My car runs fine its just the gas and rpm and speedometer gauge go up and then the rpm and speedometer go to 0 the rpm guage should atleast stay at 800 to 1000 at an idle. what is the problem is it my cluster
Need a new cluster. There may be a recall not sure but you can have cluster fixed by replaceing the step up motor in cluster.
Testimonial: "like this solution it got to the point"
is the cluster behind the gauges
can i find the cluster at a salvage yard
The step up motor goes bad on all gm products 98 and up pretty much
ok where do i find the step up motor
Salvage yard or most module repair men can fix it for you. Call any auto shop and ask where you can have it replaced or repaired but a salvage
LKQ DELIVERS 800-525-3667
×
sounds like your missing a ground somewhere.
SOURCE: the odometer speedometer gas gauge and heat gauge do not work
There has been issues with the solder joints on the PIN connection to the gauge cluster. The issue being that over time thru vibration and such one of these solder joints will fail (happened on or 1999) you can repair this though. You will have to remove all of the trim from around the driver's side dash board, this will include the trim towards the center of the dash. Once these pieces are remove you'll need to remove the gauge panel (I believe (4) allen head screws) carefully bring the panel and release the wire clip from it. Looking at the back of the panel, where the plug was, carefully with plenty of light look for one of the pins to have a failed solder joint. It will be very faint however the failed joint will be a fine dark line around the pin. To correct use a small soldering iron and reheat this solder until it wants to flow, let it cool and reassemble.
I hope this may have helped,
Tom
PS: I have helped several persons with this issue, please review my profile; good luck with it (also often times with this issue the ABS light stays on)
Testimonial: "thank you you are the only person who had an answer I will try and let you know"
SOURCE: 2000 Chrysler Voyager Instrument Cluster is dead
have you got a dimmer switch on your model to dim the dash lights. if you have it may be faulty. link the cables together if the lights work the switch is faulty. if you have not got a dimmer switch
your printed circuit on the back of the dash may be faulty or the plug in the back of the dash is not pushed all the way in. hope this helps
SOURCE: speedometer, gas gauge, odometer, rpm gauge not working
My gas guage, speed odometer and tempiture does not work
The speed odometre is reading 9999999 what should i do
SOURCE: Everything works fine on my vehicle EXCEPT today
Check the fuse for those items that don't work.
564 views
Usually answered in minutes!
×