Question about 2006 Harley Davidson FLHR Road king

2 Answers

2000 FLHRI turns over but won't start

It has been very cold, and I don't think I waited for the engine light to go off before I turned it over. Now, when I press the reset button on the Odometer and turn to ACC, a code comes up. It is, dOICLr what does this mean, how do I reset it? Thanks.

Posted by on

  • stanimal_23 Jan 06, 2009

    Thanks so much for the quick response. The info should prove useful. If I reset the bike's computer, should it start? My code came up dO1CLr which by your info means there is no problem, thank God! Thanks again for your help. Stan.

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I have a 1998 Road King Classic.. The ground came unpluged fron the fuel injection.. It wouldnt start.. I found the problem fixed it and now the code do1clr comes up how do i reset?

Posted on Aug 01, 2010

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 1,512 Answers

Hi,
I found this info for you.  Have you tried the built in diagnostic in your speedometer? You can access them by: 

1) While you ignition is off hold the reset button 
2) Turn the key to the on position. 

Now from each reset button push the speedometer will test the following: 

d01 Speed sensor power output shorted low 
d02 Speed sensor power output shorted high or open 
d03 Not Used 
d04 Not Used 
d05 Speed sensor return shorted high 
d06 Speed sensor return shorted low 
d07 Not Used 
d08 Speedometer power over voltage 
d09 Speed output shorted high 
d10 Speed output shorted low or open 

The last number CAL14 is the calibration number. 
To reset all codes while in diagnostic mode, hold the reset button in for 5 seconds. 

Each test will read dXXSEt if there is a problem, or dXXCLr if there is not. (XX being the number of the list above) The 

From what I can tell it will test if your speed sensor, speedometer, or wiring is the problem. 

Hope it helps. Cheers
regards robotek

Posted on Jan 05, 2009

  • Graeme Ross
    Graeme Ross Jan 07, 2009

    hehe when you say very cold... maybe a shot of Ether up each nostil would help it fire up :) I dont think the problems relate to each other, except perhaps as you say... its very cold! 

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2001 FLHRI sequencial fuel injection rev's at around 2000 RPM when hot any clues?


You have to adjust the idle cold,and hot. Warm the bbike up,and with the air filter housing off,look at the bottom right? of the backing plate,and there will be a small hole. There is a small torx bit screw in that hole that you will need to turn to adjust the hot idle. Dont quote me,but i think its a t20 or t25 torx bit.

Sep 23, 2012 | 2000 Harley Davidson FLHR-FLHRI Road king

1 Answer

Dual engine and oil lights


No way to tell what happened with the high idle if you can't make it happen on demand.
The oil and engine lights would come on if the engine died while the key was still on so that was a normal event.
You might stop somewhere and have the computer scanned for trouble codes just in case the computer recorded anything.
The difference in octane should not be a big problem if you don't switch back and forth, after about 50 miles of driving the computer will adjust for the octane of the fuel.

Jul 24, 2012 | Ford Explorer Cars & Trucks

1 Answer

1993 Toyota Camry won't restart after driving unless waiting hours. The starter doesn't try and it's brand new. It always starts cold and if you don't drive it, you can turn it off and restart it over


i'me asumeing the batt is ok....turn on lights, do they dim when you try to start engine? if not .bad selonoid on new starter..was it rebuilt? it happens. Billy Starr

Dec 27, 2011 | Cars & Trucks

1 Answer

Kenmore 70 Series Dryer won't turn on. I don't think it is a door switch problem because when I hold down the door switch to make the dryer light turn off, the dryer still won't start. I...


Hi,

There can be many reasons why your dryer will not start or turn...

The most common causes are the belt breaking or jumping off, or the motor goingbad...

Here are a couple of tips that I wrote will help you to figure out why yourdryer will not run...

Dryer Repair - The Dryer is not Turning

Dryer Repair - The dryer will not start


heatman101

Sep 19, 2011 | Kenmore Dryers

1 Answer

My 2000 jeep grand cherokee will start and drive fine. The check engine will turn on and it will die. Some times i can get it to start and then there is times that it won't. When it don't start, it...


There are many things to do with the engine management system the when the ECM light comes on it can kill the engine. You can go to an autoparts store and they will read the codes for free. Get the code number and description. let me know, i will help. Randy

Jul 30, 2011 | 2000 Jeep Grand Cherokee

1 Answer

When I turn my RoadKing on, the turns lights ( both) flah quickly 6 time. I cannot start the engine with the handlebar start button


Sounds like the security alarm on your bike is tripping. You should have a code to enter or you can reset it. I hope this helps.

Jul 03, 2011 | 2000 Harley Davidson FLHR-FLHRI Road king

1 Answer

Engine light comes on goes off, then comes back on and goes back


I THINK that it means there is a code stored. How is it running and starting?

May 12, 2010 | 2000 Harley Davidson FLHR-FLHRI Road king

2 Answers

I have a 1997 FLHRI The bike wants to rev and runs hot


I guess the guy above does not know that FLHR-I means injected no carb anyway..You problem is a heat sensor. Its reading cold when the bike is heated up an should be kicking down. Its on the back of the front jug left side. Unscrew it and replace it. Easy fix.

Jun 10, 2009 | 2000 Harley Davidson FLHR-FLHRI Road king

Not finding what you are looking for?
2006 Harley Davidson FLHR Road king Logo

482 people viewed this question

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Gills Lango

Level 2 Expert

195 Answers

Mike

Level 3 Expert

4334 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...