I have changed the oil on my 2002 wr426f after letting it stand for two days and simply replaced the amount that came out with the same amount of fresh oil... 1600ml... is this procedure ok?
You may have this
posted in the wrong product category. Please select another category
appropriate to the problem and re-post the problem so the correct
expert will see and respond to the question..
This is for
car and truck problems.
What is a wr426f? We are in USA north america
What you said about changing oil on anything,
makes no sense
Oil drains in about 10 min
You refill a car,air compressor or any product
with the correct oil & correct amount
You wouldn't change any oil on anything without
knowing how much goes in or how to check
the level
So Explain this
SOURCE: resetting the mileage readout for changing oil, brakes, etc.
if this is a 2006 or old sprinter....turn the key on...push the button that changes the reading from odometer to trip to sevice interval ....til interval shows...turn key off...push button and hold it....while holding button turn key back on....hold it til interval resets
SOURCE: 1st time changing oil filter on v6 2008 rav 4,
I just changed my oil on my RAV4 V6 and the first thing is you are not looking for the regular canister but a oil housing like on the old farm tractors. You just replace the inside filter cartridge. The canister is in front on the engine on the passenger side. Use a 3/8 socket to open the bottom and drain. Next use a oil filter cap wrench to remove the housing. Actully this is a less messy than my chevy and more "green."
SOURCE: reset oil change reminder procedure
Press the "step" button until the oil change interval comes up then press and hold "reset"
SOURCE: oil change light stays on after oil change
1. Turn ignition switch on but don't start the engine. Push ENG MET button on the trip monitor ONE time.
2. Press ENG MET one more time within 5 seconds. Within 5 seconds press and hold the RANGE button (90-94) or the GUAGE button on 95 Vettes, you will see the light start to flash
3. When light stops flashing the CHANGE OIL LIGHT has been reset
SOURCE: simply replace spark plugs - procedure?
pretty simple just screw them out and replace them you may need an extention with a swivel but you shouldnt have any major problems, remember to always hand start the plugs in the ports before using a wrench to ensure they are properly threaded.
78 views
Usually answered in minutes!
×