- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The 2kd engine has same torque settings whether it goes on a hilux, or srx or other. The minimum diameter specs are: 11.6 mm for head bolts, and 12.6 mm for main bearing bolts. http://www.auto-searchphilippines.com/files/Toyota_innova_E_Specifications.pdf
1. Position the flexplate onto the crankshaft and install the bolts hand tight. 2. Tighten the flexplate retaining bolts to 95 N·m (70 ft. lbs.) in the sequence shown. 3. Install the transmission.
Fig. : Cylinder head torque sequence, 260, 307, 350 403
Oldsmobile built engines
On the V8, tighten the bolts, in the sequence illustrated, to 100
ft. lbs. When all bolts have been tightened to this figure, begin the
tightening sequence again, and torque all bolts to 130 ft. lbs.
On V6's, tighten all head bolts in sequence to the following
torques: * All except bolts 5, 6, 11, 12, 13 and 14 - 100 ft. lbs.(19-135.5
Nm) * Bolts 5, 6, 11, 12, 13, and 14 - 41 ft. lbs. (19-55.5 Nm) * All bolts except 5, 6, 11, 12, 13, and 14 - 142 ft. lbs. (19-192.5
Nm) * Bolts 5, 6, 11, 12, 13, and 14 - 59 ft. lbs. (19-80 Nm)
The neutral witch is behind the clutch and as long as it is switched on the bike will not run unless you defeat the kickstand switch.
I really recommend properly repairing the neutral light switch because taking off with the kickstand down can put you down on the pavement way too easily.
×