Question about 2005 Hyosung GT 250

1 Answer

2007 Hyosung GT250R CHOKING at top end

As long as I am contantly accelerating and breaking, city traffic, the bike is responsive and bad ***.  Once on the highway in 5th gear it won'tlast about 1 to 2 minutes before it begins to choke little by little until I've come to a complete stop.  Where can I control the amount of air to gas ratio, i think it might be getting too much gas when the throttle is all the way or close to all the way down for a long period of time.  This bike was bought after it had been without use for a couple of months, maybe a year.  Ive used about 3 to 4 gas tanks worth since I got it early december.  The first time I rode it in november i took it for a long ride to a dealer to have it checked and it made the trip there and back without this problem.  What could have changed?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    An expert whose answer got voted for 20 times.


    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 101 Answers

Hi ..... Lots of variables on this one. Pull the petrol pipe from the carb(s) and ensure you have a stong/steady stream of petrol. Remove the spark plugs and have a look at their colour, should be a light tan. The petrol tank has a breather hole near the petrol filler OR through the filler itself make sure this is clear and unabstructed.
Let me know how you get on.

Posted on Jan 02, 2009

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2012 Hyosung GT250 EFI lurches when going off throttle and then back on throttle. How to eliminate problem?

Hi, David my gut tells me it's a sensor issue (TPS or MAP) for this situation I would call my local dealer or reputable shop's service/parts department and inquire about any possible quick fix, answers, or parts inquiry. For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
2007 Hyosung GT250R Starving for fuel maybe
Uneven running
HYOSUNG GT250 FI Owner Manual
HYOSUNG COMET 125 Service Manual

Mar 14, 2017 | 2012 Hyosung GT 250

1 Answer

2010 Hyosung Gt250r carb flooding when I try to ride but idles good only on start up what's causing this?

Hi, Chris and the usual suspects are:
1. Dirt or other foreign matter between float valve and its seat.
2. Float valve sticking.
3. Float valve and/or valve seat is worn or damaged.
4. Float misadjusted.
5. Float cracked, leaky or damaged.
6. Excessive "PUMPING" of hand throttle grip.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
Why is the engine bogging under acceleration Suzuki FA50 Moped
will gv250 carbys fit gt250r
HYOSUNG GT250 FI Owner Manual

Feb 18, 2017 | 2010 Hyosung GT250R

1 Answer

No power to dash any ideas changed fuse worked once now nothing and fuse is still good

Hi, Brandon you may have a wiring issue check the connector that is at the end of the wiring harness from the instrument panel for corrode, broken or loose pins/blades for more information about your question and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
bike runs fine but NO dash
ignition key on but no lights on dash

Apr 24, 2016 | 2007 Hyosung GT250R

1 Answer

Why is my motor bike wont start baterry is ok its new but seems like my fuel is not flowing to the pump

have you checked the fuel lines to make sure they are not clasping and plus check fuel filter for a blockage and to make sure no vacuumed leaks to do with fuel

May 14, 2014 | 2007 Hyosung GT250R

1 Answer

08 hyosung gt250r starting issue

Hi, Ron and the usual suspects are:
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Discharged battery, needs to be 12.5 volts or better and be able to pass a "LOAD" test if necessary.
4. Check the battery terminals for damage or corrosion check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
5. Tip over sensor needs a reset.
6. Faulty ignition switch.
7. Faulty starter button.
8. Faulty kickstand or clutch pull in switch/sensor.
9. Starter control circuit, relay, or solenoid faulty.
10. Main fuse or circuit breaker may be blown or faulty.
11. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
Hyosung GT250R not starting
HYOSUNG COMET 125 Service Manual

Mar 15, 2017 | 2008 Hyosung GT250R

1 Answer

Hyosung GT250R Tacho not working

These bikes are never senen with many miles on them when for sale, invariably they have issues uncommon to a newer bike, this sis due to the workmanship and metalurgical issues etc, they are clones but thats where the similaritys end, they nevr last from all I ever saw of these bikes.
If you mean loses power on hills due to clutch slippage, the springs i know get weak fast and lose tension sufficient to engage fully thus allowing plates to slip and losing power to the rear wheel, if you mean otherwise nobody can tell you this way correctly.

Feb 25, 2012 | 2007 Hyosung GT250R

1 Answer

2011 Hyosung GT250R instruments keep resetting

Hi, Kingsley for this scenario you will need your service/owners manual if you can't find the first and best tool you ever bought for your Yamaha, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
Hyosung GT250R clock repair
HYOSUNG COMET 125 Service Manual
HYOSUNG GT 250 Service Manual
HYOSUNG GT 125 Manual

May 12, 2017 | 2011 Hyosung GT250R

1 Answer

I haven't started my bike in almost 1 year. The starter does not even turn engine. I replaced battery and lights work. No noise at all when I press starter.

i have a 2007 gt250r and had a similar problem, on the right side beside the battery between the fairing and the frame is the starter solenoid, you can test it with a test light by putting the clamp of the test light on one side then the light on the other side, hit the starter button if the light doesnt come on it is the solenoid, about $50 off ebay

Aug 10, 2011 | 2008 Hyosung GT250R

Not finding what you are looking for?
2005 Hyosung GT 250 Logo

311 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyosung Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers


Level 3 Expert

74206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22082 Answers

Are you a Hyosung Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides