Question about 2004 Harley Davidson FLSTC - FLSTCI Heritage Softail Classic
Fuel pump going bad and want to change it myself
Posted by Anonymous on
Hi Anonymous, for more information about your question please visit the website below. Good luck and have nice day.
How to replace Harley Davidson fuel filter on Fuel Injected models Part 1
Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e
Posted on Jun 15, 2015
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
ON THE RIGHT SIDE JUST UNDER OIL TANK YOU WILL SEE A HOSE RUNNING DOWN TOWARD THE FRAME NEAR TRANS. THIS HOSE HAS A PLUG CLAMPED TO THE END OF IT OR STUCK INTO A PLUG THAT IS WELDED TO THE FRAME. UN CLAMP AND PULL PLUG, MAKE SURE YOU HAVE THE DIPSTICK OUT BEFORE PULLING LOOSE!
Posted on Jan 29, 2009
Set the alarm by holding the key fob button until you see running lights flash twice. Turn off the alarm by pushing the key fob button twice and the lights will flash once.
Posted on Aug 30, 2009
The oil drain us usually a hose with a plug in it that is held by a clip on the frame. It us usually on the right hand side of the bike just behind and underneath the transmission side cover. Loosen the clamp and pull the plug out. The oil will run out of the tank. Replace plug and add new oil to the tank.
Posted on Sep 24, 2009
The fork oil is a very specific job needing a manual and a special tool, I don't want to insult anyones mechanical knowledge but if you have never done it before, best to take somewhere else. Engine oil on the other hand is easy, the drain tube to any softail is on the right side by where the frame meets the swing arm, has somekind of plug in it. Start and run bike for a little while, long enough to get it warm but not hot. Remove fill plug and then remove plug in drain line. Using a peice of cardboard or something put in between filter and frame , directing the oil to your drain pan instead of where ever it goes. Put 1 qt oil back in (after everything is reinstalled) start the bike and make sure the oil light goes out, when it does shut bike off and fill to the point that when it is standing upright you get a little oil on the tip of your finger, over filling may result in loss of oil cap from pressure (been there)
Posted on Feb 16, 2010
Tips for a great answer:
Apr 04, 2017 | 2000 Harley Davidson FLSTC Heritage...
Feb 17, 2014 | 2006 Harley Davidson FLSTCI Heritage...
Sep 07, 2013 | 2004 Harley Davidson FLSTC - FLSTCI...
Jul 04, 2012 | 2004 Harley Davidson FLSTC - FLSTCI...
Apr 18, 2011 | 2004 Harley Davidson FLSTC - FLSTCI...
Nov 17, 2010 | 2004 Harley Davidson FLSTC - FLSTCI...
Apr 04, 2010 | 2003 Harley Davidson FLSTC Heritage...
Jul 17, 2009 | 2004 Harley Davidson FLSTC - FLSTCI...
Jul 09, 2018 | Motorcycles
189 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: