Question about 2001 Triumph 955i Speed triple

1 Answer

Wont start triumph 955i

It fires on one cyl occasionaly . the engine managment light remains on while cranking .
If i remove the tank and clean the plugs it starts for a second or 2 thats your lot

Posted by on

  • michaelyoung Jan 09, 2009

    I have tested the fuel filter and pump and plugs all fine .

×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 292 Answers

You not getting fuel to the plugs, gotta be carbs or injection whatever you have. berrymans b12 is a good fuel system cleaner

Posted on Apr 03, 2009

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
cape cod bob
  • 292 Answers

SOURCE: triumph 955i not starting

gotta be fuel, bad fuel (gummed up carbs or injection) Berrymans B12 fuel additive system cleaner is very good. double dose and mix in gas tank.
also check or change fuel filter

http://www.carlsalter.com/motorcycle-manuals.asp

go here for free pdf service manual

Posted on Apr 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have just purchased a 2003 daytona 955i and when i got it home the engine management light came on and is still on after doing a further 40miles careful riding. when i first went to view the bike the...


Hi, Keith_jones1 it should be noted that the reasons your check engine light or CEL stays on constantly or flashes and your bike will or will not start and may turn over or not, these conditions will vary from bike to bike depending on the year, make, and model and you should always refer to your owners/service manual for proper diagnostic procedures. It should also be noted that any type of prior work done to the bike or an abnormal event occurrence IE: adding accessories, electrical curiosity/adventures, laying bike down/crashes, rainstorms/bike washings just before CEL light issues started can be significant hints/aids into tracking down the gremlin, also carry the appropriate jumper wire to access fault codes to reduce the risk of being stranded or towed also keep in mind that your CEL comes to life if anything, and I do mean anything isn't 100% with the ECM like parameter spikes. This means that you could be staring at a major repair, or your speedometer sensor is contaminated and needs to be cleaned.
And the usual suspects are:
1. Severely discharged or a damaged battery check the terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary, you should have 12.5 volts or more and be able to pass a proper "LOAD" test if necessary, you may have a preliminary reading of 12.5 volts or more but little or zero amperage the battery is faulty and must be replaced, AGM batteries fail in this scenario more so than lead acid batteries.
2. Faulty charging system.
3. Faulty system sensor some models have up to 40 sensors
4. Faulty safety switches: run/off, ignition, clutch lever, neutral, side stand, tip over, fuel, and or their connections.
5. The engine got wet where it didn't like to get wet.
6. Faulty ignition circuit spark plugs, coils, cables etc.
7. Broken wire or worn insulation exposing wire to a ground situation especially inside wire harness at tight bends around fairing brackets, under dash panels, under fuel tanks over cylinder heads etc. Many harnesses are open on the ends that will allow water to enter and accumulate at v-bends.
Dielectric grease and contact cleaner are your best friends for wire/cable/harness connectors, look for corroded, broken, or loose pins/sockets.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
Triumph engine management light
How do get the engine management warning light off
Triumph Daytona 955i 2002 Service Manual
http://www.triumphestore.com/
Triumph Daytona 955i Handbook

Jul 01, 2017 | 2003 Triumph Daytona 955i

1 Answer

Triumph Daytona 955i 2004 , Just had a 12,000 mile service but the bike as started to smoke / burn oil this did not happen before the service any idea what the course could be.


If the oil is too thin, that may be a cause or if the oil has cleaned the carbon deposites off the piston rings because it is a detergent oil, that may cause it.
Check the oil that was used and check the crank case breather is not blocked building up pressure in the cranl case with obvious consequences.

Feb 12, 2011 | 2004 Triumph Daytona 955i

1 Answer

2004 Triumph daytona 955i. 4000 miles. Was riding and all of a sudden bike dies, no power to lights speedo or any gauges, starter button wouldnt work. Pushed home and turned key on all lights worked and...


