Question about 2011 Honda CB1000R

Open Question

Starter prolems with cb1000r

Start up all right put it turn over a lot before it starts but run ok is this how they start just got bike

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 3 Answers

SOURCE: 05 honda vtx 1800 runs rough

Your carb idle pins/needle valves are either fouled or worn/damaged. Or floats that control your equilibrium for gas distribution throughout the carb array are not working together with valves/pins. Has this bike set a spell, at least once for too long of an interval? I'd pull the whole darn carb setup and inspect/clean, then reinstall exactly to specs. Ask for the very best teardown/rebuild cleaner for carbs at the parts store! Betcha a little elbow grease and a perfect dismantle and clean, then rebuild is all you need! Been there----Did dat!

Posted on Jan 13, 2009

  • 188 Answers

SOURCE: 2005 Honda crf450x cold starting

doulbe check the grounds, & you might need to add and extra ground wire to the bike, closer to the starter. This should help. There is a valve that release the compression when you kick it off.You might see if you can pull this release the compression valve while pushing the start button????

Posted on Feb 11, 2009

polarcycle
  • 1392 Answers

SOURCE: my honda vt1100 c2 starting problem

If you can hear the starter run, but no motor turning, the starter clutch is going bad. It is what allows the motor to turn over with the starter, and it idles while the bike is running.

Posted on Jun 09, 2009

  • 921 Answers

SOURCE: replaced right engine cover cb1000r no ignition

can you bump start it?

Posted on Sep 13, 2009

  • 330 Answers

SOURCE: starter clicking noise, bike won't start

start relay should be checked, if cables are loose or corroded they do not deliver enough power.if jumping the start relay will engage the starter replace the relay.

Posted on Apr 30, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

XV1100 Starter does not engage when trinig to start engin


sorry didn't actually see the post before my first comment, if it is only when the bike is warm or hot but not over heated I would suspect the same thing, faulty starter. "replace or rebuild"

Jul 12, 2013 | Motorcycles

1 Answer

1996 suzuki katana 600, the bike was running, i shut it off, put on the body parts and tried to start it again and the starter sound like it just spins but doesn't turn the motor over. sounds like when a...


ok bud souunds like your starter solinoid went out either or you piched awire . while putting on body parts retrace what you took off looking closely at starter wirering so it looks rite make sure all connections are tight nproper . try n start with pnels off if still pull off starter n solinoid have m check at local bike shop .things ware out at strangest times so toomake us crazy some times good luck bud.

Apr 03, 2011 | 1993 Suzuki GSX 600 F (Katana)

2 Answers

I own a 2003 laverda 750S. I battle to get it started, the starter battles to turn the motor!!


how good is the battery check terminals are clean leads and all conections are good try remote battery and jump start it like a car if the problem goes away its your battery if not its the starter or solinoid or leads

Jun 23, 2010 | 1971 Laverda 750 S

1 Answer

New bike 2008 k1200 gt starting problem when hot


if the clutch burned out it must have been slipping causing lots of heat inside were the starter is, all this extra heat wont do the starter any good at all, if its still under warrantee get it back as its clearly not right,, not at all like bmw?

Feb 02, 2010 | 2008 BMW K 1200 GT

2 Answers

Starting fault


There are two safety switches that you may need to test. 1) Neutral safety switch- this switch is what tells the bike that it's in neutral and allows the starter to engage. 2) Kickstand safety switch- this switch will not allow the bike to run in gear if the kickstand is down. My initial guess is the neutral safety switch. If the neutral safety switch is bad, then you will not be able to start the bike with the kickstand down because the bike thinks that it's in gear (even if in neutral). This also may explain why the initial intermitent problem of not starting when warm since the metal contacts will expand and possibly not make contact when warmed up. Are you trying to start the bike with the kickstand up or down? If it were the kickstand safety switch, the bike would probably start okay and then die when you put it in gear.

Oct 10, 2009 | 1995 kawasaki ZZR 1100

1 Answer

Harley davidson evo motor wont turn over...just clicks


Pull the spark plugs out and hit the starter. This will make sure that the engine is not locked up. If the starter does not turn the engine, put the bike in first gear and have someone push you, making sure the engine is free. If the engine is OK, your starter is probably jammed and needs replaced. That wire getting hot is a dead giveaway something is locked up tight...starter or engine. If ya have a large hi-performance engine in the bike, chances are your stock starter won't do the job.

Jun 16, 2009 | Harley Davidson Harley-Davidson Motorcycle...

1 Answer

My honda vt1100 c2 starting problem


If you can hear the starter run, but no motor turning, the starter clutch is going bad. It is what allows the motor to turn over with the starter, and it idles while the bike is running.

Jun 09, 2009 | 1996 Honda VT 1100 C2 Shadow Sabre

1 Answer

1999 sporster 1200 starting prolem


sounds like starter is pullin' alot of juice away from the ignition..this can also happen if your battery is less than optimal...to test this try jumpstarting with donor vehicles engine NOT running...if she fires right up then try charging your battery fully and if still won't handle it, time for a new battery...good luck to you friend...Tim

Jun 04, 2009 | 2000 Harley Davidson XL 1200 C Sportster...

2 Answers

Electric start on 640 pulls dead


put bike into 2nd gear while on the bike and push backwards until the bike goes no further.put back into nuetrual.should start easier.works on my 640 when its slow to start

Mar 29, 2009 | 2002 KTM 640 LC4

Not finding what you are looking for?
2011 Honda CB1000R Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75117 Answers

Gino Cussen
Gino Cussen

Level 2 Expert

216 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...