Question about 2003 Honda Silverwing 600

1 Answer

Yellow Light On. 'V' is printed on the light.

Hi There,
See above problem. I do not have a manual unfortunately. Think this might indicate Voltage (??) but am not sure. Perhaps the battery needs water but am not sure where it is - only bought the bike recently - 2nd hand.

Any help would be appreciated

thanks

John

Posted by on

  • john_carty Jan 06, 2009

    Great, thanks for that definitive response Robotek. One more question: Any idea as to where I would get a manual?

  • john_carty Jan 06, 2009

    :-) No, no good to me unfortunately! Thanks anyway

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 1,512 Answers

Hi John
The indicator light indicates that something is out of spec with your V belt drive. It may purely be just a distance traveled thing "time for service" indicator that can be reset. But, if you wish to get ongoing reliability from the motorcycle, then I suggest that you book it in for a service. Nothing worse than stuck on the side of the road broken down. Happy to talk to you more about it. Thanks for using FixYa
regards robotek

Posted on Jan 06, 2009

  • Graeme Ross
    Graeme Ross Jan 06, 2009

    I know where I can get you a German one :) Any good?

  • dixwimby Mar 14, 2011

    when the v-matic yellow light comes on you are normally within 1,300 miles of needing to have the drive belt replaced. this occures at about 13,000 to 15,000 miles on the clock.

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My R15 v2 YZF engine light blinks 10 times firsts 5 blinks slow rest very fast bike tends to stop whenever it appears n stop but when the light is on upper the bikes dont stop above 90 km/hr not stop


Yamaha yellow blinking light start Motorcycles Questions ...

www.fixya.com > ... > Tags > yellow blinking light start > Motorcycles
Ad. Question about 1997 YZF 750 R ... oil light blinking on 2004 yamaha r1 oil lightblinks 10 times stops then blinks 10 ... My yamaha r15 v2 I drive to bike after sometimes yellow engine light on aftersometime I light on to yellow engine light of.

Yamaha blinking yellow light Questions & Answers - Fixya

www.fixya.com > Forum > Tags > blinking yellow light
oil light blinking on 2004 yamaha r1 oil light blinks 10 times stops then blinks 10 times ... Question about 2008 YZF-R15 ... My yamaha r15 v2 I drive to bike after sometimes yellow engine light on aftersometime I light on to yellow engine light of.

[Ownership Thread]: Yamaha YZF-R15 - xBhp.com

www.xbhp.com/talkies/.../4854-yamaha-yzf-r15-1951-print.html

Jul 11, 2013 - 4 posts - ‎3 authors
2months back i got this problem while riding the engine goes off, but ... of heavy traffic after transporting it from my home town. then it works fine and all of a sudden i find the bike engine light blinking. it reads '42'. then after showing it to ... the ECU alone wil cost me to 10k. and obviously it is very expensive ...

Yamaha YZF-R15 version 2.0 - xBhp.com

www.xbhp.com/.../20138-yamaha-yzf-r15-version-2-0-a-786-print.html
Nov 26, 2013 - According to me the problem of chain with my bike is because i ... list about the required changes at 10k kms like Fork oil change and ... On switching on the ignition, the engine malfunction light, the orange(?) ... From your description that a longblink coupled with 3-4 short blinks it .... All times are GMT +6.5.

Yamaha YZF-R15 version 2.0 - xBhp.com


Jan 27, 2016 | Motorcycles

1 Answer

Alternator or Voltage Regulator or Other?


You will need to test the charging system. Try this simple test, hook a voltmeter to the battery and check the voltage with the key turned off. Should be 12 volts. Now start the engine and note the volt meter reading at idle, it should go up to about 13.8 - 14.2 volts. Rev the engine up and note what happens. If the voltage is low at low RPM 12V and then goes up with more RPM like you stated it could be the regulator or the alternator. Start by switching out or trying another voltage regulator. If this does not fix the problem you will need to test and repair the alternator. The alternator out put can be tested by bypassing the regulator. This requires special equipment and know how. I hope this gets you

Jun 30, 2015 | Honda GL 1500 SE Gold Wing Motorcycles

1 Answer

Alternator or Voltage Regulator?


As a general rule, voltage regulators either work or do not; either-or.
This leans more to the alternator. Hook up a volt meter to the battery. Check your voltage engine off, then start it. watch the meter, if it stays below 12 volts and then suddenly jumps up when you reach 2500 rpm perhaps it's the regulator, if it slowly climbs as you describe with the lights your alt may be weak.
Do you have a lot of lights and accessories that stay on? Especially lights-extra lights can put quite a drain. Good luck to you!

Jun 30, 2015 | Honda Motorcycles

2 Answers

Hey anybody know how is yellow light signal indicates. when i ride above 80 it shows.?hows the yellow signal. is t


SORRY BUT I CAN NOT UNDERSTAND THE QUESTION .THE INFORMATION NEEDS TO BE MORE DETAILED.THANKS ALAN

May 01, 2014 | 2008 Yamaha YZF-R15

1 Answer

My r15 flashes yellow light and id doent show speed it show only 0 and also it doesnt show kilometer


Hi, Kalpesh for this scenario you will need your service/owners manual if you can't find the first and best tool you ever bought for your Yamaha, despair not, for a mere $0 you can download another one. For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
http://www.xbhp.com/talkies/help-me/22921-r15-v1-yellow-indicator-hud.html
Yamaha R15 Warning light error codes Team BHP
Yamaha Fault Codes motorcycle manuals
https://ridertua.files.wordpress.com/2011/04/service-manual-yzf-r15.pdf

Apr 11, 2011 | 2008 Yamaha YZF-R15

1 Answer

The high beam blue light on the binacle remains on whether dipped or not?


Evidently the high beam indicator light (blue) is improperly wired. It should be wired with the yellow wire going to the high beam of the head light. You'll probably need a schematic to determine where the light should be connected. I'm sorry but I don't have a schematic for that bike. Harley used a white wire for the low beam and a yellow wire for the high beam for years but I think they changed on the late models.

May 20, 2010 | 2000 Harley Davidson FLHR-FLHRI Road king

1 Answer

Hi have a honda cbr 100f on a 1990 cant get a spark from it any help


Hi and welcome to FixYa,

Initially, for a no spark concern on a 1990 Honda CBR1000F, checks would be on:
  • presence of ignition +12 on the black/white wires to the ignition coil;
  • presence of pulsating voltage on the yellow/blue and blue/yellow wires to the ignition coil;
  • presence of pulsating low voltage between the yellow and white/yellow wires coming from the ignition pulse generator;
  • status of light green wire from neutral switch/indicator;
  • status of green/white wire from sidestand switch; or
  • try starting with the sidestand folded up and/or the clutch lever pulled in.

Good luck and thank you for asking FixYa.

Dec 11, 2009 | 1990 Honda CBR 1000 F

Not finding what you are looking for?

Open Questions:

See all 2003 Honda Silverwing 600 Questions

2003 Honda Silverwing 600 Logo

486 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4481 Answers

yadayada
yadayada

Level 3 Expert

61168 Answers

Gino Cussen
Gino Cussen

Level 2 Expert

216 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...