Question about 2007 Husqvarna SM 125 S

1 Answer

Crank case oil husqvarna wr125

Does any one know what weight of oil goes in th crank case? any help would be much appreciated. thank you.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I would run AMSOIL For immediate answers to your technical questions call: 1-715-399-TECH (8324) between 8 a.m. and 5 p.m. Central Time.
You should be able to get your answers there My guess is it will be there 10w-40 advanced synthetic which is what I use

Hope it helps Bill

Posted on Dec 15, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

WHAT IF I PUT GAS WHERE THE OIL GOES


if you mean where the chain oil lube goes then you could have a fire if any sparks occure ! If its where a seperate 2stroke oil feed should be then you will not lubricate the engine internals and sieze the engine ! Just drain out and fill with oil , 2stroke will need to be bled on the side of oil pump !

Jul 05, 2014 | Husqvarna "Chain Saw - 16" Bar, 3 Hp

1 Answer

What is the oil/fuel ration for a Husqvarna model 234 e chain saw? I recently purchased the saw new, but only the instruction manual to assemble the case was enclosed. Thank you. Don


With Husqvarna two stroke oil it should be 50-1, with other manufacturers two stroke oil it is 25-1 as we do not know the quaility of other oils, always try to use Husqvarna oil.

Jul 29, 2011 | Husqvarna Garden

1 Answer

Re 2006 Husqvarna WR125 - I want to top up the fork oil, have the measurements and oil but unsure what to open to add oil. Help.


well first of all,,,,,you dont just top up the fork oil,,,,
you drain it all out and refill it with clean fresh oil....
the reson for this is,,how much oil is left in the forks?
if you over fill them with oil you will burst the top fork sead?? bad news that is! so find the drain plug (a nut or screw) at the bottom of each fork leg and drain all the old oil out first,,, then remove the fork top plug and tip in the right amount of the right grade of oil into each leg,,,then let it stand for a fuw minuets,,for the air to come out,,,do up the fork top plug and push the forks down a fuw times before riding it to spred the oil around inside the forks,,,oh,,by the way,,,change the fork oil yearly,,,,,

Jun 26, 2010 | 2006 Husqvarna WR 125

1 Answer

Possible seal failure


Gearbox oil may be getting into the crank area. Check the oil in the crank, is it motor oil or two stroke oil? If it is motor oil then you will need to split the center case and clean/re-seal the case halves. Be sure to install new crank seals. New crank bearings? If 2 stroke oil, just put a cup of gas in the crank to thin the oil, rotate the crank a few times to mix gas and oil, then just tip the bike over to dump the mix out of the case. If the bike has an oil pump, see if you can lessen the stroke of the pump. If mixing 2 stroke oil in the gas tank, Be sure to use only 2 stroke engine oil at 32 to 1 ratio. That equals 4 ounces of oil to a gallon of gas.

Nov 18, 2009 | 2000 Husqvarna WR 250

1 Answer

Need carb settings for a Husqvarna wr125 1999 model


Main Jet 400
Jet Needle 6DJ8-60
Jet Needle Groove - 3rd
Pilot Jet - 35
Idle air screw - 1+1/2
Slide 3.0

Free manual here... http://safemanuals.com/user-guide-instructions-owner-manual/HUSQVARNA/WR%20125-_M

Aug 04, 2009 | 2000 Husqvarna WR 125

1 Answer

Wiring loom diagram - WR125 2000


see yamaha dealer, or probs best bet- clymer manual off ebay (£20ish)

Jul 12, 2009 | Husqvarna WR 125 Motorcycles

4 Answers

Missing bobbin case and bobbins Husqvarna 4000-serie sewing machine


ask where Husquvana machines are sold. google dealers if you don't know.

Oct 24, 2008 | Husqvarna Sewing Machines

Not finding what you are looking for?
2007 Husqvarna SM 125 S Logo

Related Topics:

285 people viewed this question

Ask a Question

Usually answered in minutes!

Top Husqvarna Experts

Gino Cussen
Gino Cussen

Level 2 Expert

216 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

venugopal durairajan

Level 3 Expert

464 Answers

Are you a Husqvarna Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...