Question about Motorcycles

Open Question

Stator wiring color code yamaha warrior 350 - Motorcycles

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

fastboyz
  • 674 Answers

SOURCE: QUAD QUESTION! 1998 yamaha warrior 350 bogging down

sounds like fuel starvation
do you have a petcock plugging or a dirty carb?
pull the fuel line and check flow
later paul9477792.gif0e30a9b.gif

Posted on Nov 17, 2008

bennito10
  • 51 Answers

SOURCE: 2001 yamaha warrior valve adjustment

hello
with the cylinder set at top dead center compression. using a feeler gauge between the tappets and the valves there should be .002-.003in clearance on the intake valves, and .006-.007in. clearance on the exhaust valves. thank you.

Posted on Mar 24, 2009

  • 89 Answers

SOURCE: How do I adjust the valves on my 2003 Yamaha Warrior YFM 350X?

first you need to remove everything that covers your valve covers(gas tank etc.) remove the intake valve cover,and the rotor nut and timing plug.set the engine a t.d.c.(top dead center)fit a socket onto the rotor nut and turn it counterclockwise until the"I" mark appears align it with the index mark in the timing hole.use a flat feeler gauge between the top of the valve and the adjuster.loosen the locknut and turn the adjuster just until you feel resistance on the feeler guage.hold the adjuster and tighten the lock nut down.i can not tell you the min.clearance spec to your quad since i have a 660 raptor.try using the smallest clearance number.

Posted on Apr 25, 2009

  • 1 Answer

SOURCE: my yamaha warrior 350 has gas and spark but wont start.

check your timing as described if it checks out ok. you might want to check the intake valves and exhaust valves. intake 4 and exhaust 6
could have a bent valve.

Posted on May 06, 2009

  • 29 Answers

SOURCE: Yamaha warrior chain.

HELLO; Heres all you should have to do this,set your quad up on a atv jack or on a milk cartoon.Loosen the four bolts that hold the rear bearing carrior and back off your adjusters then push the carrier forward till it stops,relay your chain and adjust it leaveing a little slack, tighten your mounting bolts then, something I do, spin the rear tires to see if the slack is right if not loosen the bolts and proceed again with the proceedure turning out the adjusters a little more look at the chain as you dothis and you will see the slack in the chain on the top. GOOD LUCK.

Posted on Oct 01, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Color wire diagram for a Yamaha trail warrior motorcycle


Hi, Michael sorry you can't find the first and best tool you ever bought for your Yamaha despair not for a mere $0 you can download another one. For more information about your issue and free downloads that you will need please visit the websites below. Good luck and have a nice day.
Wiring Diagram
Yamaha YFM350XP Warrior ATV and Color Code Wiring Diagram Automotive...
http://www.yamaha-motor.com/assets/service/manuals/2003/lit-11626-16-08_227.pdf
https://www.tradebit.com/filedetail.php/5621482-yamaha-warrior-yfm-350-yfm350x-service-repair-manual

Jan 22, 2016 | Yamaha Motorcycles

1 Answer

How do I test the stator coil on a yamaha warrior 350 electric start


hi .. go straight to here .. youtube link. http://www.youtube.com/results?search_query=yamaha+350+warrior+stator+test
yamaha 350 warrior stator test YouTube

Jul 20, 2014 | Motorcycles

1 Answer

No spark on 350 warrior


Go to the on/off switch and see if it's shorting out. Also check the ignition.

Jan 13, 2014 | Yamaha Genuine Yfm 350 Yfm 600 Yfm660...

1 Answer

1997 yamaha warrior 350 will not fire


did you check the timing, piston, or put your thumb over the spark plug hole to feel for compression?

Apr 10, 2013 | Motorcycles

1 Answer

Yamaha warrior 350 won't turn over


Hi, Anonymous and the usual suspects are:
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Discharged battery, needs to be 12.5 volts or better and be able to pass a load test if necessary.
4. Check the battery terminals for damage or corrosion check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
5. Tip over sensor needs a reset.
6. Faulty ignition switch.
7. Faulty starter button.
8. Faulty kickstand or clutch pull in switch/sensor.
9. Starter control circuit, relay, or solenoid faulty.
10. Main fuse or circuit breaker may be blown or faulty.
11. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have nice a day.
warrior 350 trouble starting turning over
ATV Connection
Yamaha YFM350X Warrior Service Manual
OEM parts for Yamaha
Yamaha WARRIOR YFM350X Owner Manual

Apr 07, 2013 | 2006 Yamaha Warrior Base

1 Answer

Need wiring diagram for a 1996 yamaha warrior 350


you might find a service manual at the bluetraxx forums

Mar 28, 2013 | RTO 200cc Full Size Four Wheeler ATV

2 Answers

Hi i have a 1997 yamaha 350 warrior i have no spark to the spark plug what could be


hello, you probably need to have your stator checked out, sometimes the pickup coil in the stator will go out, also you can try ign coil, the one spark plug wire is hooked to,warriors are bad about cdi going out, mine would idle, would not rev up, would bog down, source coil in stator probably needs to be checked also..

Feb 27, 2010 | 1974 Yamaha DT 360

1 Answer

Yamaha xt 125r wont start up


hello, check and see if plug is firing a blue color, if not you may need a stator-pickup coil, i have a 2000 warrior, it is firing, orange and white color, stator neede to be replaced, pickup coil was going out, also check ign coil, these have a problem with getting weak after a while. most likely it is your stator pickup coil, no blue fire from plug, no running the motor. my stator pickup coil was going out. no blue fire from plug, i was told by a yamaha mechanic, no blue fire from plug it will not run, has to be blue, not orange or white looking fire.make sure carb is clean and all jets inside are clean, and air passage ways

Feb 22, 2010 | 2005 Yamaha XT 125 R

3 Answers

Yamaha warrior won't start


If you are getting a nice bright blue spark then no, the last time I had a problem like this it was sugar in my tank. If you taste a bit off your finger and it is the slightest bit sweet, then some one has sugared your tank. If so just flush the tank with a little fresh fuel and then flush the carb, and fuel lines by spinning the engine over for a bit then try to start again.
Is yours an electronic ignition or points. If points gap could be wrong or even timing slipped. That has happened to me also.

Apr 29, 2009 | 2003 Yamaha YZ 125

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

72 people viewed this question

Ask a Question

Usually answered in minutes!

Top Motorcycles Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

74945 Answers

kakima

Level 3 Expert

102366 Answers

Are you a Motorcycle Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...