Question about 2007 Kymco Agility 50

Open Question

Scooter boggs down after carburator cleaned- electric ckoke

I think the electric choke is not seating all the way. The scooter has been put up for 10 months so I clean the carb ( my first time), put it back on and it cranked. It is now very cold natured, unlike before, and when I give it gas the motor boggs down and tries to cut off. Im new at this and I am kinda guessing so any help would be appreciated

Posted by Anonymous on


2 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 68 Answers

SOURCE: Scooter runs for about 5 or 10 minutes, the cuts

Your fuel tank is not venting, or a vacuum line came off. Chaz Moto DC

Posted on Feb 25, 2010


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Carburator problem

not getting fuel from jet you need rebuild carb clean out jet replace needle and seat

Jun 17, 2013 | Garden

1 Answer

ET2 Float adjustment

Do tjese scooter have any kind of temp control sensors? Although fuel will cause this so will temp sensors will run ok then heats up and dies cuz bad sensor. I realy dont know but maybe!!?!!

Mar 15, 2013 | Peg Perego Vespa Scooter

1 Answer

My Honda Met.2 Chf50 runs great with handkerchief on intake of carb but when you attach breather quits

Hi, Monte the two wires are probably for the electric auto choke for this scenario you will need your service/owners manual if you can't find the best tool you ever bought for your Yamaha, despair not, for a mere zero $0 you can download another one. For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
Carburetor Tear Down And Cleaning 2005 Honda Metropolitan CHF50 Scooter
Honda Metropolitan Jazz Ruckus Resource page
Honda 2003 NPS50 Ruckus Service Manual
Honda CHF50 2007 Metropolitan Owner Manual

Jun 11, 2017 | 2005 Honda Metropolitan Base

1 Answer

Idles but Boggs down when u give it gas

Hi Anonymous, if you have a carburator the usual suspects are:
1. Damaged or restricted fuel tank venting system (gas cap).
2. Inlet system air leak.
3. Vacuum piston malfunction.
4. Accelerator pump leaking or no output.
5. Plugged bowl vent.
6. Fuel level (float chamber) too low.
7. Restriccted fuel supply passages.
8. Plugged jets or passages.
9. Worn or damaged needle or needle jet.
10. Enrichner valve not seated or leaking.
Good luck

May 31, 2012 | Harley Davidson FXD Dyna Super Glide...

1 Answer

My velocity 49cc scooter starts and idles fine but when I give it throttle it boggs down

Sounds like a fuel problem. Check the fuel filter, tune or rebuild your carburator.
Thats just possabilities of course...

Apr 14, 2012 | Cars & Trucks

1 Answer

Eton four-wheeler will only start for a second after I spray carburetor with carburator spray help me to get it to run

There are a lot of tiny fuel and air passageways in the carburetor that must be kept clean it order for your scooter to run right. Carefully, take the carburetor apart. This can be relative easy (on a 50cc scooter). The carb has tiny passages that can get gummed up. Your scooter will not run correctly if the carburetor isn't completely clean, so take your time. I use a gallon container of carb dip (you can get a gallon at your local auto supply store).
First, remove all of the rubber and gaskets or they will get damaged. After a 20 minute soaking in carb dip, I blow out the carb with compressed air. You have to get all the jets and the passageways clean. Be sure the jets are clear, especially the starter jet. Sometimes carb cleaner won't clear out these tiny jets. Use a guitar or a piano string, a strand of copper electrical wire, or a tiny drill bit pin vise. Be sure not to increase the size of the hole in the starter jet or you'll change the tuning. Carefully reassemble everything, checking for cracks in the rubber carb boots and the gaskets. Replace them if they are old and cracked. Be sure and remove all rubber and gasket material first or they could get ruined. Spray carb cleaner also works if you're diligent.
If you have an electric choke, check it to make sure it works. Check the resistance between the wires - you should see around 10 ohms or less. Measure the length of the choke assembly. Remove the choke from the carb and plug the wires into a 12V source for 15 minutes. The choke body should be warm. Measure the length again - it should increase by around 1/8".
Next, consider whether your exhaust pipe is clogged. This is especially a problem with older two stroke scooters. The unburned fuel/oil mixture builds up in the exhaust pipe along with carbon over time. If the exhaust pipe is clogged, your scooter will run terribly or not at all. It can be difficult to tell if the exhaust pipe is clogged. The easiest way to tell is to remove it and try starting your scooter. It will be a bit loud - two strokes will sound like a chain saw. If it runs with the exhaust pipe off, you know that is the problem

hope this helps


Aug 21, 2011 | Eton JC 125 B Motorcycles

1 Answer

Won't idle without choke, turn throttle boggs out

have u checked the float hight on the carburator? also make sure ur choke curcuit i clean and free of dirt

Apr 13, 2010 | 2005 kawasaki KLX 125

2 Answers

I have a 02 kx 85 when u ckoke the bike it runs choke off bike shuts off

The choke allows more fuel. I would guess that you have a plugged jet in the carburator. Remove it and go through it all to make sure all passageways are clear.

Aug 21, 2009 | 2001 KTM MXC 250

2 Answers

50cc Sunl gas scooter

You may need to adjust the fuel/air ratio. There is a small screw under the pull starter facing horizontally (its behind the plastic air filter cover, but accessable) adjust either clockwise or counter clockwise in small increments and give it gas and see if it dies or boggs down. Also check that spark plug is clean and not fouled, and air filter is clean and olied.

Jul 06, 2008 | Transport Schwinn Rechargeable Portable ...

Not finding what you are looking for?
2007 Kymco Agility 50 Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kymco Experts


Level 3 Expert

77202 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Are you a Kymco Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides