At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
I have a problem smoging a 96 Mercedes C220 Because "vehicle requires completion of monitors" I take the car to a Mercedes dealer and they dind't find noting wrong bad they not able to smog the car PLEASE HELP
Battery should be in the trunk, under the mat next to spare tire on the right side. The starter is in the engine compartment on the underside near the firewall (very close to the accelerator pedal, think: if you could put your foot through the floor with the accelerator while sitting in the driver's seat, you would end up kicking the starter). Not fun to get at from under the car! (which is the only way to get to it :(
93-95 Mb was forced to use biodegradable insulation on its wiring in there cars by the US. Try looking at the engine wiring harness because they can short out. Also the Throttle assembly has the same wiring, it would cause all those problems.
This can not be reset by conventional methods. This must be done through a scan tool. Usually only the dealer scan tool will communicate with the SRS module. If the SRS light is on you have other issues and they must be remedied before the light will go out. There is no way of knowing what the issue is without running codes with the scan tool.
check your harness wire. Check if the wire coating is brittle then you have to change it. The original harness has a lifespan so what we did is to replace the wirings one by one with a japanese made wires that wont get brittle. More durable
check your main harness wire. The harness wire becomes brittle and will eventually short circuit your car. Stalling and hard starting is the initial symptom. If not replaced soon, your car will smoke and eventually affect your computer box
changed different sensorscrank and different air sensors mechanic had it numerous times it works 4 a while and then stalls while driving and won't start fed up 94 c220
×