Question about 2005 Suzuki Boulevard C90T

1 Answer

No power when ignition is turned on, all fuses ok, battery fully charged.

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

Sounds like it might be your rectifier. Happened to me. Replaced the rectifier and the battery nad the problem went away. The bad rectifier WILL eventually quite working. Try hooking up jumper cables to the bike to see if it gets power. If it does, and your battery and fuses are fine, I would suggest you have your rectifier checked and replaced. Good luck!

Posted on Sep 05, 2013


4 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 56 Answers

SOURCE: Burgman AN 250 sccoter - battery fully charged, but no power

Have you checked the fuse box yet?

Posted on Jan 29, 2009

  • 212 Answers

SOURCE: my 2000 suzuki AN400 won't start

check with ignition coil......

Posted on Jul 03, 2009

  • 8404 Answers

SOURCE: put in ignition key turn on no power at all,

Run switch on or off?

Posted on Mar 17, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2002 Suzuki Intruder 1500LC has no power, main and regular fuses are ok

When it shuts off while driving, a vacuum in the gas tank can built up when the gas cap is restricting ventilation.
The power regulator may be at fault as well. Have you checked the ignition coil for power? Is it going to the spark plugs?

Jun 23, 2015 | 2002 Suzuki VL 1500 Intruder LC

1 Answer

Electrical prob

batteries can be fully charged but fail under load conditions. have a load test done to eliminate the battery as a problem. Check for fusible link near battery and ING fuse near battery

Jan 10, 2015 | 2007 Kia Picanto 1.1

1 Answer

2005 mustang manual will not turn over has full

have you checked power to the starter motor, if no power check the control fuse , usually placed close to the battery fuse box , it will be around a 100 amps so should be easy to spot, if this is ok then will need to check if the ignition switch is sending power to the starter , if have power to the starter i would assume the starter is at fault.It could also be the start switch at the clutch point of starting if the rest checks out so getting the OBD codes read could point you to the component at issue , is there any sort of clicking noise or is it completely noiseless? if it is clicking then the battery may not have enough amps for turning the engine but enough to appear fully charged so get the battery condition checked for holding charge etc , hope some of this helps keep me posted if you wish and good luck

Sep 27, 2014 | Cars & Trucks

1 Answer

Replaced failed starter with new one on my 1977 porche 924, turn key and nothing. I have a fully charged battery.

check power and ground cables for fit and corrosion. If ok check starter switch wire(the little one) for voltage when key is turned,if none is ignition fuse/switch problem.

Mar 02, 2011 | 1987 Porsche 924

2 Answers

I have a weird symbol showing on the dash for my 1985 blazer that I don't know what it means. I am having a problem starting it without a jump and then it doesn't want to stay charged. New battery, plugs,...

ok get power to truck turn key to on position pull plug off altenater one of then should be hot its call an exciter wire to excit the altenater to starg charging but first before all that check the alt. fuse inside your truck

Dec 15, 2010 | 1985 Chevrolet S-10 Blazer

1 Answer

Starting problems

With a voltmeter or test light can you check for power at the fuse block? There should be power to some of the fuses like ignition or radio, cigarette lighter. If not then check directly at battery. Some cars have fusible links between the battery and all loads, I don't know yours.

Apr 01, 2010 | 2001 GMC Sonoma Extended Cab

2 Answers

94 z wont start

You will have to check, at the starter, for power to the SMALL wire on the starter solenoid (which is on the starter) when turning the ignition switch to start.
If there is power to this wire ( usually purple ) and power at the LARGE cable ( from the battery ) at the starter need a starter.

If you do not have power at the small wire at the solenoid with the key in start position and battery power is OK.....check the safety neutral switch.Moving the shifter around a little can sometimes allow the car to start if the neutral switch is worn.

A new battery does not always mean a fully charged battery.
Try a boost from another car before testing the starter for power.

The battery cables need to be clean and tight....and check the ground to the engine as well.

Everything else may work OK with bad connections,they don't use the power the starter needs to turn the engine over.

Sep 08, 2009 | 1994 Chevrolet Camaro

3 Answers

Battery is fully charged but it still wont power up no lights when plugged in to charge

Hook up only the ac adapter to the DS to see if it turns on. If it does then we know the ac adapter works. We know the battery got fully charged but the system isn't turning on with the battery that is fully charged up.

I would say your battery is defective but you won't really know until you fully charge up a known good working battery and test it out.

Jun 29, 2009 | Nintendo DS Lite Console

1 Answer

Turn on key no ignition lights .Battery fully charged, all fuses under the dash ok. Where is main ignition fuse?

I would replace the electrical switch the key turns, they are notourious for this problem, they come apart and loose connections. see photo

STANDARD MOTOR PRODUCTS Part # US212 {IGNITION SWITCH) Price $86.00 Source (best price around!)

Mar 26, 2009 | 1984 Mazda 626

Not finding what you are looking for?
2005 Suzuki Boulevard C90T Logo

Related Topics:

220 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts


Level 3 Expert

78267 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4736 Answers


Level 2 Expert

83 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides