Question about 2011 Schwinn Sport 50

1 Answer

Schwinn Sport 50: Scooter turns on, but I can't get the throttle/handle to twist. Throttle/handle is loose.

The throttle/ handle is loose. I can move it about one cm to the left and right.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Renaissance:

    An user who is expert in 3 categories / brands.

  • Schwinn Master
  • 1,917 Answers

You need to replace or tighten the throttle hold down screw right just being held in place by throttle wire this is very dangerouse if the cable slips or sticks it will be held open

Posted on Jun 06, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hope scooter will start but when I give it gas nothing happens


Trace the throttle cable from the handle to the(carb or throttle body).Either the cable is broken,it has come off at one end,or the throttle handle or a piece of linkage is broken or loose.(this is a pretty basic problem-you can do it!)

Oct 26, 2012 | Office Equipment & Supplies

1 Answer

The scooter will go but when throttle is released it keeps going and won't slow down?


I had this problem too. U need to twist on it and jam it until it turns off. Twist it back/forward. U can also pull in brake. The brake automaticaly deactivates motor. Hold brake until STOPPED then let go. The scooter will stay

Jun 18, 2012 | Razor E100 Electric Scooter

1 Answer

PGO PMX 50 Sport poor idling and slow revving


Hi, Rackham3120 and the usual suspects are:
1. Idle speed improperly adjusted.
2. Air fuel mixture screws not properly adjusted.
3. Inlet system air leak.
4. Leaking accelerator pump.
5. Loose low-speed jet.
6. Plugged low-speed jet.
7. Contaminated or plugged low-speed circuit.
8. Enrichner valve/choke not seated or leaking.
9. Multi carburetors out of sync and need to be balanced.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
tgb r50x still giving problems Scooter Invasion
http://125ccbikeclub.awardspace.co.uk/basic_fault_finding.htm
PGO PMX Sport 50 Service Manual
PMX 50 AC PGO Scooter Parts Racing Planet USA
PGO MAX 50 User Manual

Jun 21, 2017 | 2011 PGO PMX Naked 50

1 Answer

E100 Electric Scooter: The twist handle is stripped...


Replace the throttle and handlebar. You can find a throttle replacement at: electricscooterparts.com

May 16, 2010 | Razor E100 Electric Scooter

1 Answer

Engine Scooter, throttle does not work


trace the cable to the connection on the motor.check that throttle lever is connected to cable,and lever moves when throttle is turned.cable may have broken.

Oct 06, 2009 | 2008 Yamaha Yamaha G5

2 Answers

I need a schematic for the x-treme scooter


Check the batteries, they need at least 12+volts to run scooter. Blinker may be burned out or the wire came loose. If batteries are charged Two things That could be wrong are: Twist throttle is NO Good, Or the controller is BAD. You need a voltage tester, (Disconnect the Wiring Harnesses) and check voltages coming out of the controller(the silver BOX with lots of wires) and see if it is sending voltage to the twist throttle. Controller wires to the Twist throttle should read 4-5 volts.

(Make Sure You Unplugged That Wiring Harness) There is 4-6 wires in that Wiring Harness then find + and - test them for voltage from that Controller box wiring harness. If You get a positive reading out of that Controller wiring harness then the Twist Throttle thing is bad. If you get NO READING out of that Controller Wiring Harness Then if is BAD. Normally it will be the dead batteries or the Twist Throttle that go bad. Batteries are expensive, Twist Throttle Cheap. Good LUCK

Apr 03, 2009 | Electric X Treme X 360 Scooter

3 Answers

Schwinn s-400 scooter no motor activity.


I had same issue, bought a new controller. 40 bucks from the manufacturer. Works great.

Jul 20, 2008 | Transport Schwinn Rechargeable Portable ...

3 Answers

S1000 Schwinn transport scooter battery


my husband is using schwinn tranport s 1000 we brought new batteries now it won't run can you help

Jul 15, 2008 | Transport Schwinn Rechargeable Portable ...

2 Answers

Schwinn S180 won't charge


NashvilleDan, this scooter has 2 12v 10 amp batteries in series, you should read over 24 volts at the charging hub if the batteries are good. I would think that if the scooter sat for over a year you have bad batteries, They can be purchased at battery plus.

Mar 19, 2008 | Transport Schwinn Rechargeable Portable ...

Not finding what you are looking for?
2011 Schwinn Sport 50 Logo

Related Topics:

107 people viewed this question

Ask a Question

Usually answered in minutes!

Top Schwinn Experts

Ross Keen

Level 3 Expert

1251 Answers

mikeuk

Level 2 Expert

70 Answers

Cindy Wells

Level 3 Expert

5166 Answers

Are you a Schwinn Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...