Question about 2002 Yamaha YZ 426 F

3 Answers

Spark plug what type of spark plug should i run a YZ426 2002 model at. as i keep burning out plugs

Posted by on

3 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 77 Answers

Run a ngk CR8E-K defiantly its got twin electodes!! 

Posted on May 10, 2009

  • danny
    danny May 10, 2009

    I mean definatly not defiantly

  • danny
    danny May 10, 2009

    electodes?

×

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

  1. Recomended sparkplug (NGK CR8E),medium heatrange plug will operate well in a wide range of engine speeds.
  2. If bike is driven in hot climates,and engine works hard - A spark plug with a colder heat range is recomended.
  3. Bike used in cold climates and engine does not work hard use a spark plug with a higher heat range.

Posted on Jan 22, 2009

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

Have a look in the owners manual or i a workshop manual and somewere in there it will tell u the best plugs that should be put in the bike. if it continues in my experiences burnt out plugs means the engine is running to hot which means it is iver fuelling. if this is the case try turning the mixture screw down half a turn

Posted on Jan 01, 2009

  • Joseph S. Nagy Oct 06, 2011

    Just had it delivered from a dealer 165 miles away in Ebensburg, PA. Manual and extra key supposed to be on it's way. It appears the last owner used it heavily as a dirt bike and the dealer did little more than wave a rag over it. I'm not new to tearing down bikes, mostly Triumph and Bultaco back in the 70's. Had no problem figuring out where the filters and all were located, draining oil and removing rusty chain and drive gear and pulling oall the grass and red mud out of the drive . Figured I couldn't necessarily trust what plugs were in it and don't have the in the mail manual yet. I had NGK C6HSA plugs in it.

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Reasons why both spark plugs keep fouling on my 1993 1340 evo harley davidson


make sure you are running the correct plug and wires for your engine and that it is properly gapped. if your piston rings are worn, excess oil burning can foul the plugs. make sure the carb is properly jetted and/or the fuel injection system is properly mapped.

May 09, 2014 | Harley Davidson FXR Super Glide...

1 Answer

Wet spark plug


Spark plug gets wet because it's running too cold. Loosen plug and retighten only tight enough so it doesn't loosen from vibrations. Just a tad beyond hand tight is enough. This way the spark plugs heat is not dissipated to the cylinder head and run much hotter burning away any excess fuel deposits.

Apr 21, 2014 | 2010 Jonway GTS 500

1 Answer

KX60 stator coil values, keeps popping spark plug


burn out silencer packing or exaust leaks can burn a sparkplug , i guess your exaust system have lots of leaks that make the sparkplug fool and burn

Dec 18, 2013 | 2003 kawasaki KX 250

1 Answer

Keeps burning spark plugs and wont stay running


First, check you are using the correct plug, if you are using one that is too "Cold" it will burn out and cause running problems. If the plug is too "Hot" it can cause holing of the piston and erratic running. It could also be a mixture problem (fuel/oil) but try the plug first.

Aug 01, 2012 | Yamaha Motorcycles

1 Answer

My 1969 triumph bonneville keep burning sparkplugs ( every part is new )


Just so we\'re on the same page, by "burnt spark plugs", you mean the porcelain tip is white with no sooty or oily residue, right?



Could be the ignition is retarded too much (with will make an engine run hot)

Spark plug gaps that are too close will not fire lean fuel mixtures.

Wrong carb jetting/adjustment.



Here is a spark plug diagnosis chart:



http://www.atvriders.com/images/articles/sparkplug/sparkcolors.jpg



By "burnt spark plug", I\'m assuming you mean what the chart refers to as "overheating"

Feb 26, 2012 | Triumph Bonneville Motorcycles

1 Answer

I have 2007 suzuki intruder the front spark plug was replaced 3 times due to intermitant spark.Each time i check the spark plug no spark then replace the plug then spark then runs for short period the No 1...


Fouling of the spark plug makes the exhaust extremely hot due to the burning of the fuel mixture inside the exhaust pipe and the spark plug end turn to black, fouling of the spark plug may be due to too rich fuel mixture check the correct setting of the air valve.

Jul 10, 2011 | 2001 Suzuki VL 250 Intruder LC

2 Answers

I lost spark on 2002 honda xr250r any ideas i have changed stator and ignition control module


Make sure the kill switch is not the problem. It should make a circuit when in the on position. A burnt out resister in the spark plug cap can also keep the spark from happening. Also check that there are no broken wires in the wire harness.
If you do have spark but the machine doesn't run make sure that the valves are adjusted correctly.
IN: 0.10 +/- 0.02 mm (0.004 +/- 0.0001 in).
EX: 0.12 +/- 0.02 mm (0.005 +/- 0.0001 in).
Honda dirt models of this engine type will not run if the exhaust valve is set too tight.

Mar 26, 2011 | 2003 Honda Xr 250

1 Answer

2000 triumph 1200 , coils keep burning out ! could there be a short ? or over amp problem ?


check all the connectors, including the ones coming out of the stator.
fit new plug caps , if your using the old ones on the new coils, they can have a resister in them that can burnout and create high resistance, which can damage coils. make certain the spark plugs are correct for the model.
If you ever check for spark make certain there is a plug in each lead and it is grounded to the engine.

make sure the earth wires from the battery are good and there should be an earth from the frame to the engine

check voltage across battery (aprox values)
12.5v bike stopped
13.5-14v engine running

Jun 19, 2010 | 2000 Triumph Trophy 1200

1 Answer

81 yamaha xj 650 spark plugs fire when engine isn't running


If you are saying the bike still continues to want to run, (rough running I am sure ), after the key is shut off then the engine is "dieseling". Carbon buildup on the piston / valves/ cylinder head is getting red hot from running. The hot spot(s) serve to ignite the fuel much the same as the spark plugs would. Burn only premium gas, be sure the cylinder is clean and not caked with mud or such, and change to a colder spark plug like NGK BP-8es or BP-9es ( BP-7es is the stock plug ). This may keep the engine cooler and stop the problem. The only other way is to pull the head then de-carbon it and the pistons. While the head is off, re-seat the valves using valve grinding compound. Check out Babbitts for parts. Go to www.babbittsonline.com/parts/viewbybrand/parts.aspx Please rate my answer.

Feb 24, 2010 | 1981 Yamaha XJ 650

1 Answer

Keeps burning up spark plugs whats the problem?


If the plugs are black, too rich. Go smaller on the jetting. Make sure the air filter is CLEAN. Are you running a good oil at 32:1?

Dec 26, 2009 | Suzuki RM 250 Motorcycles

Not finding what you are looking for?
2002 Yamaha YZ 426 F Logo

451 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

mikeuk

Level 2 Expert

61 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1128 Answers

D. E. Hev

Level 3 Expert

1132 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...