Question about 2008 Moto Morini Corsaro 1200 Veloce

2 Answers

Hi there i have a problem with thermo fans not working, i have checked fuse box but its good the bike is moto morini veloce

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Hi there i had the same prob with my fans , try to press on the centre of the fan it will work again it is the brushes that are worn .re dom.

Posted on Jul 01, 2010

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 1,512 Answers

Hi dunmpy,
 there are some things to check with the bike to diagnose the problem.  

  1. When the bike is cold, turn on the ignition and check with a test light or multimeter that the fan has 12 volts to it
  2. If so,it is the earthy side of the fan being switched. 
  3. If there is no voltage on the fan, connect your test light between the battery +ve terminal and check each terminal of the fans.
  4.  If it lights up then it is 12 volts you have determined that it is being switched with a dedicated earth to the fan.
  5.  If there is no 12 volts, and no dedicated earth, I expect that there is a fault in the chassis -ve connection to the fans. 

From here, where there is a dedicated earth, and you have determined that it is good with your test light, 
  1. get the bike to the temperature that you normally expect the fans to fire up. 
  2. The fans will be supplied 12v when they are supposed to come on. Check to see if that happens.
 If not, are a few options of what it may be. 
  1. Either a faulty thermostat,
  2.  a faulty relay switching 12 volts (or earth) to the fans,
  3. faulty wiring/connectors failing  connecting any of the above. 
Following the above  should tell us what is happening, and guide you to where the trouble may be. Bike wiring is a nightmare to diagnose. Usually it is a connector that has failed or has had water in it. You may need to purchase a shop manual to assist you with troubleshooting. I have a had a quick look on the net, but came up with nothing. Thanks for using FixYa. Happy to talk to you more about the problem. A FixYa is a great reward for my time in taken to get this info to you. Cheers
regards robotek 

Using the test light connected 
  1.  do you have voltage on the fans 
 
When you expect the fans to be running.

Posted on Jan 11, 2009

  • Graeme Ross
    Graeme Ross Jan 11, 2009

    Disregard the last 3 lines of my post. Didnt see them still there when posting...should have been edited out. 


    How did you go...any updates?


×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

WHRE IS THE FAN FUSEE IN A 1.3 TOYOTA TAZZ


you changed the thermo switch and relays and it didnt fix it
did you test the fan motor itself

the fuse box cover should have a fuse layout diagram
engine cooling fan

look for a 30 amp fuse

they usually near the fan relays

is the air con cooling fan working with air con on
and engine running




26238251-04wei2fenntfkeahz4fn3g0j-5-0.jpgwhre-fan-fusee-in-1-3-toyota-tazz#sln-36379873-rmi0ll110lgwm2wbdtthe4rs-3-2_0.jpg

Jul 15, 2016 | Toyota Cars & Trucks

1 Answer

Starting


GET YOUR BATTERY LOAD TESTED ,SOUNDS LIKE ITS BAD

Jan 20, 2013 | 2008 Moto Morini Corsaro 1200 Veloce

1 Answer

My fan on my bike is not coming on and the bike is over heating fuse is good


The most common reason for the radiator fan to stop working on a Honda is a bad thermo switch. It is located on the back left side of the radiator and turns the fan on and off. Cost for the part is around $60. The fan motor could also be bad , that runs about $250. Check the fan to see if it is frozen or spins freely. When the lead was grounded on the fan, the fan should turn on.

May 06, 2011 | 1998 Honda F6 C Valkyrie

1 Answer

Volkswagon POLO 2001 Manual Problem: thermo fan not working. Hi all, I have since ordered and replaced the fan with a another fan and the fan still does not work!! Could it be the fuse? Initial...


CHECK TO SEE IF POWER GOING TO COOLANT FAN AND COOLANT FAN THERMO SWITCH.THERMO SWITCH LOCATED BOTTOM OF RADIATOR ON THE LEFT HAND SIDE.IF POWER GOING TO THERMO SWITCH THEN SWITCH IS FAULTY.IF NO POWER GOING TO THERMO SWITCH OR COOLING FAN.CHECK LARGE FAN FUSE IN THE ENGINE COMPARTMENT AND YOU HAVE FUSE 16 IN FUSE HOLDER.IF FUSES GOOD YOU HAVE SHORT IN THE FAN WIRE OR FAULTY FAN CONTROL MODULE.SHAKE FAN WIRES IF FAN WORKS PROBLEM IN THE FAN WIRES YOU HAVE A SHORT IN THE WIRES..

Jan 12, 2011 | 1996 Volkswagen Golf

1 Answer

My thermo fans are not kicking in just chasing common faults for this


Hi and welcome to FixYa,

Initial check would be on the fan motor switch. Temporarily jump the black wire to the fan motor switch to ground, the fan should spin. If yes, then the thermo switch may require further check/replacement. If no, check for presence / absence of IGN +12 on the black/blue wire going to the fan motor. To my recollection, the wire is fed by a 10 amp fuse in the fuse box.

Good luck and thank you for asking FixYa. Happy Holidays.

Dec 26, 2009 | 1997 Honda CBR 900 RR Fireblade

1 Answer

The water temperature gage shows temp's up to 115 degrees Celsius and then still the fan's do not work. Does that imply there is a problem with the fan's or do they only start at an even higher...


The fan should have come on by then!
Check out the fan by putting power straight to it, if it works then
Check the wiring from it to earth & to the temperature sensor
If that also checks out then its the sensor
Ride Safe
Bike-doc

Please mark this as useful (if it has been!!)

Aug 03, 2009 | 2008 Moto Morini Corsaro 1200

1 Answer

Rust


spraying deisel on it will not keep it from rusting it will damage the bike

Nov 10, 2008 | 2008 Moto Morini Granpasso 1200

1 Answer

Rust


spraying deisel on it will not keep it from rusting it will damage the bike

Nov 10, 2008 | 2005 Moto Morini 9 1/2

1 Answer

Questions on my new (to me) 500


the gauges are in need of help. Tach looks shot and the speedo has a (very) bent needle but otherwise seems to work fine. Battery size is needed as well (amps and physical dimensions).I run a 12N12A battery for lightness (no elec start) Venhill in Surrey UK do fantastic cables off the shelf for morinis & all wop tackle. I'm sure they have a web presence. just spell out exactly what you need. ive had many things from them - often not what I requested.... you can also try http://www.motomorini.co.uk/,,

Nov 10, 2008 | 1981 Moto Morini 500 Turbo

1 Answer

Shocks for morini 500 sport


I measure mine at 12.5 inches from centre to center. Try Ikon I`m sure they would have a set to fit,

Nov 10, 2008 | 1981 Moto Morini 500 Turbo

Not finding what you are looking for?
2008 Moto Morini Corsaro 1200 Veloce Logo

221 people viewed this question

Ask a Question

Usually answered in minutes!

Top Moto Morini Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

68032 Answers

kakima

Level 3 Expert

101642 Answers

Are you a Moto Morini Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...