Question about 1991 Suzuki VS 1400 Intruder
Posted by Anonymous on
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
One the left-hand side of the bike (facing forward), there is cover plate just ahead of the drive shaft. Remove that cover (mine has 8mm bolts). The bleeder valve is under this cover. Go to an auto parts store and get a "one man bleeder kit" or if you have some plastic tubing that will fit over the valve, you can use that and a clean jar. Follow the instructions on the bleeder kit, or if you're using the jar and tubing, fill the jar about a quarter of the way with break fluid (use DOT4, but never DOT5!). Take the cover off the master cylinder up at the handlebars, place the tube over the end of the bleed valve (after loosening it a turn or two. Place the other end of the tube down in the break fluid in the jar. Work the clutch lever until you stop getting bubbles in the jar. Be sure to keep the fluid level up in the reservoir. Tighten the bleeder valve, remove the tubing, top off the fluid and replace the covers.
Be careful not to get brake fluid on anything. It will eat paint and mess up other things.
Posted on Feb 13, 2009
the manual probably wont give you those details,go onto www. bikebandit.com type in your make and model,this will bring up a full parts schematic with part numbers etc,if not just simply get them off your local dealer,they are normally quite helpfull if they think they are going to get a sale..hope this helps
Posted on Jul 10, 2009
Did you sync the two carbs? If not the rear may be getting all the gas from the rear carb and none to the front. Twist throttle engine off and see if front carb cable is pulling the carb open.
Also unscrew the spark plug boot from the front spark plug wire and trim 1/8th inch off the wire and screw the boot back in. The plug wire end may be corroded on that wire.
Posted on Feb 08, 2010
i have a 2002 volusia intruder 800cc and the bike was runnning fine. i change the oil/oil filter/removed the radiator hose and drain the radiator/ replace spark plugs and when it was time to start the bike it started and then stalled out/ can't keep the bike running. check the fuel filter and it appears to be o.k. don't know whether or not i should change the fuel pump???
Posted on Apr 06, 2010
Tips for a great answer:
Feb 21, 2018 | 1995 Suzuki VS 1400 Intruder
Jul 01, 2017 | 2003 Suzuki VS 1400 Intruder
Mar 19, 2017 | Suzuki VS 1400 Intruder Motorcycles
May 08, 2016 | Suzuki Motorcycles
Jul 02, 2014 | 1994 Suzuki VS 1400 Intruder
May 26, 2010 | 1994 Suzuki VS 1400 Intruder
Mar 05, 2010 | 1994 Suzuki VS 1400 Intruder
Sep 20, 2009 | 1994 Suzuki VS 1400 Intruder
119 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: