Question about 2011 Sym Joyride 200 RV

Open Question

Sym Joyride replace air filter - 2011 Sym Joyride 200 RV

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 3567 Answers

SOURCE: I HAVE A SYM JOYRIDE 125 AND THERES A TAPPING NOISE

If you hear a tapping noise from the gearbox then you have a broken gear tooth. Is the sound is present in all the gears or just in one or two gears? If the tapping is present in all gears then the busted tooth is on the clutch hub or the crankshaft drive gear. This is good because it is easier to fix than a broken transmission gear.

If the tapping is just in one or two gears then you will need to remove the engine for a complete tear down. In any event, ALWAYS replace gears in sets. Replace the broken gear and the gear that it meshes with. Don't replace both gears and you will soon wish you did. ALWAYS replace gears in sets.

Please rate this answer. Thanks!

Posted on Apr 20, 2009

  • 1 Answer

SOURCE: My Sym Joyride 180 cuts out when I slow down

If this happens in cold weather or after a fast run it's carb icing. SYM do a replacement carb bowl to solve this or you can use a fuel additive SILKOLENE Pro FST. I use the additive as it also keeps the fule system clean and lasts well.

Posted on Jul 03, 2009

flyingfrog
  • 3 Answers

SOURCE: my sym joyride 200 is somewhat like dragging at

I also own one (4 years old). Assuming it drives strongly enough at speed the problem will be your belt drive/variator transmission. If you are OK mechanic-wise remove the left side panel (you have to remove the small rear panel near the lights first) and then all the txmission case screws to have a look. If the belt is OK (and they last forever) it could be you need new roller weights in the front variator. They wear flat spots afet a couple of years that ruin acceleration. (Special tool needed - I made one though), or new clutch shoes in the rear variator - or maybe they are just sticking and need a good clean. Spin everything by hand to check for noise/slop/ wobbliness and check the oil in the tiny rear gearbox (see owners handbook. You need a measuring cup and a paint syringe to get the exact amount right.
If you aren't confident use a good bike garage. weights are inexpensive and probably clutch shoes too so if you can do any labour yourself it won't break the bank. Google for a free SYM Joyride workshop manual by the way. Happy scootering

Posted on Sep 09, 2009

  • 4 Answers

SOURCE: intermitent snatchy drive on 2004 Sym joyride.

,being a scooter it will be in your belt has streched or your rollers have flattened out .the rollers should be changed every 2500klms or so ,as they flatten out they take longer to reach the top of the variator(they have to try and slide not roll like there supose to)
your bike has no chain and sproket like the last answer said (and he calls himself an expert)if you look at http://www.youtube.com/watch?v=3yRskb0BYwE&feature=related it will show how a variator works

Posted on Jan 24, 2010

  • 4 Answers

SOURCE: my sym joyride has a rough transmission when i

have you checked your belt ,also 3000 is about the limit i drive with my rollers unless i use the dr puller (sliders)they last alot longer .some rollers flatten out at about 1500-2000klms,the clutch could be worn or one of the springs could have failed(clutch or contra spring)that will give a rough ride ,1 more thing when you changed the rollers did you clean the variator and get rid of all the belt dust

Posted on Jan 24, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Sym Joyride 125 overheating


Hi, Yorkie and the usual suspects are:
1. Low coolant level.
2. Restricted radiator air flow.
3. Faulty thermostat.
4. Coolant pump or fans inoperative.
5. Vent hose crimped.
6. Air in the coolant and needs bleeding.
7. Engine idling too long or bike moving too slow.
8. Coolant too old needs to be replaced.
9. Faulty radiator cap.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
Scoot overheated 5mi from dealer
http://symforum.com/index.php?topic=3431.0
Sym Joyride 125 Service Manual
Sym JOYRIDE 125 cc 2002 Parts
SYM JOYRIDE 125 User Manual

Jun 25, 2017 | 2007 Sym Joyride 200

1 Answer

How to change from km to mph on my sym joyride 125 ?


