Question about 2004 Honda CBR 600 RR

1 Answer

Max revs 14000 rpm.

Hi i own a cbr 600rr 04, it doesn't redline, the battery died so i jumped started it and when i flored it it didn't go past 14000 rpm.my cousin had the same problem, (same bike) they changed the fuel pump and the bike was ok but they also changed the battery. i don't think it was the fuel pump, i'm thinking it's the mapping of the ecu. thanks in advance.

Posted by on

  • pangolf2002 Jan 11, 2009

    the rev limiter doesn't come on, it's like i'm letting go of the throttle a bit. if i let of the throttle it goes up to 14500 rpm. the red line limit is about 15200 rpm, that's where it should be.

  • Dick
    Dick May 11, 2010

    What is the redline supposed to be on this engine? 16k max? You are getting close, so close it could be any physical problem like restrictions in the fuel or air system, but it could also be electrical (weak battery or alternator) or an ECU problem too. So many possibilities. I would start by evaluating how many miles are on the bike and doing any scheduled maintenance, checking your air, fuel, and electrical system components closely.

    You do know there is a rev limiter on modern sportbike engines, when you hit it the engine sounds like it's cutting out for a moment? I wonder if maybe the rev limiter is coming on too soon.


×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 137 Answers

Hey m8,,,just looked at your problem,,to start with i need to uliminate a few things first,,is the bike restricted do u no,, to 33bhp,,that sounds the problem,, the restrictors could be in the carbs,to check this take the top of the carb off pull out the spring, and needle,, on the diaphram check theres no pin holes,by holdin it up to the light,,then on the needle u may see a bit of a plastic spacer or down the inside of the carb,if so then take that out or off,,and repeat this to all 4 carbs,,if nothing is visable,,then check the spark plug caps,and ht wires on the coil,, to be sure change all the plugs if they are not the plugs that should be in the bike,,see spec in a manual,4 the right heated spark plug,, and change the plug caps,try this first m8,, if still not havin any of it, ,shout andil anserw m8,, cheers

Posted on Jan 11, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I go about fixing a reving issue on my bike? It doesnt like to rev past about 10,000 rpms. I was thinking maybe the carbs need to be rejetted. The bike will rev to redline in neutral.


Hi, Ani and the usual suspects are:
1. Severely drained or faulty battery.
2. Faulty regulator/rectifier or high output coil.
3. Faulty power valve, solenoid or installation.
4. Clogged air filter or exhaust.
5. Cracked or incorrect float level.
6. Float needle is not seating.
7. Faulty reed valve.
For more information about your question and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
02 GSXR 750 won rev past 8k
2002 750 wont rev past 8000
Wont rev past 10000 RPM
http://www.suzukigsxr.cz/docs/Suzuki_GSX-R_750_96-99.pdf

May 21, 2016 | Power Motorcycles

1 Answer

My 2005 Honda cbr 600rr won't start i was riding it when it just stopped running no power I replaced the siloniod now it lights up but when you turn the power button on it shuts down everything ?


Hi, Wes and the usual suspects are:
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Discharged battery, check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
4. Bank angle sensor tripped and ignition/light key switch not cycled to the "OFF" position and then back to the "ON" position.
5. Faulty starter button/switch.
6. Faulty jiffy stand or clutch pull in switch/sensor.
7. Security alarm needs a reset.
8. Starter control circuit, relay, or solenoid faulty.
9. Electric starter shaft pinion gear is not engaging or over-running starter clutch slipping.
For more information about your issue and valuable free downloads that you will need please visit the websites below. Good luck and have nice a day.
Another 03 cbr 600rr will not crank
HONDA CBR WONT START TRY THESE TIPS
2005 2006 Honda CBR600RR Service Manual Moto Data Project

Feb 26, 2016 | Honda Motorcycles

1 Answer

Why won't my 2005 CBR 600 RR rev past 3500 rpm?


I have a few questions for you. 1. Have you owned the bike since it was new? 2. Have you been able to rev beyond 3500 rpm prior?

Apr 24, 2015 | 2005 Honda CBR 600 RR

1 Answer

Idle control


If you feel it is a good deal and account the cost to repair the broken idle then go for it.
Chcek with your dealer first how much it would cost then do the deal.

Mar 23, 2010 | 2004 Honda CBR 600 RR

1 Answer

I am putting a cbr 600rr motor into a 2006 yfz 450


Hi and welcome to FixYa,

Have you tried here?

Good luck and thank you for asking FixYa.

Nov 04, 2009 | 2005 Honda CBR 600 RR

1 Answer

I have a cb400n super dream which will not rev above 6500rpm. i have changed the plugs and oil and striped and cleaned the carbs, but the problem is still there.


Is that not the REDLINE? you cannot go beyond the redline please! Check your throttle cable connection for obstruction, and make sure the butterfly valves open to the max. Might be that the manufacturer installed some rpm limiter switch.

Oct 21, 2009 | Honda CB 400 Super Bol Dor Motorcycles

2 Answers

Honda CBR 600RR 04 electrical problem


Does anyone no what problem i have?
I`v got a honda cbr 6 rr 05,tiptop condition starts everytime, runs really well. but when i turn off the engine. " like for filling up or just for 5min" It wont start or reluctant to start first time, but 2hrs later starts perfectly again!
can any one solve this problem please.
thanks. justin

Feb 05, 2009 | 2004 Honda CBR 600 RR

2 Answers

CBR 600 rr 04 lights and bike die when switched to high beam


There is a direct short in the bar switch or in the head lamp bucket check the wiring

Jan 22, 2009 | 2004 Honda CBR 600 RR

Not finding what you are looking for?
2004 Honda CBR 600 RR Logo

269 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4477 Answers

yadayada
yadayada

Level 3 Expert

61037 Answers

Gino Cussen
Gino Cussen

Level 2 Expert

216 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...