Hi, The_redneckc and the usual suspects are:
1. Severely discharged or a damaged battery should have 12.5 volts or better and be able to pass a proper "LOAD" test if necessary your battery may show 12.5 volts or more but have little or zero amps and must be replaced.
2. Failed alternator/generator and or voltage regulator.
3. Loose or corroded battery terminals and or cables especially the "NEGATIVE" cable, look for loose, corroded, or broken connectors inside the cable harness at "BOTH" ends.
4. Failed main circuit breaker or ignition switch, check for loose connections and continuity.
5. Failed system and or ignition relay, check for continuity.
6. Failed ignition coil, ignition/electronic module.
7. Failed CKP, CPS, CMP, MAP, TPS, or BAS sensor, corroded, loose or broken wire connector pins/sockets.
8. Throttle cables and or idle speed improperly adjusted hot idle speed should be 950 RPM to 1000 RPM.
9. Fuel tank empty.
10. Fuel tank contaminated with ethanol sludge.
11. Water or dirt in the fuel system, or clogged filter.
12. Restricted, blocked or kinked fuel line.
13. Faulty fuel pump.
14. Faulty pressure regulator.
15. Faulty or clogged fuel injectors.
For more information about your issue and valuable "FREE" downloads that you need please click on the blue links below. Good luck and have a wonderful day.
2002 955i Daytona Quits while running and then will not start
Topic Starting Issue on 2005 Triumph Daytona 955I RUNNING AGAIN Read 8197...
Triumph Daytona 955i 2002 Service Manual
Hermys Triumph Motorcycle Parts 2004 Triumph Genuine Body and frame...
Triumph Daytona 955i Handbook

Apr 17, 2017 | 2004 Triumph Daytona 955i

1 Answer

2003 Triumph Speed TRiple 955i check engine light is on


Hi, March_of_fla for this scenario you will need your service, parts fiche, and owners manual if you can't find the best tool you ever bought for your Triumph, despair not, for a mere zero $0 you can download another one. For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
2003 Speed Triple check engine light on
TuneECU Help Error codes on 2002 955i
Triumph Daytona 955i 2002 Service Manual
https://www.triumphestore.com/
Triumph Speed Triple Handbook

Jul 14, 2017 | 2003 Triumph Speed triple

1 Answer

I have a 2004 955i speedtriple.I charged the battery last night as I do from time to time due to the short journeys that I do. When I started it this morning the engine management light stayed on but it is...


There is a number of things that can cause this engine management light to come on. The fuel could be old, the plugs could be fould. After checking these things, reset the power and test operation. Good Luck

May 13, 2009 | 2001 Triumph 955i Speed triple

1 Answer

Engine turns over but will not fire up


dead battery or relay stuck.. i am having the same issue with my 2003 triumph speed triple.. turns over well but no spark no fuel in injectors.. ecu isnt telling it to start. dead battery? or relay?

Mar 01, 2009 | 2006 Triumph Daytona 955i

1 Answer

Engine does not start


JUST A SHOT IN THE DARK ON THIS.

TRY DISCONECTING THE POSITIVE POWER CABLE ON YOUR BATTERY,AND WAIT TEN OR TWENTY MIN.THEN PUT THE POSITTIVE BACK ON IT.

SEE IF THAT WILL RESET IT.

HOPE THIS HELPS

ELLIOT NEACE

Feb 25, 2009 | 2004 Triumph Tiger

1 Answer

Triumph 955i not starting


gotta be fuel, bad fuel (gummed up carbs or injection) Berrymans B12 fuel additive system cleaner is very good. double dose and mix in gas tank.
also check or change fuel filter

http://www.carlsalter.com/motorcycle-manuals.asp

go here for free pdf service manual

Jan 11, 2009 | 2001 Triumph 955i Speed triple

Not finding what you are looking for?
2001 Triumph 955i Speed triple Logo

487 people viewed this question

Ask a Question

Usually answered in minutes!

Top Triumph Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Are you a Triumph Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...