Cars & Trucks Logo

Related Topics:

Anonymous Posted on Dec 12, 2012

'02 alero 5 spd wont engage gear

Can move shift lever in and out of all gears without clutch. there were no noises. I had the car in N tried to put it in 1st gear to drive and it wont engage. while checking the car out after I noticed the transmission plug was loose, and there was little to no fluid in the transmission. also there was trans fluid sprayed everywhere.. Nothing smells burned.. Could this be the transmission wire binding?? HELP PLEASE!!

1 Answer

Stephen

Level 3:

An expert who has achieved level 3 by getting 1000 points

Top Expert:

An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

  • Oldsmobile Master 21,873 Answers
  • Posted on Dec 12, 2012
 Stephen
Oldsmobile Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Top Expert:

An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

Joined: Jun 22, 2012
Answers
21873
Questions
0
Helped
6201191
Points
67230

My first question is - have you had the trans filled with fluid ?
If the fluid level is now normal, and you can't shift the gears, you may have damaged the main shaft inside the trans.

5 Related Answers

Anonymous

  • 372 Answers
  • Posted on Aug 29, 2008

SOURCE: 1999 Olsmobile Alero

sounds like bad clutches in trans...tranny shop needed...takes 4 qts for a filter change and remember to check it when the vehicle is warm and in park running.

Ad

Anonymous

  • 25 Answers
  • Posted on Dec 27, 2008

SOURCE: Cannot engage transmission from first to second gear

Hi,
maybe has a broken linkage or the bolt came lose.
Check if you can engage hall the gears pushing the linkage by hand,engine ranning and same one pressing the clutch!that way you can have same idea wath is wrong?!

Anonymous

  • 3 Answers
  • Posted on Jan 16, 2009

SOURCE: 2000 daewoo nubira shift lever moves but gears do not engage

Is this FWD? Maybe check the shift cable.

Anonymous

  • 2 Answers
  • Posted on May 27, 2009

SOURCE: automatic transmission wont catch into any gear

You sould have been moore frequent on your transmission fluid changes, and you shouldn't have taken it to Jiffy Lube either. Your best bet is to drain and fill the trans fluid run it shift gears. Drain and fill again. Do this 3 times. Yeah the transmission fluid is expensive. on the last drain and fill you want to get a bottle of LUBE GUARD from NAPA or who ever sells it. put the whole 10oz bottle in. Shift Rev, 1, 2, 3, D. Neutral Rev D. If that don't work then you have bad seals.

Anonymous

  • 57 Answers
  • Posted on Aug 26, 2009

SOURCE: 06 ford focus 5spd. no 1st, 3rd, or 5th gear.

It sound like the gear linkage isn,t set up right, you wouldn,t always be able to engage a gear unless you rocked the car.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Gears seem to want to slip out and make a winning noise in certain gears too is my gearbox done for or is it more likely clutch it's Audi a3 with 130000 on the clock and clutch is very high too any...

gears slipping out will be indicated by the gear lever jumping into neutral.This can be from incorrect rear engagement from a loose worn pivot in the gear lever tower or something stopping the gear lever from moving properly.. Clutch problems are indicated by --going to the floor. crashing 1st gear, engines rpm s climbing without an appreciable vehicle speed increase. If there is a fault in the gear box it will be only in the gear engaged (missing teeth-chipped ) and not all gears. If it is a bearing then there will be no noise in 4th gear
Boxes are repairable as mostly it only needs that faulty part to be replaced
0helpful
1answer

1995 celica 2.2L doesn't engage gear 2,4,r

are you saying this car is a A/T car, AUTO and not a stick?

say so, as both have 2,4 and reverse gears.

i think its a 5speed manual.

so the tip of the shifter is bad, remove it see plastic parts bad.

you could shift car , by moving the transmission levers and id bet it does work so that leaves. bad shift lever parts.

i bet the lever is real loose , so loose the H pattern is garbage
right> ?
1helpful
1answer

My 1998 Honda civic ex won't move but the motor

Have you just replaced the clutch? Taken out the transaxle, and put it back in? Are you sure transmission was in good condition before this? If so, review your procedure carefully to be sure you got it all back right.
Watch the slave cylinder while someone depresses clutch. You should see the little plunger move slightly out and move the clutch lever back. The lever moves the release bearing inside bell housing into contact with the pressure plate. If slave cylinder doesn't move at all, try bleeding again. The plunger has to move when clutch is engaged.
I'm not sure what you mean by "will shift but won't go into gear". You mean it's actually going into a gear position and car won't move? Or it won't go into any gear, period. As if you had no clutch?
1helpful
1answer

06 ford focus 5spd. no 1st, 3rd, or 5th gear.

It sound like the gear linkage isn,t set up right, you wouldn,t always be able to engage a gear unless you rocked the car.
1helpful
1answer

Difficulty shifting 2000 Ford Explorer 5 spd. manual transmission

have you checked to make sure your clutch fluid is topped up? low hydrolic fluid can sometimes cause this.
4helpful
4answers

Car will not drive, is it clutch or cabel

my daewoo lanos wont shift into gear/s while running even when clutch is depressed all the way
0helpful
2answers

1996 Geo Metro Clutch won't disengage

Hi,

In all likelihood two (2) possibilities:
  • defective clutch cable (most likely); and/or
  • defective clutch fork (least likely).
Should it be the cable, this might be of help. It is turns out to be the fork, you might need the services of a qualified professional or a dealership.

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information. Good luck and kind regards. Thank you for using FixYa.
1helpful
2answers

1988 suzuki samurai WONT MOVE

First thing just try to push or pull the 4x4 lever if you get it to move and it feels like it went into some gear try to drive the truck.If this works look on the shifter for the 4x4 and put it in 2 wheel drive (H2 is two wheel drive,H4 is 4x4 high,and L4 is 4x4 low range).Make sure you have the clutch depresed when you try to move the 4x4 lever.If you try this stuff with no fix try and look for clutch adjustment on the transmision you may need to adjust it or your clutch is bad.
Not finding what you are looking for?

154 views

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...