Question about 2006 kawasaki KLX 110

Open Question

How do you remove the choke assembly from the carb

2006 kawasaki klx 110

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 2336 Answers

SOURCE: oil capacity

1.1 liters it says this on the block on the right side of the engine

Posted on Nov 10, 2008

Ad
  • 2336 Answers

SOURCE: How fast will a Kawasaki KLX 110 go?

Well it depends but it should be able to get up to about 45 mph. However, if u put the 4th gear in it can go maby 50. You can also put some parts in to give ur bike a little more kick

Posted on Nov 10, 2008

  • 126 Answers

SOURCE: klx 110 2006 stalls when choke is pushed in

i'd say the carb is gummed up especially the pilot jet (#16158) in this pic of the USA carb. may have to remove the carb & bowl and then remove the pilot jet (w/ flat head screw driver) and clean out the tiny holes.

http://partsfinder.onlinemicrofiche.com/atlanticcycleandpower/Kawasaki_OEM/KawasakiDB.asp?Type=18&A=39&B=17&Action=O

-OR-

the carb slide is installed backwards (turned 180 degrees). its #16025 in the pic. i've done this before on my daughter's XR70 and Z50. you'll know if its this when you move the choke lever, RPMs increase and decrease.

hope this worked for you and was fast enough.

Posted on Feb 06, 2009

  • 1 Answer

SOURCE: Kawasaki Vulcan VN400 carb diaphragm broken

If you are really stapped on cash napa auto parts has some heavy duty rubber spray. Just spray a thin layer over both sides of the diaphragm to repair any holes/tears and let dry overnight. My diaphragm was going to cost over $110 for one. It will still have full function and be even stronger than stock!

Posted on Feb 12, 2009

  • 636 Answers

SOURCE: KLX 250 won't fire - new battery

-check the fuse right hand side below the fuel tank and seat, see if it is blown.
- Check to see if plug has spark, replace if necessary .
- Did you run the bike with a low battery before replacing it? could be that your stator is shot.
-Is bike trying to start but won't?

Posted on Sep 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

To start and run my kawasaki klx 110 i have to pull the choke all the way out. if i push it in it stalls it was a relatives and has been sitting for a while with gas in it what can i do to fix the problem


Remove and clean the carb. disassemble the carb then soak the carb parts in denatured alcohol for a couple hours then spraying with an aerosol carb cleaner should do the trick. Drain the gas tank and put in fresh gas. Go ahead and install an in-line fuel filter to lessen problems from a rusted gas tank.

Mar 13, 2011 | kawasaki KLX 110 Motorcycles

1 Answer

What is the choke position on 2004 klx 125, up or down


Down is choke "ON" and up is choke "OFF". Had same question and found on another site. Made carb adjusrment much easier after cleaning. Bike was new to me and runs great now.

Jun 05, 2010 | 2004 kawasaki KLX 125 L

1 Answer

How do you find the year on a klx 110


Go to Kawasaki's web site and put in your VIN number and that will give the the model code and then from that you can get the year.

http://kawasaki.com/DefaultFrame.aspx?strContentURL=/SITE/VIVEHICLEINFORMATION/VICHOOSEVEHICLE.ASP

May 02, 2010 | 2006 kawasaki KLX 110

1 Answer

2004 klx 125l bike ideling


How long has the bike been sitting? The gas may be bad or the carb might need to be cleaned out or choke may be sticking.

Feb 06, 2010 | 2004 kawasaki KLX 125

1 Answer

2007 klx 250 runs only when choke is on.


hi buddy on carb is a mixture air screw fiddle with this till it runs if it doesnt i have another plan buddy get back to me with results 8ce62f2.jpg

Oct 12, 2009 | 2007 kawasaki KLX 250

1 Answer

Bogs out, no power


Not much info was given. If it bogs when you open the throttle from idle, remove the cap from the top of the carb and pull out the slide assembly. Now move the clip on the top of the jet needle down one notch. Two notches may be required but start with one. See the diagram below.

Please rate this solution. Thanks!

a9af0ef.gif

Jun 28, 2009 | 2006 kawasaki KLX 110

1 Answer

2004 Klx 125 only runs with choke on. Barely starts


Mixture is off on the Carb, try backing the mixture screw out a quarter turn. Better/ Worse?

Apr 14, 2009 | 2004 kawasaki KLX 125 L

1 Answer

Klx 110 2006 stalls when choke is pushed in


i'd say the carb is gummed up especially the pilot jet (#16158) in this pic of the USA carb. may have to remove the carb & bowl and then remove the pilot jet (w/ flat head screw driver) and clean out the tiny holes.

http://partsfinder.onlinemicrofiche.com/atlanticcycleandpower/Kawasaki_OEM/KawasakiDB.asp?Type=18&A=39&B=17&Action=O

-OR-

the carb slide is installed backwards (turned 180 degrees). its #16025 in the pic. i've done this before on my daughter's XR70 and Z50. you'll know if its this when you move the choke lever, RPMs increase and decrease.

hope this worked for you and was fast enough.

Feb 06, 2009 | 2006 kawasaki KLX 110

Not finding what you are looking for?
2006 kawasaki KLX 110 Logo

Related Topics:

133 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers

yadayada
yadayada

Level 3 Expert

77499 Answers

bazzz7071
bazzz7071

Level 2 Expert

342 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...