Question about 1989 Yamaha FZR 250 R

1 Answer

My fzr 250 87mod is electricaly dead.

After id been out riding for a few hours i switch off my fzr like always,left it then 2 hours later jumped back on it and nothing,no power.completly dead.Tryed a roll start,nothing no even a cough. removed and rechardged the battery overnite,put it back in,still dead as a doornail. Had the bike for 12months and it hasnt missed a beat till now. any clue anyone?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Yamaha Master
  • 8,404 Answers

Double check that you have not accidently hit the kill switch.

Posted on Dec 02, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
goofduck
  • 490 Answers

SOURCE: FZR 250 power promblems and no top end power battery keeps draining

need to have the valves adjusted and the compression checked

Posted on Jun 16, 2009

  • 83 Answers

SOURCE: Son dumped the ttr 225 and now get nothing from

NOT FOR SURE BUT SOUNDS LIKE MAYBE THE CLUTCH SWITCH COULD BE THE CULPRIT. ALSO CHECK THE SIDE STAND SAFETY SWITCH.

Posted on Oct 21, 2009

  • 518 Answers

SOURCE: i have a 91 fzr 600 recently did oil change, spark

sounds like loose or bad connections,earth lead clean at frame?,

Posted on Jul 04, 2010

  • 1 Answer

SOURCE: 1990 FZR 600 - Battery problems? drainage?

this is yours jarnater or regulater problem same problem to me i have fzrr 400 but i install a new regulater and then i solve my problem

Posted on Aug 14, 2010

  • 129 Answers

SOURCE: after a 2 hour ride

Might have 12.67 volts, but not enough amps to crank engine or light the lights properly. Try putting a charger on the battery, bring it to a full charge. Next, put a load tester on the battery to see if battery is weak or dead cell. If battery checks good, check the charging system. With engine running at idle, put volt meter on battery-read volts, then rev engine to high idle. Volts should climb higher than idle reading.

Posted on Apr 18, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

96 infiniti g20 ABS light came on and car died


Have the fault codes read. Replace faulty items. Use only genuine items as non-genuine replacement are not always compatible with the OEM fitted CPU units If you needed a bigger battery then the autozone salesperson should have sold you the correct battery first time round.( try getting a refund on the first battery) Jump starting an efi vehicle incorrectly will do serious damage to the control module requiring a new ecu unit. Check what is staying on when you switch off including interior lights/ boot light

Jul 04, 2013 | Cars & Trucks

1 Answer

Bike has new battery and i was riding it,parked bike and came back a couple hours later and it was dead. push started it and it was fine,shut it off a couple times after riding places and it started up....


You should start by checking if its charging.
put a volt meter across the battery, it should read roughly 12v
then start the bike and it should rise to 14v
much more than this can blow bulbs and boil batteries

Aug 14, 2011 | 1993 Yamaha FZR 600

1 Answer

Bike cranks and runs fine, then for some reason the battery goes dead, I jump it with a quick jump and it starts and runs, I can run it for a few minutes, turn it off and back on starts great, battery may...


Sounds like an alternator or charging problem.
Check to see if you are getting around 14v on your battery with the engine running.
If not you will have to investigate your alternator etc.

-----


Please dont forget to vote this answer was helpful.


Many thanks

------

Feb 22, 2011 | 2003 Honda VTX

2 Answers

My 1996 Yamaha FZR 600 won't start. The lights turn on, but when I hit the start button, all I hear is a fast clicking sound. Maybe from the digital ignition box. I have tried jumping it from a car...


sounds like the battery to me, have it checked by a sparky, they dont give you much warning before they **** themselves, I had to replace mine only a few months ago

Jun 17, 2010 | 1989 Yamaha FZR 600

1 Answer

1990 FZR 600 - Battery problems? drainage?


this is yours jarnater or regulater problem same problem to me i have fzrr 400 but i install a new regulater and then i solve my problem

Feb 18, 2010 | 1990 Yamaha FZR 600

2 Answers

Vacum cleaner flashes lights and goes dead.


Do you put it down before you turn it on? some vacs wont turn on in the upright position. Happened to me once til I stepped on the button to bed it back then powered right up.

Jan 15, 2010 | Electrolux Vacuums

Not finding what you are looking for?
1989 Yamaha FZR 250 R Logo

131 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

dhnguyen

Level 2 Expert

281 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1144 Answers

Tony

Level 3 Expert

2600 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...