Question about 2005 Honda Activa

1 Answer

I hv activa for 2006 model,my daily travel is almost 50 kms perday - 6days in a week, from last 6 months Activa started giving starting problem and last week white smoke started coming out while drivi

One mechanic suggested to do some work in Engine,costing 4 K

Posted by on

  • Anonymous Mar 13, 2014

    its a 2013 model activa and run aroung 5000 kms

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Honda Master
  • 8,404 Answers

White smoke is classic head gasket problems in water cooled engines ... Your engine is air cooled but you can still have top end troubles. I suggest you have your motorcycle checked by a professional before you ride much more. info on your ride here: http://www.honda2wheelersindia.com/activa/specifications.html

Posted on Dec 04, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad
caroldon
  • 17130 Answers

SOURCE: my honda activa doesn't start

First of all it is for sure that water had seeped into your electricals. So open the covers and wipe dry the coils, the wires to the plug, the wires to the ignition unit. make sure that there is no water in your fuel.remove the plug with the plug spanner supplied.Kick or use the starter to check for the spark on the plug ( which was also cleaned). If no spark then check again on the ignition system, the coils the contacts to confirm the fault. After a good spark is seen fit it back again and start. It must start for sure.Other wise repeat the process. I hope you get this right. Good day

Posted on Aug 04, 2010

  • 8909 Answers

SOURCE: i have honda activa 2005

If you replace the silencer, you will restore the back pressure that is essential for 2 stroke engines to start and run smoothly.
Check out ebay

Posted on Jan 09, 2011

  • 1 Answer

SOURCE: honda activa machin oil and gear box oil leakage

immidiately sale it, 

Posted on Jun 02, 2009

  • 8909 Answers

SOURCE: I have H.Activa 2005 model.After getting it

The piston must be at Top Dead Centre to adjust the valve tappet clearances. This will only stop it from ticking. Have you checked the type of and amount of oil in the engine?
Hope that helps.

Posted on Dec 27, 2010

  • 1 Answer

SOURCE: my honda activa 2004 scooter is not at all

Only two things prevent an engine from starting/running. Always go to "Basics": Spark & Fuel (fuel/air mix). That's it. 1) Remove spark plug. 2) Put the plug back in in the "Spark Cable" just as it is IN the Engine. 3) Scrape a small area clean (down to bare metal) on the frame. 4) Hold the rubber head of the cable with rubber handled pliers (water pumps work great) using this to hold a side of the plug against the bare metal. 5) Turn the Ignition switch to ON. Crank the Engine as if starting it. Note the spark (if any). Is it Blue?=Strong Yellow?=Weak Is it Centered or way of to the side of the electrodes? If you have a good, regular, strong blue/white spark-...Fuel: 1) How old is the gas in the tank? Over 3 mos. Dump it! 2) Always replace/clean Fuel filter. 3) Same trick: Pull the fuel line off at the carb. and crank the Engine. (Careful-No Smoking!) Gas? 4) Fuel/Air mixture. If you have good Spark and good fuel...and Still does not start...Time to check parts. Good Luck

Posted on Feb 22, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

What is a cylinder compression how much do it cost to replace it


If you have low (or no) compression in one or more cylinders, it can be due to broken/bent valves or valve seats, bad or broken piston rings, or mechanical timing way off. The cost to correct is very dependent on the specific cause. Best case is mechanical timing is way off (this will show up as low/no compression in all cylinders), assuming no other mechanical damage was done. Worst case is engine rebuild or replacement.

Aug 22, 2017 | Cars & Trucks

1 Answer

What would it cost a mechanic to install motor mounts on a 1995 gmc sonoma 4.3 litre 4*4


Im sure your 95 is no different then my 01 sonoma 4x4 u shouldn't need a cherry picker to do the engine mounts a small block of wood and a floor jack to support the engine from underneath and take a little bit of the load off the mount should work you dont have to lift the engine out to do them its not easy this way but is possible and cost less money working for a gm parts department and a former tech you would be spending and average of 75 to 100 an hour labor wise depending on what shop u take it to and what shop labor rates at like near you I would estimate an easy 2 hours labor but it all goes by book time thats or determined at the shops

Mar 27, 2014 | 1995 GMC Sonoma

1 Answer

Blown head gasket


Well it would really depend on the condition of your engine.
It would take more labor to repair your engine than it would to just replace it. But unless the engine is very damaged it should be cheaper to have your engine fixed. And replacing the head gasket and having the head repaired should be under the price you were given. A head gasket set for a 4 cyl engine is around $100 wholesale.
I would call around and check with other shops next.

Jul 17, 2013 | Nissan Cars & Trucks

1 Answer

Ticking noises / Spun Bearing


If it is a light ticking noise it could be something as simple as tappits on rocker arms. valves pinging..........IF it is a ticking and not a KNOCKING noise then i would have another mechanic take a look at it...Sad thing that happens is some mechanics will give wrong suggestion for the simple fact of making your wallet lighter.... not saying this is the caes but something this costly needs more than one mechanics opinion. My suggestion would be have another mechanic look at it not telling what the first mechanics opinion was and then see how they compare..... hope this info helps and good luck....Please rate my post.

Aug 16, 2012 | 2007 Jeep Wrangler 3.8

1 Answer

1998 toyota camry shift override button continued use after switch light replacement


Just remove the mechanism (solenoid) that locks the shifter in the console. Its not cost effective to repair.

May 27, 2017 | 1998 Toyota Camry

1 Answer

I have a Ford Harley davideson pickup truck.The oil dipstick has no oil on it.Can the cpm pickup that there's no oil and wont start,also security light flashes.


Hello Corey,
I am not a motor mechanic, but from my limited knowledge....
If you cannot see oil on the end of the oil dipstick then your engine *desperately* needs more oil added.
A 5 litre / 1 gallon bottle of oil costs only a handful of dollars.
An engine that siezes cost hundreds or thousands of dollars.
If your pickup truck still starts, I suggest you take it to the nearest motor mechanic, as soon as possible.

Dec 13, 2011 | 2001 Ford F150 Styleside SuperCrew

1 Answer

I have a 1998 Nissa Maxima with 277K+ miles. I bought this car new and it has run great over the years. Recently when turnig the key to start (cold or hot)the engine starts to crank but sometimes "kicks"...


consider the cost of any work vis a vis the cost of replacing (your pet) bet it works out cheaper to recycle.......( you have to go to switzerland for euthenasia,wonder where cars go.....?)

Jun 09, 2010 | 1996 Nissan Maxima

1 Answer

2001 Mazda B2300 engine repair and compatibility


If you threw a rod,This would be a total engine rebuild.(Cost vary by location)
You can use the Ranger motor ,but you will need to swap most of the accessories from the Mazda motor so the wiring harnesses match up.


Please rate this a fixya

Feb 09, 2009 | 2007 Mazda B2300

1 Answer

Intake engine manifold qt.


Based on local labor rates (which may be different in your area), the estimate to repair your vacuum leak at your intake (also assuming the intake will have to come off the engine to fix the leak), the cost will be around $350.00. Is it a 4 cylinder or 6?

Chris

Aug 01, 2008 | 1995 Mazda 626

Not finding what you are looking for?
2005 Honda Activa Logo

419 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4731 Answers

yadayada
yadayada

Level 3 Expert

78267 Answers

bazzz7071
bazzz7071

Level 2 Expert

342 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...