Question about 2005 Yamaha TT-R 125 L

2 Answers

Carburator leaking gas out of over flow tube

2006 yamaha when gas is turned on leaks out of carburator through over flow tube

Posted by on

  • wozzman Mar 17, 2009

    I have a 87 Kawi Vulcan that ran fine in november and now gas is pouring out of the overflow when it runs,,is there any cleaner that i can add after draining the tank and putting in fresh gas ?any kind of cleaner that would free up the floats?i have tried to tap on them but that dosent make a diff

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

Sounds like a stuck float. try gently tapping on side of carb near bottom where float assembly is located to see if it frees up if it doesn't you will need to remove and clean your carb and check your float adj.

Posted on Dec 28, 2008

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 101 Answers

Hi .... Switch off the petrol at the tank stopcock/petrol tap. Using the correct sized screwdriver unscrew (anti-clockwise) the screw in the float bowl of the carb (it's the one at 45 or 90 degrees) ......... petrol, water & possibly debris will come out. If you place a plastic tin cap underneath you'll be able to see what comes out, do this in a well ventilated area with NO naked flames. Re-tighten screw, switch on petrol and see if OK. Let us know how you get on.

Posted on Dec 28, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ii cleaned my injectors on my 2006 Yamaha V-Star put it all back together bottom right scrw is leaking gas how to stop it


Hi, Peggy you may have forgotten to install or cut an o-ring or bowl gasket during installation for more information about your question and valuable "FREE" downloads that you will need please click on the websites below. Good luck and have a nice day.
Yamaha Star Carburator Cleaning
Carbs leaking Here is how to fix it
http://www.starmotorcycles.com/assets/service/manuals/2003/LIT-11626-16-05_22.pdf
OEM parts for Yamaha
http://s.productreview.com.au/products/manuals/32141_563ae9ef16ab5.pdf

Apr 10, 2016 | Yamaha Motorcycles

1 Answer

How to remove the carburator on my 2001 v star 1100 classis?


Need to take off the fuel tank and after intake system from carboretors

Aug 31, 2014 | 2001 Yamaha V Star 1100 Classic

1 Answer

Carburator leaking gas out of small hole in bottom of bowl


Hi, Anonymous and the usual suspects are:
1. Damaged or restricted fuel tank venting system.
2. Loose float bowl screws.
3. Damaged float bowl o-ring.
4. improper fuel level in the float bowl.
5. Worn or dirty inlet valve or seat.
6. Damaged or leaking float assembly.
7. Particle contamination in inlet fitting cavity.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have nice a day.
Carburetor Carb Leaking Gas How to Fix Repair it Motorcycle Honda DIY...
Carburetor is leaking gas out of overflow tube need help
YAMAHA YZ125 Owner Service Manual
OEM parts for Yamaha
http://mybikemanuals.com/yamaha/yamaha-yz-owners-manuals

Dec 21, 2013 | 2003 Yamaha YZ 125

1 Answer

I have oil coming through carburator. Is there a vacuum line cloggedor what?


Check your oil level. If your vacuum petcock or float bowls are over flowing gas into the engine, your oil is diluted with gas, the crankcase is too full, gasoline diluted oil is blowing through the breather tube into the air box, and from the air box into the carburetor. Needles sticking in the carburetors can happen at any time even to new motorcycles. If you have vacuum petcocks inspect the vacuum diaphragms for leaking. Clean the carburetors and replace the float needles if they show wear. Change the gas fouled oil and filter. Hope this helps.

May 08, 2011 | 2003 Yamaha V Star 1100 Classic

1 Answer

Gas began running out of the tube that exits the top of the carburator on the Yamaha TTR-50. So much gas that I had to use a gas can to put the excess gas into. It appeared to be leaking from the...


hi,sounds like the float in the carb is stuck in the fully open position,you will have to take the carb out,take the bowl off the bottom of the carb and inspect the float needle assembly,the little clip that holds the float to the needle valve may have come off,allowing fuel to run unchecked into the carb and ultimately out through the overflow..hope this helps..cheers

Mar 09, 2010 | 2003 Yamaha TT-R 125

1 Answer

I have a 03 Yamaha 660 raptor one of the carbs


Did you reset (adjust)the float inthe float chamber to tht carburator which is leaking ?
You will probabley have to adjust tht float to stop from overflowing in other words we call it flooding.
Check the float pin of wear at the tip.
Hope this helps!

Mar 02, 2010 | 2003 Yamaha TT 600 R

1 Answer

I have a yamaha ttr 125 L that was given to me. When I turn the gas on, it leaks gas from the yellowish line coming from what I think is the carburator. I am not a mechanically inclined person and don't...


What you describe is correct. EIther the floats in the carb are sticking up and allowing gas to flow, or the air/fuel ratio screw on bottom of carb is turned up to high. If it just started, then floats are stuck or set to high.

Oct 28, 2009 | 2002 Yamaha TT-R 125 L

2 Answers

2000 yamaha ttr90 fuel leaking out overflow tube


your float is stuck take carburator off and clean wiggle float and it shouldnt leak gas anymore

Apr 04, 2009 | 2002 Yamaha TT-R 125

1 Answer

Motorcycle leaking gas from an unknown tube.


sounds like you got a cracked gas line or it needs a clamp on it,1.if it a line running from each carb. that is the overflow lines.2.if its one big one coming from the breather box it is a catch holes, and you open it to let whats in it run out.

Mar 27, 2009 | 1985 Yamaha FZ 750 FN (Europe)

1 Answer

Float hieght for 1984 IT 490


not sure of the exact height, but if you hold the carb level with fuel hose attached and pushing float up with finger, turn on petcok and slowly lower the float until it is just above horizontal. at this point, gas should start to flow out of the needle & seat.

if float turns off gas too soon, then engine will starve.

if float doesn't turn off gas, then it will flow out of the carb overflow tube.

Mar 14, 2009 | 1974 Yamaha DT 360

Not finding what you are looking for?
2005 Yamaha TT-R 125 L Logo

1,729 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1128 Answers

D. E. Hev

Level 3 Expert

1059 Answers

mikeuk

Level 2 Expert

61 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...