Question about 2001 kawasaki ZZR 250

1 Answer

Thankyou i discovered the problem with my mates zzr it had blocked carbs thanks 4 your reply

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

The best way is to remove carbs open bowl and soak on carb cleaner over night . make sur no rubber o rings or any rubber part is in cleaner remove and set aside.( Diaphram) as they will expand.Get a shop Manual it will show you what you need to do. If you can not find one let me know

Posted on Jan 12, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Describe your Briggs Stratton Lawnmower Lawn Mower Short Block Problem. I have model# 11A-414E765 Lawn Mower. Starts ok but is surging and when I checked a brand new spark plug it was full of black dust...

I am pretty sure this is a 4.5 Hp engine with the carb on top of the tank. Plastic carb 4 or 5 mounting screws mating carb to tank. Remove the air cleaner... and tighten the carb to fuel tank mating screws. It is drawing air between the tank and the carb. This should stop the surging. If is has been a long period that you used the mower with the surging problem the diaphragm between the tank and the carb may be either out of position or damaged. The diaphragm is not expensive. Usually the first time this symptom presents itself you can resolve it by tightening the carb to tank scresw. IF you have the primer bulb carb..mash the rubber of the bulb against the carb body. If the surging stops... the primber bulb has a pin hole in it.

You passed the mower model number and not the engine model number. When we use the 11A number you passed all we get is the base and handle parts. If you need more help I need the model number off the engine just above the spark plug wire on the air shroud.

Thanks for choosing Fixya,

Aug 31, 2011 | Briggs & Stratton Briggs Stratton...

1 Answer

Hi i got a zzr 600 im not geting fuel to carb 2 or 3 and no fuel in float chambers but runs on 1 and 4 for a bit thans terry

Sounds to me that the float may be stuck in the raised position for that carb. This will keep the needle vavle closed preventing fuel entering the float chamber. has the bike been left in the garage for a while on its side stand if so that might also indicate that the float pivot pin is worn and as the fuel evaporates the float has jammed against the side of the float chamber. Carb cleaner slight tapping of the side of the carb float chamber and possible a squirt of compressed air. All worth a try before a massive strip down. Jim ex heli-mech.

Jun 26, 2011 | 1990 kawasaki ZZR 600

1 Answer

Hi i have a zzr 600e 1998 model im having

sounds like a carb or carbs are clogged need to have them cleaned and synced
may also want to make sure you have spark at all 4 cylinders

Jan 27, 2010 | 1993 kawasaki ZZR 600

1 Answer

Where do fuel lines connect to on 92 zzr 250

Hi and welcome to FixYa,

On a ZZR250, the only fuel line is from the petc0ck to the Tee between the carbs.

Good luck and thank you for asking FixYa.

Nov 25, 2009 | 1991 kawasaki ZZR 250

1 Answer

I need an maintainence manual for a zzr 400

there is not a manual for the zzr 400 so use the zzr 600 everything is the same except from the carbs and the head

Oct 09, 2009 | 1990 kawasaki ZZR 400

1 Answer

Nearside carb problem on kawasaki zzr1100

Clean your carbs! Your floats might be sticking open a bit. Plus, all Kawasakis have a simple spring-actuated check valve in the fuel valve. This way, you can disconnect the fuel line without having to block the flow. Fuel could be leaking through the check valve. Your problem most liklely identifies dirty gasoline. Clean out your tank, your carbs, and change your fuel filter.

Apr 08, 2009 | 1992 kawasaki ZZR 1100

1 Answer

Zzr 1100 c model revs fine stationary and starts ok but when riding will not go faster than 50mph and stutters back and forth all the time

The spec sheet doesn't say if your model has fuel injection or carbs. Assuming carbs, disassemble and clean them. You will want the shop to balance and sync the carbs as well. This should get you back on the road in style.

Please rate this solution. Thanks!

Mar 31, 2009 | 1990 kawasaki ZZR 1100

1 Answer

I TURNED OUT THE IDLE SCREW CABLE OF My ZZR 400 N, where does this go back into the carb and can i replace this without removing the carbs? please advise ta

yes this can be replace without removing the carbs and it goes at the rear of the carbs reach your hand through the fairing and it goes on the throttle stop
you will need to feel with your hands

Mar 26, 2009 | 1997 kawasaki ZZR 400

1 Answer

No power

Hi ...... Wet your finger and see if the downpipes are warm/hot then try swapping the spark plugs from cylinder to cylinder. This will isolate bad plug or blocked carb ........... Let us know how you get on.

Dec 22, 2008 | 2001 kawasaki ZZR 250

Not finding what you are looking for?
2001 kawasaki ZZR 250 Logo

Related Topics:

150 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers


Level 3 Expert

77499 Answers


Level 2 Expert

342 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides