Question about 2003 Victory Vegas

1 Answer

I bought a 2003 Vegas and it is full of gas and the starter is doing its job. But it wont start the Spark plugs were real dirty but cleaned em um and the sparked. Dont know what it could be?

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Make sure the plug wires are snapping into place on the top of the spark plugs, or you may need new wires.

Posted on Dec 01, 2013

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What cause my 2000 dodge neon to stop on me and now it wont even turn over. and all of the spark plugs is cover in oil?


it is possible that your neg battery terminal could be losing contact or coil could have stopped working and im sure the oil on the spark plugs has a bit to do with the running issue . You need to change the valve cover gasket make sure nothing is cracked clean up the valve cover and engine side surface install valve cover gaskets and bolts torque em down and see what happens youll probably have to replace the spark plugs or clean them up real good

Jan 26, 2015 | 2000 Dodge Neon

1 Answer

Castelgarden 102 wont start


could be a number if things, dirty carb, old gas, dirty coil contacts, low combustion chamber pressure, (bad rings), bad spark plug. First try replacing the spark plug and if it is old gas remove and replace with fresh. if that doesn't do it then the carb needs to be removed, cleaned and blown out thoroughly with an air compressor. reassemble and reinstall. next is to remove the recoil housing and clean the coil contacts. the coil is attached to the spark plug wire. remove and with some old gas or wd-40 and a wire brush, remove dirt and rust from contacts as well as magnet on the flywheel. be sure to leave the proper gap between the coil and flywheel when you replace the coil. If you can pull the recoil with your forefinger and thumb, chances are your machine is toast and needs a ring job. good luck

Aug 05, 2014 | Briggs & Stratton Garden

1 Answer

I barely bought a dodge stratus 03 it wnt start please help


Car not starting or turning over indicates towards multiple possibilities. It can be issue with battery or weak battery. But if battery checks out ok, then it can be starter issue or faulty alternator or problem with low fuel pressure or no spark at spark plugs due to dirty spark plugs or faulty ignition coil or injectors getting cracked or dirty and needs to be cleaned.


To confirm the problem, the basic troubleshooting is required.


Click this link below and follow the troubleshooting:------

http://technoanswers.blogspot.in/2012/02/car-starting-issues.html

---------

This will help.

Thanks.

Mar 03, 2012 | 2003 Dodge Stratus

1 Answer

Hi. I have a Briggs & Stratton 2800PSI gas pressure washer. I can get it to start, but after about 5 min, then it quits. I have cleaned the carb, change oil, changed plug, new gas, cleaned/checked...


if it wont start, check for spark.how you do that,ok take the spark plug wire out put it close to the sparkplug(use some gloves or something to insulate your self from get electric shot from the spark) find some one who pull the start rope, if you dont see any spark between wire and spark plug, tehre its not spark ,it will never start.you will have to remove the start recoil on the botton is like a damper whitch will have to be remove also ,on botton of it its like a coil whitch with the rotation of the damper when you pull the starter rope provoke the spark and send it to spark plug along with the gas combution get the engine started.that coil some time goes bad and have to be change.if you have electric starter. check the starter also.good luck

May 30, 2011 | Briggs & Stratton Prosumer 20324 Gas...

1 Answer

My yukon sometimes wont starterd until 10mins,tehy told me it was the gas pump. i replace it and still does it


COULD BE DIRTY FUEL INJECTORS LEAKING WHILE ENGINE OFF FLOODING OUT SPARK PLUGS.TRY THIS REPLACE AIR FILTER.CLEAN FUEL INJECTORS BY ADDING A BOTTLE OF SEAFOAM TO 3/4 TO FULL TANK OF GAS SEE WHAT HAPPENS.

Mar 02, 2011 | 2003 GMC Yukon XL

1 Answer

I have a p-3416 poulan saw it is getting spark but the saw still wont start


It's not getting gas. Possible wrong mix oil to gas, but not real likely. Possible sat over the last winter with gas in it and varnished. I'm guessing this is the one, more likely than not. take cover and filter off and clean and bag 'em. pour carb cleaner in the carb and soak overnight. Dump out (carb cleaner and old gas)into a sealable jar or can and fill with straight gas and soak an hour and dump into trash gas/carb cleaner. Use a bicycle pump to blow air into carb to dry it. At most use a computer air can. Then start with the right gas/oil mix, prime it, set the trigger and choke and drop start. (It helps to have the spark plug out during the soak. Then clean it and sandpaper the gap and the magneto area on the flywheel).

Jun 18, 2010 | Garden

2 Answers

I have a cub cadet that wont stay running.


Is the gas more than 5 months old? If so drain the old gas and replace with fresh gas.
If that does not fix it try replacing the fuel filter.
If that doesnt fix it try cleaning and re-gapping the spark plug or replace the spark plug. If none of these easy fixes do it then it could be a dirty carb.

Apr 04, 2010 | Garden

1 Answer

WONT START


Not so many reasons she won't start. 4-Strokes are Simple!

Here they are:

Motor:
Fuel Tank-> Fuel Line-> Fuel Filter-> Carb-> Intake (Valve)-> Piston-> Exhaust (Valve)-> Muffler

Carb (Old Style):
Fuel Side:
Fuel Bowl-> Float-> Needle Seat-> Fuel Ports (Venturi)
Air Side:
Air Filter-> Carb Air Intake-> Butterflies (2)
(Clean 'em ALL!)

Hardware (Motor):
Rotor (Magnets)-> Magneto (Ignition Coil)-> Spark Plug Wire-> Spark Plug-> Cylinder Head (Spark Plug Ground)

Ignition:
Kill Switches (Seat, Clutch, etc.)-> Spark Plug/Ignition Coil-> Ground
Key Ignition-> Battery->Starter/Generator

If one of those fail.......= Non-Starting 4-Stroke!

Fixes-
Fuel:
You are either getting too much, or too little. Too much = Carb.
Too little = Carb. Therefore, tear down the Carb (COMPLETELY-Careful!) and clean it up.

Electrical:
Grounding out the System (Kill Switches)
Battery-> Ignition-> Starter.
Magneto->Plug Wire->Plug (Check 'em all!)


May 28, 2009 | Mtd Garden

Not finding what you are looking for?
2003 Victory Vegas Logo

Related Topics:

137 people viewed this question

Ask a Question

Usually answered in minutes!

Top Victory Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers

Joseph Hoffmann

Level 3 Expert

1706 Answers

Are you a Victory Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...