Hi, Yorkie for this scenario you will need your service/owners manual if you can't find the first and best tool you ever bought for your Sym, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
Switching Speedometer between Km and MPH
MPH display
Sym Joyride 125 Service Manual
Sym JOYRIDE 125 cc 2002 Parts
SYM JOYRIDE 125 User Manual

May 15, 2017 | Sym Motorcycles

1 Answer

My Sym 125 starts however when l go to use the throttle the engine stops what can I do


Hi, Michael you have carburetor issues and the usual suspects are:
1. Idle circuit and transfer ports clogged.
2. Air fuel mixture adjustment too lean.
3. Pilot jet clogged.
4. Faulty accelerator pump.
5. Float level too low.
6. Float bowl contaminated old fuel, water, dirt, rust, etc.
7. Float bowl vent or overflow tube clogged.
8. Fuel flow to carburetor restricted.
9. Intake manifold leak.
10. The gas cap is not venting properly or fuel tank venting system blocked.
11. Vacuum line from intake manifold to petcock broken, cracked, or not attached, carburetor vent line plugged.
12. Needle and seat stuck closed in the float bowl.
13. Multi carburetors not in sync
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
ScooterCommunity
How it works 150cc GY6 Automatic Choke Buggy Depot Technical Center
Sym Joyride 125 Service Manual
https://www.oemmotorparts.com/oem2.asp?M=sym
SYM JOYRIDE 125 User Manual

Apr 03, 2017 | Sym Motorcycles

1 Answer

How canI find the year of my Sym shark engine it's been replaced


Hi, Dmills for this situation I would call my local dealer or reputable shop's service/parts department and inquire about any possible quick fix, answers, or parts inquiry. For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
https://scootergrisen.dk/scooterhjemmeside/download/sym_shark_rs_21_servicemanual.pdf
Sym SHARK 125 cc 2001 Parts
SYM JOYRIDE 125 User Manual
SYM Shark 125
SYM Motors Wikipedia

Mar 09, 2017 | Sym Motorcycles

1 Answer

Hi what will be my engine code sym joyride evo125cc 2010 reg number yj10khd engine number ku735159...also can you supply variator complete for above bike? cheers george


Hi, George for this situation I would call my local dealer or reputable shop's service/parts department and inquire about any possible quick fix, answers, or parts inquiry. For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
https://en.vindecoder.pl/LXMTCKPF990118880
ftp://safercar.gov/MfrMail/ORG4317.pdf
Sym Joyride 125 Service Manual
SPARE PARTS
SYM JOYRIDE 125 User Manual

Nov 04, 2016 | Sym Motorcycles

1 Answer

I changed my aril filter on my sym joyride to a foam one. Now it's back fires, why?


NEEDS BACK PRESSURE WAS STANDARD THICKER AND FOAM LET MORE AIR IN IF SO COULD BE YOUR PROBLEM CHANGE FILTER OR PUT JET KIT IN

Sep 19, 2013 | Sym Motorcycles

1 Answer

Will not start


CHECK FUEL/OIL LINES FILTER ETC ADUJST/CLEAN CARB REPLACE ALL ITEMS LISTED AS NEEDED

Jun 25, 2013 | 2008 Sym Joyride 200

1 Answer

Sym joyride 200 acceleration on uproads issue


Hi, Faris1234567 nice novella you may have carburetor issues and the usual suspects are:
1. Inlet system air leak.
2. Enrichener valve not seated or leaking.
3. Damaged or restricted fuel tank vent system.
4. Restricted fuel supply tract.
5. Dirty or damaged air cleaner element.
6. Plugged bowl vent or overflow.
7. Worn or damaged needle or needle jet.
8. Vacuum piston assembly malfunction.
9. Loose or plugged main jets or passages.
10. Improper float level.
11. Accelerator pumps inoperative.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
http://symforum.com/index.php?topic=2755.0
SYM Joyride 200 acceleration
https://scootergrisen.dk/scooterhjemmeside/download/sym_joyride_servicemanual.pdf
https://www.oemmotorparts.com/oem3.asp?M=sym&T=joyride%20-%20200%20cc
SYM JOYRIDE 125 User Manual

Mar 10, 2017 | Sym Motorcycles

1 Answer

Need to access battery on sym joyride 200


If it is leaking battery acid you should be able to work out where the battery is. Because you can see where the electrolyte is coming from. Remember to disconnect the earth wire (black) first. Remember to neutralise the battery acid after you have removed the failed battery.

Feb 12, 2012 | Sym Motorcycles

1 Answer

My Sym Joyride 180 cuts out when I slow down


If this happens in cold weather or after a fast run it's carb icing. SYM do a replacement carb bowl to solve this or you can use a fuel additive SILKOLENE Pro FST. I use the additive as it also keeps the fule system clean and lasts well.

Jun 20, 2009 | 2004 Sym Husky 125

Not finding what you are looking for?
2011 Sym Joyride 200 RV Logo

Related Topics:

41 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sym Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75117 Answers

montehammons

Level 3 Expert

5252 Answers

Are you a Sym Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...