Question about 2005 Harley Davidson FLHTCUI Electra Glide Ultra Classic

2 Answers

Wireing tempature gauge

How do you wire a outside temp gauge to the senser on a 2007 harley davidson ultra classic

Posted by on

  • 4 more comments 
  • Tom Diffin May 11, 2010

    the air temp guage i belive is self contained no external sensor ( on my 2002), at least the one I removed to replace with oil temp guage didnt have one, the oil temp guage is the better option if its warm or cold you dont need a guage to tell you but oil has to get 190degsF to work right (moisture turns in to steam at that temp) and all aluminum engines make moisture at warm up I tell all our custs try not to take
    short rides if posiable short rides mean short oil, and engine life

  • Tom Diffin May 11, 2010

    are we talking about the air temp guage or oil temp

  • Tom Diffin May 11, 2010

    are you talking about air temp or oil temp

  • Joe Stanton Apr 13, 2013

    Why Would You Need A Air Temp Gauge.Mass Air Flow Sensor Is Going To Adjust For Ambient Temp.

  • Anonymous Mar 22, 2014

    bulbs appear ok fuses ok

  • Anonymous Mar 29, 2014

    Part number 2005

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 1 Answer

Outside temp sensor located at inner fairing, it is tied to left fairing frame just above cigarette lighter.
On OEM parts,
Air Temp Gauge pin#1 = Orange +12 Volt
Air Temp Gauge pin#2 = Black - ground
Air Temp Gauge pin#3 = Air Temp sensor pin#1

www.bengkelsepedamotor.wordpress.com

Posted on Jan 05, 2009

  • Joe Stanton Apr 13, 2013

    Still Its Somthing You Dont Need To Monitor With A Gauge.

  • Joe Stanton Apr 13, 2013

    When You Ride By A Bank You Will Know What The Temp Is Allowing For Wind Chill And Speed.

×

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that gotĀ 5 achievements.

    Habit-Forming:

    Visited the website for 3 consecutive days.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 55 Answers

Bad Idea. It Could Fault The Computer. Best Bet Would Be To Install A Temp. Guage Oil Filler Cap. It Would Be More Indicative Of Engine Temp With Out Effecting Computer.

Posted on Apr 12, 2013

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to fix fuel gauge on 2002 ultra classic harley davidson ?


Check your wiring first as it sounds like a short or it could also less likley be a sender or a gauge problem. Check for DTC's first though.

Jul 06, 2014 | Harley Davidson FLSTF Fat boy Motorcycles

1 Answer

2005 harley ultra classic voltge inoperative


All four gauges are wired using common supply and ground connections. Oil, Voltage, Temperature and Fuel. If two gauges are not working and stopped at the same time, then I would start by removing the outer fairing and checking the wiring harness. If gauges stopped working at different times, then it is likely either the senders have gone faulty or the gauges themselves.

Jun 12, 2014 | 2005 Harley Davidson FLHTCUI Electra Glide...

1 Answer

2007 Ultra Classic - Tour pack removed. Blows tail


Hi Anonymous, you have a hard/dead short that should be easy to find generally they are the easiest. Time to get out your test light and start tracking the wire from the power side of the blown fuse receiver, when the test light quits lighting you are very close to your short. For a free wiring diagram please visit the website below and good luck. Harley Davidson Wiring Diagrams and Schematics

Oct 22, 2013 | Harley Davidson Motorcycles

1 Answer

Wiring harness for starting system 2007 ultra classic


Hi Anonymous, for more information about your question please visit the website below. Good luck and have nice day.
Harley Davidson Wiring Diagrams and Schematics

Jan 22, 2013 | 2007 Harley Davidson FLHX Street Glide

1 Answer

Harley fairing wiring diagram


Hi Jim, for a free wiring diagram please visit the website below and good luck. Harley Davidson Wiring Diagrams and Schematics

Oct 12, 2012 | 2005 Harley Davidson FLHTCUI Electra Glide...

1 Answer

Fuel gauge is stuck on full on 2005 harley davison ultra classic


Hi Anonymous, always check your instrument fuses first also you could have a faulty sending unit or guage, there could be a problem with your wiring. On models with the fuel gauge posing as a left hand fuel cap the gauge is a press fit do not try to unscrew it, simply ample force lift up in a rocking motion to remove gauge. Disconnect wires to the gauge and with a set of positive and negative jumpers from the battery connect the positive jumper and flash the negative, gauge should peg full, if not replace gauge. With a test light check for power to the sending unit, then remove the sending unit and manually operate the float arm slowly with the correct wiring hooked up to the fuel gauge and sending unit and the ignition on, the gauge should respond accordingly if not replace the float arm assembly. For a free wiring diagram please visit the website below. Good luck and have nice day.
Harley Davidson Wiring Diagrams and Schematics

Apr 09, 2012 | 2000 Harley Davidson FLHTCUI Electra Glide...

1 Answer

Wiring diagram 2007 ultra classic


Hi Anonymous, for a free wiring diagram please visit the website below and good luck.
Harley Davidson Wiring Diagrams and Schematics
Have a nice Harley day

Jan 16, 2012 | 2007 Harley Davidson FLHTCU Ultra Classic...

1 Answer

No brake lights or turn signals on te rear of a 2007 Harley ultra Classic


Hi Mike, always check the bulbs first for broken filaments. Then check the connection at the rear fender wiring harness, inspect for corroded, broken or loose pins. Use a dab of dielectric grease and repair as necessary. Check your brake relay if you have one , some models rear turn signals were single filament bulbs only, no running light. If all else fails get out your test light and start tracking the power wire from the harness connection. For a free wiring diagram please visit the website below and good luck:
Harley Davidson Wiring Diagrams and Schematics

Sep 24, 2011 | 2007 Harley Davidson FLHTCU Ultra Classic...

Not finding what you are looking for?
2005 Harley Davidson FLHTCUI Electra Glide Ultra Classic Logo

631 people viewed this question

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4497 Answers

Gills Lango

Level 2 Expert

195 Answers

Mike

Level 3 Expert

4332 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...