I have a problem with the front left turn signal, when I turn it on the rear and indicator lite super fast , I tried a bulb replace no good the bulb is good works fine in other sockets,i checked inside the housing its ok clean and dry. if I pull the bulb and leave only the rear in it blinks but if I pull the rear and try it with only the front bulb in i get a loud buzzing noise.Any suggestions to what my problem is and how I can correct it ? Thanks
Having the same issue!? Has anyone figured this out!?
I own a 2006 Triumph Speedmaster,,,all the lights work with exception when I turn the right turn signal on the front light doesn't come on and the flasher clicks a lot faster? Change the bulb same thing....any helpful advice...
Sounds like you should check and clean the contacts on bulb holder and bend them just a little to insure that they are making good contact with both parts of the bulb. Before replacing bulb turn on indicator and put a d. c. voltmeter on both contacts of bulb holder.12 volts should be measured intermittently. If not then suspect a broken wire or connection further back.
SOURCE: speed 4 electrical problem
sounds like you've blown a fuse when the relay packed-up!!! The Fusebox is under the seat, it's next to the battery on the left-hand side (as if your sat on the bike), the 10amp fuse in position 4 protects the horn, indicators, stop light, instrument memory and diagnostics. You'll have to buy a new fuse 'cos the spares in the fusebox are 20 and 40amps!
SOURCE: Engine does not start
JUST A SHOT IN THE DARK ON THIS.
TRY DISCONECTING THE POSITIVE POWER CABLE ON YOUR BATTERY,AND WAIT TEN OR TWENTY MIN.THEN PUT THE POSITTIVE BACK ON IT.
SEE IF THAT WILL RESET IT.
HOPE THIS HELPS
ELLIOT NEACE
SOURCE: turn signals are not working, need a wiring diagram for triumph
Check the fuses and the connections on the wiring harness. Trace how far the power goes. Where it stops is the problem.
SOURCE: Can't start my Triumph tiger 955i 2005
let is sit for a day and dry out. you probably got moisture into the spark plugs, or the distributor, or the wires. if you have a battery charger, charge the battery while you are waiting.
SOURCE: 2001 TRIUMPH TT600 SIGNALS DON'T WORK..WHY????
If these are LED lights, they tend to use more of a load on the relay. Try to get a new relay with the same prongs and ratings, but for a truck. These tend to accept more power because trucks sometimes use trailers, which would have to power more lights than usual. Give it a try. About a $10 fix.
ride smart.
Tim
1,006 views
Usually answered in minutes!
If I am missing some info that might help diagnose the problem feel free to ask?
×