1993 Cadillac DeVille Logo
Posted on Nov 18, 2012

Dash panel workin but blower motor wont come on?

The heat control on dash is workin and it says its on but the blower motor is not kickin on

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

  • Contributor 1 Answer
  • Posted on Dec 22, 2012
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Joined: Dec 22, 2012
Answers
1
Questions
0
Helped
85
Points
1

I HAVE A 1993 CADILLAC. I BELIEVE THE HEATER CORE IS OUT. THERE IS NO WATER IN THE DASH BOARD OF THE CAR. I'AM THINKING I MY NEED TO REPLACE A HOLES. WHAT DO I DO?

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
3answers

How do I change heater fan

It would help to know the make and model. Different manufacturers put them in different places and mount them different.
0helpful
1answer

A/cmotor not workin

Are you talking blower motor? If Yes, Have you checked for power at the resistor under dash on passenger side, behind glove box. Power should be going in to resistor then out to blower motor.
0helpful
1answer

2004 CHYRLER PACIFICA NO HEAT COMING OUT AND NOW CAR WONT TURN ON

Not sure I follow your question.
The alternator charges the battery so it would not have a direct effect on the blower motor.
If the blower motor is not working, the problem could be the blower motor, a fuse or relay, the resistor if equipped, or the controller on the dash.
1helpful
1answer

My heater blowers dnt work and i need to knw where i can locate the resister blocks for my heater blowers so i can ghange them

Its located under dash,or near glove box.

The dash panel lower side has to be out.

HEATER BLOWER MOTOR


Its faulty blower motor resistor. The low and medium speed on blower motor is controlled by resistor and its actual speed is high. So because resistor is not working, blower motors actual speed which is high is working.


It can be faulty blower motor or faulty blower motor resistor. Get the blower motor inspected. If it's faulty it has to be replaced.


=======

For blower motor testing and replacing, check the link below: ----

Blower motor Testing/replacing for all vehicles?

http://repairhelpcenter.blogspot.in/2012/02/blower-motor-replacing-for-all-vehicles.html

------------

These will help.

Thanks.

0helpful
1answer

The fan has stopped working on the heater. heat comes out but no blowing.

CHECK BLOWER MOTOR FUSE AND RELAY.IF ALL IS GOOD.BEST TO REMOVE BLOWER MOTOR HOTWIRE IT.IF DONT WORK REPLACE BLOWER MOTOR.IF BLOWER MOTOR WORKS.YOU HAVE FAULTY CONTROL SWITCH OR MODULE.BESURE TURN OFF RADIO FIRST YOU NEED TO REMOVE NEGATIVE BATTERY CABLE.WAIT 15 MINUTES BEFORE WORKING UNDER DASH.THIS WILL DISARM AIRBAG AND BCM UNDER DASH.YOUR BLOWER MOTOR UNDER DASH ON THE PASSENGER SIDE FAR TO BACK.YOU NEED TO REMOVE BOTTOM PANEL TO GET TO IT.
0helpful
1answer

For the past month or so i have only had on on my blower for my ac and heat settings 1 2 3 has stopped workin i was told its a easy cheap fix i just dont know what it exactly is and where its exactly...

follow the wires back from the blower motor. The wires from the blower motor should plug into it. That is the part you need to change. Called the blower motor resistor
0helpful
2answers

The blower control for high medium and low stopped workin and will only blow on high then stop on any other setting how do you fix this problem?

the blower speed control switch is probally bad replace it first than if that doesnt fix the problem than move to the blower motor itself as it might be bad
0helpful
1answer

Module location for blower motor on a 1994 Buick Roadmaster with automatic climate control.

on the paasenger side of the car under the dash. Remove the lower dash panel below the glove box and the module is in the duct for the heat to the far right side of the footwell.
0helpful
1answer

Heat

A component called a Resistor located near the blower motor controls the blowers speed. it has a plug and a couple of screws to remove. Replace this Resistor. It is usually located in between the wiring and the blower. Sometimes mounted on the blower motor itself. It can be a little hard to remove because of limited space under the dash.
Not finding what you are looking for?

95 views

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Sean Wright
Sean Wright

Level 3 Expert

2045 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...