Diagram for FLSTCI SWINGARM

First off the wheel will be offset. as well the belt will run on the outside edge of the pulley. It won't run in the middle. Just like if you rotate the wheel in reverse the belt will travel inward on the pulley and remain there until you run it forward again. It part of Harley's design. Also you can't really go off of the adjuster bolts as a guide. They tend to be different. Sometimes the covers just need to be forced away from the wheel too. If the adjustments seem correct then I would try re adjusting the covers or make sure they are spaced out right as well.

I’m happy to assist further over the phone at https://www.6ya.com/expert/robert_5bac37c3cb991fdb

Only Moto1 swingarms fit on them. Swingarms are specific to models.

There are no grease fittings on the swingarm bearing on your Softail. You must pull the swingarm to get to the bearings.

Steve

The wheel alignment is fixed and cannot be changed between the front wheel and the rear wheel. Also, different models of bikes may or may not have an offset between the front and rear wheels.

The only alignment that you have any control over is the alignment of the rear wheel inside the swingarm. It must run parallel to the swingarm. The way you get this is by adjusting the rear wheel to where the length of the adjuster bolts are the same on both sides of the swingarm when the belt is at the proper tension.

Good Luck
steve

Are you asking how to make a swingarm for a 1993 Fat Boy? If so, I would advise against doing this. These parts are specifically designed to meet certain safety standards. Unless you're an accomplished engineer, machinist, and welder, it would be better to simply purchase the rear swingarm. That's unless you want to build a custom swingarm in which case it's all up to you.

If you just are looking for an exploded view. You can view, look only at bikebandits.com. Can't print or save, just look. Hope this helps.

JP

You can see the parts microfiche at http://www.bikebandit.com/triumph-motorcycle-speed-triple-2001/o/m17577

Its at the back of crank box right hand side of bike attached to bottom of frame in a sprung clamp just before the softtail swingarm- black hose with a plug and hose clip