Question about kawasaki VN 800 A Vulcan Motorcycles

Open Question

Choke won't stay out - VN 800 A Vulcan kawasaki Motorcycles

Posted by Anonymous on

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

wd4ity
  • 4565 Answers

SOURCE: my choke won't stay on. it keeps sliding back

If you look at the choke cable just behind the knob that you pull out, you'll see a round knurled knob. If you tighten this knob, it increases the tension on the cable. However, if someone has put a lubricant on the cable, it may not do any good.

Good Luck
Steve

Posted on Jun 09, 2011

landstar377
  • 66 Answers

SOURCE: my 2003 Honda Valkrie starts with the choke but

That is a sure sign that the carbs need cleaning. The low speed idle jets are plugged up and the choke cuts back the air and allows more fuel in the mix. There are 6 carbs on the Valkyrie so have someone who knows what they are doing clean and sync them.

Posted on Jul 09, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Acts like the choke is stuck closed it won't stay started and runs ruff until engine warms up then its fine. What do i do?


Well the choke has an electric part that heats up and makes the choke open in a few minutes. As soon as the engine starts the choke should open about 25 percent by way of a vac pull-off.
You can take the air cleaner off and watch the choke while someone starts the engine cold. If the choke does not open after it starts, check the choke pull-off. You can also open the choke with a screwdriver to see if the engine clears up.

Jan 29, 2013 | 1987 Chevrolet Caprice

1 Answer

Replaced all fuel lines and pickup fuel filter. but won't stay running without choke.


Take the carburetor off and clean it and check and replace any air filters you may have. Can't say that this will fix it ,but it is a starting point for you. Hope it works and good luck.

Dec 01, 2012 | Poulan P3416 16Inch 34cc 2Cycle Gas...

1 Answer

Husqvarna 445 start/stop switch won't stay in choke


remove the top cover and see if the pins are broken from the sides of the lever

Sep 05, 2012 | Husqvarna Garden

1 Answer

Not Staying Started


I can't tell you how many pieces of small equipment I have been given for free because it "just won't start" or "won't stay running". Start by draining the tank and cleaning it out - use a good carb cleaner. It only takes a grain of sand to create a problem. You may have to take the carb apart and clean that out too.

Aug 01, 2012 | Husqvarna 7021 21Inch 160cc Honda GCV Gas...

1 Answer

Chainsaw won't stay running


You must have dirt in one or more of the carb jets. Remove the carb and clean it with carb cleaner spray and compressed air (compressed air is a must).

May 10, 2012 | Echo 30.1CC Chainsaw With a 14 In.bar and...

1 Answer

Won't stay on when choke is pushed all the way in


idle screw or tickover out of adjustment , Dirty carbs

Jan 27, 2012 | 2009 Yamaha V Star Classic

1 Answer

Engine starts but won't continue to run. Choke doesn't stay closed after starting. will stay running only if I hold choke closed manually.


let it warm up with choke closed manually after it starts to stall with choke closed open it and dont let it stall u can learn to play with the choke a little to get it to run right GOOD LUCK!

Aug 14, 2011 | Toro Lawnmower 20099 Mower Mowers Lawn

1 Answer

My 2003 Honda Valkrie starts with the choke but won't stay running wiyhout it.


That is a sure sign that the carbs need cleaning. The low speed idle jets are plugged up and the choke cuts back the air and allows more fuel in the mix. There are 6 carbs on the Valkyrie so have someone who knows what they are doing clean and sync them.

Jul 09, 2011 | 2003 Honda F6 C Valkyrie

1 Answer

My choke won't stay on. it keeps sliding back in to its normal position & i have to hold the choke out until it warms up.


If you look at the choke cable just behind the knob that you pull out, you'll see a round knurled knob. If you tighten this knob, it increases the tension on the cable. However, if someone has put a lubricant on the cable, it may not do any good.

Good Luck
Steve

Jun 09, 2011 | 2001 Harley Davidson FXDL Dyna Low Rider

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

46 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...