Question about Yamaha G5 Motorcycles

1 Answer

Pw50 problems stating bike

Hi just brought second hand pw50 bike for my lad bike seemed to be running fine when i brought it now i am struggling to get it started it does run ok when i get it going . i have put a new throttle cable on new air filter .still a problem to start it.please help with any ideas

Posted by on

  • Anonymous Mar 23, 2014

    Would a empty oil reserves cus bike to run poorly

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 137 Answers

Hey there matey,, just to run a few things with,, have u taken the spark plug out and cleaned it up,,try a new plug 1st,, to be sure, or if u have a new plug,, take out the spark plug place it back in its cap and rest it on the cylinder head and either elec start it or kick it over and make sure u have a spark ,, if all is ok on the above,, then turn to fuel and carburetta, make sure fuel is gettin to the carb 1st,, but u say u do eventually gettin it goin ,,then theres a blockage in jets ,,undu the bottom of the carb clean out the bowl, ,in the carb u will see a brass jet, un screw that and the needle guide that the jets screwed in to and using a pin or needle,poke the small hole clean so u can see light threw them,, bung it all back together and pray,, if no joy il get back to ,, ok m8, enjoy

Posted on Jan 10, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Yamaha pw50 engine diagram


I could probably dig you up a diagram, IF I knew the MODEL YEAR of your bike.

For the best help, ALWAYS give the YEAR/MAKE/MODEL!

Jan 27, 2014 | Motorcycles

1 Answer

Pw50 kickstart


remove sidecover and check shaft , spring and cog etc is ok ! tip bike on side so oil stays inside ! ! easy repair ! P....

Nov 25, 2013 | Motorcycles

1 Answer

Yamaha pw50 replaced card and throttle cables when I move lever from start to run the bike is at full throttle. why????


What is a "card" on a PW50? I have one here and have no idea what part you could mean. My guess with the throttle is that you have the cable way too tight. Check that first - it is quite touchy, since the idel is also st with the cable tension on some earlier models.

Oct 27, 2013 | Yamaha Motorcycles

1 Answer

I have a 2010 V7 Guzzi. Great bike except the kickstand falls down while driving which opens a safety kill switch. I brought it back once and the owner of the shop traded it out with another kickstand from...


At this age it should still be under warranty, and even if it isn't, it is strange that it fails after being serviced. Ring the service place/dealer and ask them what they did to it as it was fine before they serviced it. That should make them collect the bike and fix it for you.

Good Luck

Jun 26, 2011 | Moto Guzzi V7 Special Motorcycles

1 Answer

I have a Kawasaki Ninja, ZX6r, 1997 F3. The bike starts great and rev's great when standing. At high rev's its as sweet as a nut. The problem seems to be when riding the bike and the revs are below 4,000....


There are adjustments on carbs for low speed air intake (air mixture screw)find out factory settings and reset that mixture.Sounds to me like those adjustments are out of sink.If so the bike will run very bad from idle to about 1/4 throttle then run great from there up to full throttle.this definitly sounds like carb problem.

Mar 13, 2011 | 1997 kawasaki ZX-6R Ninja

1 Answer

Hi, i have brought a 2005 cbr600rr second hand. it only came with 1 key which was stolen out of my car.. i contacted the guy i brought the bike from and said he lost the spare, it has a HISS ignition and i...


hi, yes this is correct, you will have to buy a key from honda and have them re code the key for you, you will have to have the bike pluged in to a diagnosic machine for recodeing at a dealership

Jan 22, 2011 | 2005 Honda CBR 600 RR

2 Answers

Stand switch


Sound like the sidestand switch. Follow the wires from the switch to where they can be unplugged, and jumper together the ends on the bike side, not the stand side, this should over-ride the switch to see if it fixes the problem. If it does, the switch is bad.

Aug 22, 2009 | 1987 kawasaki GTR 1000

1 Answer

1999 ultra classi fuel injected twin cam


Hi Bbbabe66, for more information about your question please visit the websites below. Good luck and have nice day.
Harley Davidson Magneti Marelli Fuel Injection Settings
https://www.youtube.com/watch?v=X1a9kBx_Lb4

Apr 24, 2009 | 2000 Harley Davidson FLHTCUI Electra Glide...

1 Answer

Backfiring and seems to be struggling getting fuel


check to make sure your plugs arent fouled. the last bike i had did that to me, fine in the morning and when i went to leave for work in the afternoon the bike ran like **** for a few seconds and shut off. i took the bike back to where i bought it and they replaced the plugs. ran fine after that.

Feb 16, 2009 | 2003 Yamaha XJ 900 S Diversion

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

576 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1128 Answers

D. E. Hev

Level 3 Expert

1059 Answers

mikeuk

Level 2 Expert

61 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...