Question about Suzuki AN 400 Burgman Motorcycles
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
I had the same problem until I found out that when you put the Burgman on it's center stand, it pushes a small round metal pin (spring loaded or something similar) that limits the Burgman to 1st gear only. Some kind of safety feature, I guess. You can see the little switch if you put the bike on it's side-stand, get down on the right hand of the bike and look where the centre stand meets with the body of the bike. My switch was stuck in permanent "on" so I just pulled the pin to it's full extention with a pair of pliars, then cut it with a junior hacksaw.
Posted on Jun 03, 2009
service your carb and fit a new air filter.
You might have a blocked start jet for the starting and possibly float level issues etc.for your mpg.
Posted on Aug 02, 2009
patience is required. you do not need to take any tupperwear off unless you have particularly large hands.
anyway. turn the wheel the opposite direction of the side lamp you wish to replace.
reach carefully up into the lamp area and you will feel the wireing for the lamp,,,,pull it out . then there is a rubber booty around the light bulb connector...take it off.
now comes the tricky part....the bulb is held in with a small wire clamp. if you look inside the head light lense you will see the part that is holding the lamp. with your fingers , pull it down and it will swing out of the way..be carefull not to take it off as it is held in place. you will notice the bulb then will be free, so take it out carefully....
when replacing your bulb, do not touch the lense and slip it back into place. look at the other bulb to see it fits correctly.
the next tricky part is to get the clamp back on by pressing it down and around the lip of the light bulb into place.
replace the rubber booty...then connect the wires...
Posted on Jan 28, 2010
There is a hmm Do not remember the english term, say thing down at the front wheel, sensor, That was the malfunction on mine. Second time t was the cable to the same sensor
Posted on Apr 15, 2010
Tips for a great answer:
Jan 15, 2017 | Suzuki Motorcycles
May 08, 2016 | Suzuki Motorcycles
May 29, 2010 | 2001 Suzuki Burgman 250
Apr 19, 2010 | 2001 Suzuki Burgman 250
Oct 09, 2009 | 2001 Suzuki Burgman 250
Aug 02, 2009 | 2001 Suzuki Burgman 250
Apr 15, 2009 | 2001 Suzuki Burgman 250
Jan 08, 2009 | 2001 Suzuki Burgman 250
Jun 07, 2015 | Suzuki VL 125 Intruder LC Motorcycles
66 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: