Question about 2005 Kymco Xciting 500

1 Answer

Motorcycle yamaha r6 won't start at 40 degrees, any help?

Motorcycle yamaha r6 won't start at 40 degrees, does somebody know why? this usually hapend in the morning, during the day is perfectly fine. any help?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 48 Answers

Try spraying a little gas in the carb if it starts then the problem would be your choke

Posted on Jan 13, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

R6 overheating


Hi, Anonymous and the usual suspects are:
1. Low coolant level.
2. Restricted radiator air flow.
3. Faulty thermostat.
4. Coolant pump or fans inoperative.
5. Vent hose crimped.
6. Air in the coolant and needs bleeding.
7. Engine idling too long or bike moving too slow.
8. Coolant too old needs to be replaced.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
http://www.r6-forum.com/forums/65-new-member-section/160259-02-r6-overheating-problems.html
R6 overheating problem solved
Yamaha YZF R6T Supplementary Service Manual
OEM parts for Yamaha
http://mybikemanuals.com/yamaha/yamaha-yz-owners-manuals

May 19, 2014 | 2005 Yamaha YZF-R6

1 Answer

R6 2007 will start but wont rev


Hi, Moses for this scenario you will need your service/owners manual if you can't find the first and best tool you ever bought for your Yamaha, despair not, for a mere $0 you can download another one. For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
http://www.r6-forum.com/forums/57-garage-mechanical-help/158952-bike-starts-wont-rev.html
07 R6 throttle is not getting engaged and clutch seems jammed bike was...
2007 Yamaha YZF R6 Service Manual R6 Moto Data Project
OEM parts for Yamaha
http://mybikemanuals.com/yamaha/yamaha-yz-owners-manuals

Mar 27, 2014 | 2007 Yamaha YZF-R6

1 Answer

My 2003 Yamaha r6 wont hold idle when it warms up


Hi, Anonymous and the usual suspects are:
1. Idle speed improperly adjusted.
2. Air fuel mixture screws not properly adjusted.
3. Inlet system air leak.
4. Leaking accelerator pump.
5. Loose low-speed jet.
6. Plugged low-speed jet.
7. Contaminated or plugged low-speed circuit.
8. Enrichner valve/choke not seated or leaking.
9. Multi carburetors out of sync and need to be balanced.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
Won stay on idle drops to zero rpm kinda
2007 Yamaha R6 won idle more info inside motorcycles
2003 2004 Yamaha YZF R6 Service Manual R6 Moto Data Project
OEM parts for Yamaha
http://mybikemanuals.com/yamaha/yamaha-yz-owners-manuals

Sep 24, 2013 | 2003 Yamaha YZF-R6

1 Answer

Yamahar6 secondary injectors code show 40


Not sure what your talking about - 2000 R6's had carb's. The first year for a fuel injected R6 was 2003.

Feb 13, 2013 | 2000 Yamaha YZF-R6

1 Answer

Can somebody tell me what wires to connect so I can turn my 03 Yamaha r6 to keyless entry for the drags


Hi, Brandon for this scenario you will need a wiring diagram from your service/owners manual if you can't find the first and best tool you ever bought for your Yamaha, despair not, for a mere $0 you can download another one. For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
2003 2004 Yamaha YZF R6 Service Manual R6 Moto Data Project
OEM parts for Yamaha
http://mybikemanuals.com/yamaha/yamaha-yz-owners-manuals
Project Yamaha R6 Part
Yamaha YZF 600 R6 5SL 05

Oct 10, 2012 | 2003 Yamaha YZF-R6

1 Answer

2007 r6 won't start and the red light on the clocks is flashing


Hi, Anonymous for this scenario you will need your service/owners manual if you can't find the first and best tool you ever bought for your Yamaha, despair not, for a mere $0 you can download another one. For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
Oil Light Flashes But Bike Won Start 04 R6
http://www.r6messagenet.com/forums/r6-maintenance-technical/148355-arrrrggghhhh-please-help-2003-r6-wont-start.html
2007 Yamaha YZF R6 Service Manual R6 Moto Data Project
OEM parts for Yamaha
http://mybikemanuals.com/yamaha/yamaha-yz-owners-manuals

Oct 09, 2012 | 2007 Yamaha YZF-R6

1 Answer

Hi i have a 99 r6 and i have no spark to any of the plugs. help please !!


Hi, Jonathan and the usual suspects are:
1. Fouled spark plugs.
2. Severely discharged or a damaged battery, should have 12.5 volts or better and be able to pass a load test if necessary.
3. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
4. Loose connection at ignition coil or plug between ignition sensor and CDI box.
5. Spark plug cables in bad condition, shorting / leaking, spark plug cable connections loose, check for spark leakage in the dark.
6. Faulty ignition coil, pick up coil, trigger coil or CDI box testing needs to be checked with an ohmmeter at 70 degrees Fahrenheit
7. Faulty safety switches clutch, kickstand, neutral, off/on etc.
8. Faulty ignition switch.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
http://www.r6-forum.com/forums/57-garage-mechanical-help/335658-no-spark-troubleshooting-nutshell-may-still-need-help.html
http://pnwriders.com/threads/99-r6-wont-start-no-spark.138195
1999 2002 Yamaha YZF R6 Service Manual R6 Moto Data Project
OEM parts for Yamaha
http://mybikemanuals.com/yamaha/yamaha-yz-owners-manuals
Project Yamaha R6 Part
Yamaha YZF 600 R6 5SL 05

Aug 22, 2012 | 1999 Yamaha YZF-R6

1 Answer

Yamaha r6 2005 won't start. Display shows no error


Hi, Axios_nt and the usual suspects are:
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Discharged battery, needs to be 12.5 volts or better and be able to pass a load test if necessary.
4. Check the battery terminals for damage or corrosion check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
5. Tip over sensor needs a reset.
6. Faulty ignition switch.
7. Faulty starter button.
8. Faulty kickstand or clutch pull in switch/sensor.
9. Starter control circuit, relay, or solenoid faulty.
10. Main fuse or circuit breaker may be blown or faulty.
11. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have nice a day.
http://www.r6-forum.com/forums/57-garage-mechanical-help/129148-2005-r6-wont-start.html
R6 wont start
Yamaha YZF R6T Supplementary Service Manual
OEM parts for Yamaha
http://mybikemanuals.com/yamaha/yamaha-yz-owners-manuals

Mar 12, 2012 | 2005 Yamaha YZF-R6

1 Answer

2004 r6 starts but won't stay running what I do


Hi, Mckinneym697 and the usual suspects are:
1. Idle circuit and transfer ports clogged.
2. Air fuel mixture adjustment too lean.
3. Pilot jet clogged.
4. Faulty accelerator pump.
5. Float level too low.
6. Float bowl contaminated old fuel, water, dirt, rust, etc.
7. Float bowl vent or overflow tube clogged.
8. Fuel flow to carburetor restricted.
9. Intake manifold leak.
10. The gas cap is not venting properly or fuel tank venting system blocked.
11. Vacuum line from intake manifold to petcock broken, cracked, or not attached, carburetor vent line plugged.
12. Needle and seat stuck closed in the float bowl.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have nice a day.
2007 Yamaha R6 won idle more info inside motorcycles
Wrecked bike starts but doesn stay running ideas
2003 2004 Yamaha YZF R6 Service Manual R6 Moto Data Project
OEM parts for Yamaha
http://mybikemanuals.com/yamaha/yamaha-yz-owners-manuals

Jul 14, 2011 | 2000 Yamaha YZF-R6

1 Answer

Yamaha r6 doesnt start at 40 degrees, any help?


your oil is to thick the same happend to my buell, it start and stall about 5 times befor it would stay running. around 45 degrees outside,I switched to a thinner oil for winter. now it starts and rides in 10 degrees.

Jan 08, 2009 | 2005 Kymco Xciting 500

Not finding what you are looking for?
2005 Kymco Xciting 500 Logo

Related Topics:

170 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kymco Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4471 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you a Kymco Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...