How do i get my change oil light to go out i dont have owners

I assume that it is the oil change hasn't been reset, or the oil pressure is still a bit low. Find the owners manual. Online or dealer...

You need an OBII scanner but... Autozone, Advance or any good auto parts store will reset it for FREE for you.

If the oil can light goes on, check the level in the crankcase by checking the oil dipstick under the hood. It may be low.

If it is at a full level, then the oil light may indicate low oil pressure. Change the oil and filter to see if the condition improves. If it doesn't, then the oil pump may be bad. One can test the pressure of the oil while the engine is running by putting a gauge on the area where the oil pressure sending unit is, and reading the value to see if it is within specifications.

Good luck on this repair.

Many times this light will come on when the oil needs to be changed.If oil has been changed recently the light may have not been reset at the time of service so the computer doesn't know when the oil was actually changed.

The link below is a free online owners manual for your car. Page 290 shows the grade of oil to use. Page 291 shows the viscosity of oil to use at various outside temperatures. Hope this helps...

http://www.autoownermanuals.com/manuals.item.2818/Nissan-Murano-Owners-Manual-2005.html

4 quarts including filter change. After filling, let settle and check dipstick.

This should only be indicating time for an oil change. Now, if the red, check engine light comes on, then you have an oil/engine problem.

Possibly the maintenance light wasn't reset when the last change was done. If you don't have the owners manual to check, I found a referenced method (below) to reset it through AMSOIL synthetic oil products. Good Luck

To reset Engine Oil light. Turn the ignition key to RUN with the engine off. Fully press and release the accelerator pedal three times within five seconds. If the Change Engine Oil light is flashing, the system is reset. The light will flash for up to 30 seconds or until the ignition is turned off. If the light comes on again and stays on for 30 seconds at the next ignition cycle, it did not reset. You will need to reset the system again.

You need to put the key on and push the gas pedal to the floor three times within five second to reset the oil life light.Some g.m.'s have a reset buttom in the fuse panel that needs to be pushed first and some don't.Check the owners manual under change oil for your specific year car.

it probably was not reset when oil change was done last .here is how to reset turn key on press gas pedal to the floor three time with in five seconds then wait ten seconds and start car it will go off.please rate this answer thanks

well, it is in the manual under engine oil. turn key to on, dont start. press gas pedel to the floor "slowly" 3 times within 5 seconds. if the change oil light flashes, its resetting. If not, repeat.. this worked for me.