Question about 1995 Yamaha FZR 600

4 Answers

What is this relay for?

What does the 3en-81950-00 relay do? What is it responsible for? I can't find a diagram online showing all that is tied to it. Any ideas?

Posted by on

Ad

4 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 6,966 Answers

Hi and welcome to FixYa,

If I remember right, an 3EN-81950-00 multi-function relay onboard an FZR would be on the right side, beside or behind the starter relay. Its function is an electro-mechanical processor. It detects if the transmission is in neutral, side stand is down, clutch is in. In turn it enables the CDI to work and the starter relay to trigger the starter motor. Internally it would have 2 relays and a couple of diodes.

Pls post back result(s). Good luck and Thank you for using FixYa.

Posted on Jan 16, 2009

Ad
  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 3 Answers

 3EN-81950-00 Relay Assembly

Benimur is correct. This is often reffered to as the master relay or the relay assembly and it has about 4 different circuits in it which include a couple diodes and a couple relays. More information about this relay and the entire electrical system of a Yamaha FZR can be found at http://www.fzrarchives.com/online_manuals.html this site has been around forever over 6 years since I've had my fizzer and they never let me down with all the info I need.
In particular if you D/L the manual for the 600 CC you can use section 8 and you will see all the information you need to troubleshoot this relay and test it. You must check continuity and resistance across a couple of different sets of pins to properly test all the included circuits in the module. The reference values to check all of the circuits in this module are in all 3 of the section 8 files that are provided in the manuals that are linked above. There are a couple circuits on the lighting system check for this relay module in file 1 and 3 and the testing of the ignition cut off relay and diode inside this module can be found in file 2. Hope this helps took a lil bit to find the specs I needed but this info got me through the test I needed to diagnoss this relay to be an issue that I was having with my Ingnition System on my 96' FZR lucky for us most years 89-99 are the same so this manual will work for most people.. they even have a manual for the 400 CC on there too I think.

Posted on May 03, 2009

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Expert
  • 100 Answers

Hi, its a fuel pump, neutral and sidestand relay

Posted on Jun 21, 2013

  • jon black Jun 21, 2013

    yes, if the sidestand is down, putting it in gear will kill the engine.. stops you riding off with the stand down.

×

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I have a question would this cause the release of the clutch to kill it on take off idols fine act like its always in gear even in nuetral..

Posted on Nov 04, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ho do I tie a tie


Go online and ask that question and you can get diagrams as to which style you favour.

Mar 30, 2015 | Cars & Trucks

1 Answer

Chevrolet diagrams


Mary, 2003 Chevrolet Silverado 2500HD suspension and steering diagrams. Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
2003 Chevrolet Silverado 2500 Parts GM Parts Department Buy genuine GM...
2003 Chevrolet Silverado 2500 HD Parts GM Parts Online GM Parts Direct
Chevrolet Silverado 2500 HD Ball Joints eBay
How To Install Replace Inner Tie Rod Chevy Silverado GMC Sierra 99 06...

Aug 02, 2014 | 2003 Chevrolet Silverado 2500HD

1 Answer

How can you tell if relays in fuse panel are good


They can be tested if pulled out. Know how a relay works? Relays have a power side and a coil side. When the coil side is energized from voltage applied to it, the electrical contacts on the power side close allowing power to pass through the relay from the power feed supply on to the part the relay controls.

To test one, you use jumper wires from the battery to the coil side. Usually will hear a click-showing the power side contacts did close. The relay will have a small diagram etched into it, showing which two or more terminals are for the coil side, and which other terminals are the power side. If more than four terminals, the diagram will show how all are tied into the relay. Jumper a positive wire to the coil side input terminal, and a negative to the coil output terminal. If you have a multi meter, check that the power side terminals show continuity when coil side is jumped. It should have continuity-relay is good. If no multi meter, but you can hear or feel a click when testing-probably good.
That's the only way to test relays. Another solution if you suspect a bad relay is to swap in a known good relay. When the relay is pulled out, a good idea to check if the power feed for the relay is present. Use a test light grounded to a screw or metal bracket, and probe all the terminals that relay plugs in to. One terminal should have power lighting the test light, verifying power feed is good. Most, if not all relays, have a power source that is hot at all times, but if you find no power on any terminal, turn the key to on and check again-that relay may only have power available when key is in on or run.
Good luck.

Sep 24, 2013 | 2000 Buick LeSabre

1 Answer

No power to the fuel pump


Obvious answer is there is a break from the relay and pump cable. Run a single cable from the relay to the pump independantly to confirm this. It happened to me on a Rover 75, easy and cheap to fix when you find the cable responsible just terminate the original and tie to the loom using cable ties.

Dec 26, 2009 | 1993 Nissan Altima

2 Answers

Where's the turn signal relay?


It's under the steering colum. Pull the plate off under the steering wheel and the relay is connected there. There are sites online that will show you a diagram

Jun 15, 2009 | 1993 Cadillac Fleetwood

1 Answer

I need a suspension diagram that shows the Inner tie rods.


The inner tie rods are screwed into ends of the steering rack assembly.

Look at this diagram. #6 is the rubber boots and #7 is the shaft from the inner tie rods.


http://www.anubiscycle.com/fixya/2000-windstar-steering-gear.jpg

Jun 08, 2009 | 2000 Ford Windstar

1 Answer

2002 Buick Rendezvous - Rear Wiper, Back Up & Rear Plate Lights


look for rear wiper fuse and relay.because both circuits is tie together . look in glove compartment for the manual .it will show where all fuses and relays located.

Mar 17, 2009 | 2002 Buick Rendezvous

1 Answer

Location of the starter


You can find it easily by just followning the positive battery cable throught the relay to the starter. Their are no free online manuals or diagrams for cars on the internet.

Jan 06, 2009 | 1997 Chrysler Concorde

Not finding what you are looking for?
1995 Yamaha FZR 600 Logo

3,952 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

dhnguyen

Level 2 Expert

281 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1144 Answers

Tony

Level 3 Expert

2600 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...