Question about 2004 Yamaha YZ 250 F

1 Answer

Ideling high once you rev the bike it idels high he gradualy decreeses to a normal idal

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 716 Answers

Check Your Throttle Cable It Must Be Hanging Up Somewhere Try Putting Some wd-40 Where It Meats Inlets

Posted on Jan 15, 2009

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My cr125 wont idel after stating can it be ajusted.

there is a little screw at the back of your carb next to your air box. kick your bike over and keep little revs on screw it clockwise (in) then start so slowly screw it anticlockwise (out) till your bike starts to rev a bit mor then release your throttle and it should tik over.

Aug 07, 2012 | 2003 Honda CR 125 R

1 Answer

My 96 1300 royal star runs good at idel and half therodel but dies down at full throdle

I thought i had a problem with my carbs. it started cuttingout when i romped on the throutle, but when i took it to a cycle specialist, they said the royal star had a Rev Limiter in it. it intentialy starts cutting out and back firing when I try to rev it too high. I\´m looking at getting the DYNA 3000 to customize the limiter. $270 bucks
Yamaha installed the limiter to lengthen the life of the bike, so this may be a long term bad idea.
I\´ll see.

Oct 04, 2010 | 1996 Yamaha Royal Star XVZ 1300 A

1 Answer

2004 klx 125l bike ideling

How long has the bike been sitting? The gas may be bad or the carb might need to be cleaned out or choke may be sticking.

Feb 06, 2010 | 2004 kawasaki KLX 125

1 Answer

02 cbr 600 f4i, red fi light flashes and bike idels high and takes a wile to go back to normal after you rev it

you have a fi fault revmove the seat cowl on the left hand sise you will see the cdi unit (black box with wires going to it) you should see a black conector with two wires going to it bridge the wires with a pice of wire or split pin turn the igntion switch on and count the blinks one long one means ten recored the the blinks and phone a dealer and ask them for the fault reset the the light pull out the bridge and the light should stay on or blink repeted turn off the switch make sure the kill switch is set to run hope this helps

Oct 29, 2009 | 2002 Honda CBR 600 F(4)i

1 Answer

1999 harley davidson fxsts that back fires

Could you adjust the throttle cable to up the revs a little, may be set too low! If not the carbs may need adjusting...

Aug 10, 2009 | Harley Davidson FXSTS Springer Softail...

2 Answers

Ideling problem and Black Smoke

cylinder needs to be machined and oversized piston installed you have blow by,also your carbs are out of sync,find another mechanic or do the work yourself this will fix the problem.

Dec 26, 2008 | 2005 Bajaj Wind 125

Not finding what you are looking for?
2004 Yamaha YZ 250 F Logo

Related Topics:

131 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts


Level 2 Expert

61 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1128 Answers

D. E. Hev

Level 3 Expert

1132 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides