Question about 2006 Harley Davidson FXDI35 35th Anniversary Super Glide

1 Answer

Oil change how do you drop the oil

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 28 Answers

Remove the bolt on bottom of engine to change oil

Posted on Dec 28, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

00 lincon navigator 5.4 oil pressure drop's low and light comes on , engine idles rough when pressure drops ,then pressure return s to normal range ,light goes out ,engine runs perfect. Is it my oil


Sounds more like an engine idle issue than a oil pressure issue. If the engine idle drops too low, the oil pump cannot provide sufficient oil pressure. If there is no oil light when the engine is idling normally, then there is no problem there.

Dec 25, 2014 | 2000 Lincoln Navigator

1 Answer

Why is my 2007 envoy denali oil pressure dropping?


check oil level in sump. You may have to remove the sump to check for cracked oil pick up line . Check oil pump pressure regulator . replace oil filter as it may be blocked and dropping the oil straight back to the sump.

Mar 14, 2014 | 2007 GMC Envoy Denali

1 Answer

Why is oil pressure gauge dropping below 40 psi.


Usually two reasons why oil pressure drops over time,worn engine parts,old oil.Try an oil change with new filter I sometimes use an additive like Restore.Over time the oil will become thinner and less viscous leading to a drop in oil pressure.

Feb 05, 2014 | 2005 Chevrolet Chevrolet Avalanche 1500 LS

2 Answers

While i was doing off road driving a warnning light (a/t oil temp) turn on, i looked underneath the car and i found oil leak drop after drop, not too sure now should I change the transmition oil and filter...


Change the transmission fluid and filter. The light says fluid temp. is high, so you may have some burnt fluid-deadly for transmissions. Drop the trans. pan and look for metal shavings-too much will indicate failure of transmission parts. If not too much, you may be alright with fluid and filter change.
Stop the leak,. make sure it is trans. fluid, not motor oil. If motor oil, stop the leak and change oil and filter. I would do the transmission regardless, since the light came on.

Aug 29, 2013 | Cars & Trucks

2 Answers

Oil pressure drops after worm up


let vehicle reach normal operating temp. remove oil pressure sensor replace with manual oil press. gauge run engine and monitor oil pressure go from there dependent upon findings

Mar 17, 2010 | 2000 Jeep Grand Cherokee

1 Answer

Check gages light turns on and doesn't go off. Already had the oil changed, the oil pressure needle keeps marking 0. It had the same problem once but I changed the oil and kept working fine; then about 2...


At this point I would strongly suggest that you have your mechanic hook a mechanical oil pressure guage to the engine and make absolutlely sure that the pressure is up to manufacturers standards. It may simply be a failing oil pressure sending unit, but, until you know, it could turn out a lot more expensive! Thank you, Dana

Jan 06, 2010 | 2001 Jeep Grand Cherokee

1 Answer

Oil pressure gauge shows low / high / middle changed sensor did


Hello mb4494: My name is Roger and I will help you. If by changing the oil pressure sending unit the problem did not change. I would perform a oil pressure test. This is done by removing the oil pressure sensor and inserting a oil pressure gauge. This can be done by yourself or by a repair shop. This needs to be done on a cold engine. Start the engine and observe the oil pressure cold.as the engine warms up observe the pressure. The pressure will drop off as the engine warms up.Should the oil pressure drop below 10 to 12 PSI. then you have internal engine trouble. More then likely a bearing problem. Try dropping the truck into gear and see what the pressure drops off to. Again if the pressure drops below 10 to 12 PSI. you have a problem. I would also check to make sure you have the correct oil switch. a truck with a oil light uses a oil pressure switch. with a gauge you would use a oil pressure sending unit. Sorry for the long reply but want to make sure you check the pressure correctly. Please rate the quality of the answer as this is how we know the answer was correct. Thank You for using Fix Ya. Roger

Jun 16, 2009 | 2004 Ford F150

1 Answer

OIL PRESSURE SEEMS TO BE GETTING ALITTLE WORSE IN BETWEEN OIL CHA


this all sounds normal the reason your pressure drops is because the oil breaks down between oil changes with that kind of mileage all is good

Apr 07, 2009 | 1998 Buick LeSabre

1 Answer

1998 camaro oil pressure drops


no oil on ground oil still full but after it runs for a few minutes oil pressure drops

Aug 31, 2008 | 1998 Chevrolet Camaro

Not finding what you are looking for?
2006 Harley Davidson FXDI35 35th Anniversary Super Glide Logo

Related Topics:

122 people viewed this question

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Gills Lango

Level 2 Expert

195 Answers

Mike

Level 3 Expert

4336 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...