2005 Ford F-150 Logo
Samuel L. Valencia Posted on Dec 24, 2012
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

Dash lights all turn on then off after several minutes, at times a bell starts sounding for a few minutes, then the radio turns off for a few seconds, truck has not stalled.

1 Answer

eric allen

Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

  • Ford Master 660 Answers
  • Posted on Dec 24, 2012
eric allen
Ford Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Joined: Dec 06, 2012
Answers
660
Questions
1
Helped
209650
Points
2064

Sounds like a loose connection or a hot wire grounding out.
Do you get and check engine lights?

5 Related Answers

Anonymous

  • 674 Answers
  • Posted on Aug 23, 2008

SOURCE: 2002ford truck explorer when i

it sounds to me that you idle controll valve isnt responding (could be dirty) get a can of carb cleaner and clean the thottle body inside and with the engine running. squirt just a little and the engine will start to stall and the idle air controll will start to open ( you will hear it start sucking) then spray more in sperts try to keep the engine running at idle . this will make the engine RPM's change and open and close the idle controll valve thus cleaning it. when done save some carb spray. put the air cleaner hose back on. and start the engine and with the engine idling spray around the intake and base of throttle body if the rpms change you have a vaccume leak than will need to be repaired.
good luck
tech rating 3

Ad

Anonymous

  • 3 Answers
  • Posted on Jan 06, 2009

SOURCE: 7.3 litre torbo diesel won't start

did you check the glow plug relay right on top of the engine?

Anonymous

  • 11 Answers
  • Posted on Jun 16, 2009

SOURCE: 05 ford escape wont start. jump started it and it

okay try this....talk to your parts store and get a battery load tester, and find out if the battery is indeed dead. My guess is it sounds like the Altenator is dying. they are around 50-100 and can be install by a pro in minutes.

Anonymous

  • 3 Answers
  • Posted on Feb 15, 2010

SOURCE: glow plug system will not cycle

Do you have dual fuel tanks? Place the return fuel line from the back of the fuel pump in a bucket and see if it will start. If yes replace the fuel tank switching valve. It may switch supply side ok, but not return side and if so it is plugging the return, which will cause a no start stuation. If it starts running the return line into a bucket replace the switching valve.

David Floyd
[email protected]

Anonymous

  • 131 Answers
  • Posted on Feb 24, 2010

SOURCE: 2004 Ford F150 will not start but making a ''clicking'' noise

start with a battery sounds weak and its probley never been changed also make sure the cables are tight and clean

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Radio pops shuts off, lights dim up and down, bells ring, several lights on dash off and on, I pulled blinker to turn on bright lights and the car immediately down shifted.

Sounds like a charging system failure. Check battery and voltage while it is running. Should be 13 to 14.5 volts.

If you need further help, reach me via phone at https://www.6ya.com/expert/chris_b82b45c59bcf133d

0helpful
1answer

06 Colbalt Electrical System Dead

I would go to the positive terminal on the battery anjd check for black hard build up on the post and inside the terminal. This is lead sulphate and cause a high resistance to any high current flow. Clean both with sand paper until shiny and refit and tension properly. Do the negative also as it will have build up but to a lesser degree. If the battery lead runs through a connection box Check for tight connections there also. As to towing most towers have a wheel rack that fits under the tyres and lifts them clear of the road so it can be taken to to a shop.
0helpful
1answer

My 1993 nissan sentra 1.6 wont run and check engine light wont turn on,bulb is ok

Could be any of several things. If the crank sensor is marginal and not sending pulses, the fuel pump is shut off. This is for safety. The pump is energized for a few seconds as key is turned in preparation for starting then engine must rotate normally to keep the pump on. If it stops, in a few seconds the fuel is cut off.
0helpful
1answer

Ignition does not engage

lock all doors and trunk then use key fob to lock all doors and set alarm ,then wait few minutes and unlock vehicle and try to start
0helpful
1answer

I have a 2005 Taurus SE. For the last few months now on a cold start, I must turn the key on but not thru to start until the bells and buzzers quit, then turn it to start; other wise it will just crank...

this is just a sugestion and in no way meant to answer your problem, but this sounds suspiciously like the the problems that used to occur with the neutral saftey switches on the older taurus.
1helpful
1answer

I have aztek 2001, and anti-lock light on the dash is constantly on. We changed engine oil last week but it still ask for changing oil,and alarm/bell is turning on every time when we turning left or right,...

The most common cause for the abs light to come on is a bad wheel speed sensor.The oil light was probably not reset afte the oil was change. Try turning the key and pumping the gas pedal 3 times with in 5 seconds.The light should start flashing or it may have to be reset through the radio.As for the alarm would it be possible to elaborate on that?Is it the same sound as leaving your key in the ignition or not fastening your safety belt?
1helpful
1answer

At times when i turn the key it will not start. The lights, radio and dash works but nothing else. after several minutes of trying it eventually starts

do you hear clicking when trying to start? sounds like your starter is goin bad. have your local parts store test it out
1helpful
2answers

My 1997 Jimmy wont start when dash info lights are not on

Try replacing the ignition wiring harness in the steering column. These wires control I think everything electrical. I did and it fixed my problems.
0helpful
1answer

No Start No Crank

I am guessing here but I would check the installation of your new cylinder and the fusebox. It sounds like the key is turning to the running/accessory position but not switching all of the accesories on. The tumbler can get loose inside the steering column and not engage the start switch.
Background... I had the same problem with 1st generation Dakota. The old key tumbler had to be turned much further than normal to engage the ignition. I paid "5 star" Dodge service to replace the unit and now it works as long as you turn the key back to "running" position after it starts. After the Dodge dealer told me that my truck was too old for them to be familiar they offered to dig around for MORE MONEY. Your problem reminds me that they said something inside the column wears out and they may not be able to fix. I was not impressed, but it reminds me to ask a mechanic if he intends to finish the job for which I am paying him. Mechanics aren't happy about this but it saves me money.
Not finding what you are looking for?

60 views

Ask a Question

Usually answered in minutes!

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...