Question about Motorcycles

1 Answer

The wires coming out of motor don't match what's on wiring harness. And I have real diagram but there is no stator or color decoder on it along with 2 other component that do not have names on then s

Posted by on

  •  Tammy R Youngman
    Tammy R Youngman Nov 02, 2012

    This is from an 2007 ATV Eagle Lyda 203e with an Egl 171 fmm/2 cylinder motor- 4 stroke liquid cooled.

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 2,019 Answers

It looks to me as if that plug is to the TCI, (Transistorized Coil Ignition).
http://www.jetav8r.com/Vision/Diagrams/SchematicTCIBig.jpg
http://viragotcirepair.com/
So it has leads to the stator as an electrical source, leads to the coils, and a lead to the tach.

Posted on Oct 31, 2012

  •  Tammy R Youngman
    Tammy R Youngman Nov 02, 2012

    Well Kirk- After reading your reply, I clicked on the diagram you added- It was very insightful. My Wiring is from an 2007 ATV Eagle Lyda 203e with a 171 fmm 2 cylinder motor. Thank you so much. Its been 11 months of frustration trying to get her back running again- you made us smile!!!

×

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 48 Answers

SOURCE: I have an oil leak from where the stator wires come out.

you have some seals that are leaking from around the crankshaft the stator is supposed to be sealed from the oil you wont have to change the stator just the crank seal

Posted on Feb 27, 2009

  • 1 Answer

SOURCE: 2000 yamaha warrior atv will not run

do you have good air intake like new airfilter and good fuel flow

Posted on Mar 14, 2009

  • 2 Answers

SOURCE: stator wiring overhaeting

My 96 GSXR was doing this too. I found I had oil leaking into the stator case. This had "washed" the insulation off the windings (I think) causing it to short out. It shorts worst when it is hot. Now when I disconnect the generator while running it runs great. Reconnect, and a huge blue spark arcs across the plug. This causes a huge current flow at this plug (back and forth). I haven't gotten all my parts yet to try out my diag. Check under your stator cover, or just continuity test it in the bike (OHMs meter).

Posted on Jun 04, 2009

tundrajet
  • 80 Answers

SOURCE: need wiring diagram for 03 hd flht

Visit your local Harley dealership and sweet talk someone in the service department to photocopy the required wiring diagram.

Bring a six pack for his trouble.

Posted on Jun 07, 2009

  • 5 Answers

SOURCE: Suzuki 1999 Quadrunner LTF250F wiring harness issue

no power to my magneto on my 99 suzuki LT-F250F dont know what one of the four other wires should be power i found the ground please help

Posted on Sep 21, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I need help with wiring diagram for a chevy tahoe 08 radio installing a pioneer avh-x3700bhs I did buy a wiring harness but it doesn't have all color wires on it


Just match wire purpose on both diagrams. Wire color may or may not match.

EXAMPLE: Right Front Positive (RF+) and Right Front Negative (RF-) on the harness is purple (RF+) and purple/black (RF-). While on the radio it's white (RF+) and white/grey (RF-).

Feb 23, 2015 | Pioneer Car Audio & Video

1 Answer

Error code le on washing machine wm-1480fhd.... drum stops spining in certain directions and then stops with the error code :LE


Well, according to the LG error look up table:

LE Locked motor error. Cause: The connector (3-pin), male,white) in the motor harness is not connected to the connector. (3-pin,female,white) of stator assembly. Or the electrical contact between the connectors. (3-pin,male,white) in the motor harness and 4-pin,female,white connector in the main PWB assembly is bad or unstable. Or the motor harness between the stator assembly and main PWB assembly is cut (open circuit) Or the hall sensor is out of order/defective.

Decoding the techno speak, this means that the little rev counter, built on to the back of the motor and connected by 3 wires has either come loose, fallen off, failed or its wires are unplugged. The result is the machine can't figure what speed the motor is running at, so it shuts it down.

Sep 16, 2011 | LG WM-1480FHD Front Load Washer

1 Answer

I need the wiring diagram for a dual stereo model xd1225 to hook it up to a 1986 ford f150


OK, for starters, get a wiring harness made for your vehicle. All aftermarket radios have standardized wiring colors. You wiring harness will have matching colors, so it will be easy to hook up. The harness will also have the diagram of colors on the package. However, you vehicle wire colors will not match this. That's why you have the harness. You will just plug into the stock vehcile harness. You will not have to match any wires because the harness is specifically made to match your vehicle. Trust me, it's easier this way. You can find them all over, try www.crutchfiedl.com to get one if you need. Hopd this helps.

Aug 23, 2011 | Car Audio & Video

1 Answer

I need Only color coding for wiring diagram for cdx-gt550


If you are planning to install your radio, I recommend you purchase a wiring harness specific for your vehicle. All aftermarket radios are standardized in wiring colors. The harness will have the diagram to hook your radio to the harness. The problem with hardwiring a radio is the wiring colors don't match, and hooking it up wrong could fry your entire electrical system. You can find a harness at www.crutchfield.com Hope this helps.

Aug 23, 2011 | Car Audio & Video

1 Answer

I need the wiring diagram for this sony car radio. trying to install it on a different vehicle thx


You don't need the wiring diagram, you need a wiring harness. They are only a few bucks and will save you a ton of time and the risk of frying your entire electrical system. The wiring harness will come with instructions. All radio wires are standardized. All you will need to do is crimp the appropriate colored wire to the matching wire on the harness. Then plug the harness into the vehicle. Hope this helps.

Aug 22, 2011 | Car Audio & Video

1 Answer

Need wiring diagram from alpinecde 9852 to 98 gmc sierra


The simplest solution to this is to use an after market harness like this. They're available at most big box electronics stores like BestBuy. The colors on this should match the colors on the Alpine so it's as simple as matching them up and soldering them together. The important colors are those for the constant and switched power (usually yellow and red), ground (black), and the speakers pairs (purple, green, white and grey). The dimmer (orange) and remote (blue) or not necessary to normal operation.

The factory wiring colors are shown here in case you don't want to use the harness. All you need to do is match the descriptions and connect the wires.

Hope this helps. Let me know if you have any questions.

Ray

Apr 12, 2011 | Alpine CDA-9852 CD Player

1 Answer

Need a wiring diagram for my 92 volvo 940 gl


Go to the following site and enter the make and model of your vehicle and it will give you a free diogram of the wiring to your stereo. The colors do not have to match up.

Apr 04, 2009 | Dual XDMR-7700 CD Player

2 Answers

Installing washing machine motor P/N 35-5022, need wiring schematic to hook up to machine internals


The black or brown connection block on the motor should be color coded to match the harness. If not you will need to remove the control panel and find the service guide sheet. This will give you the wiring diagram for the whole machine.

Jan 10, 2008 | Maytag Performa PAV2200

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

234 people viewed this question

Ask a Question

Usually answered in minutes!

Top Motorcycles Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75822 Answers

kakima

Level 3 Expert

102366 Answers

Are you a Motorcycle Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...