Installation
Remove the two upper screws from the headlight housing, using a Phillips screwdriver.
Locate the two lower retaining nuts inside the engine compartment at the bottom of the headlight housing. Remove the nuts using a ratchet, extension and socket.
Headlight Aiming
SOURCE: Headlight lens removal
Open hood and look at top back of the assembly and you will see 2 clips. Pull them up and remove,then release the lower clip and pull assembly out.
SOURCE: Mercury Villager headlight assembly diagaram for removal
This is easy. Lift the lid open. Look at the back of the sealed beam and you will see a clip and an o ring. Pull the clip up and pull wires back toward the driver's seat. Unscrew the o ring and firmly pull the bulb out toward the driver again. Note the 3 tabs on the bulb seat and realign the new bulb with those tab ( 2 bottom, 1 top). Replace with #9007 bulbs..do them both.
SOURCE: 1995 ford f250 headlight assembly how to remove.it
REMOVAL AND INSTALLATION
Headlamp Assembly
Removal
Installation
SOURCE: I cant figure out how
If you looke at the back side were it looks like the bolt in the should be a little tab sticking out at 90 degrees those a retainer clips pull up and the headlight should release.
762 views
Usually answered in minutes!
×