I checked all the fuses
Test the brake light switch located at the brake pedal, disconect the switch & bridge the wires, turn ignition on if you have lights its a faulty switch (very common on ford falcons) if not check you have power at that plug, if power check the globes cause you could have blown globes as they are twin filiment globes (1 globe but 2 lights tail & brake) & the brake filiments might be blown.
SOURCE: 2001 dodge neon tail lights inop
looking at your schematics and , you say tail lights don't work , you didn't mention if front parking lights and license plate lights are working , they all come from the same source , a black /yellow wire , a good clue if front work and rear don't , please advise .if fronts work then you have a open circuit somewhere between junction S118 (near breakout for left headlamp) and rear sockets.
SOURCE: 94 toyota previa brake lights not illuminating
CHECK THE BRAKE LIGHT SWITCH UNDER THE BRAKE PEDAL
SOURCE: 2001 ford explorer sport trac
Just found the answer on another site. Sure enough went out removed the 3 philips head screws in the steering column opened it up and walla a wire connection had pulled itself free. When my son uses my truck he always uses the tilt steering, when I get in I have to readjust it. because of this the wire connection pulled itself out. I simply pushed it back in an blinker and brake light are now working. My husband is now trying to figure a way to secure the wire connection so it doesn't pull itself out again. Hope this helps others, either by saving the cost of a dealership or machanic or from getting rear ended.
SOURCE: Right brake light out; tail light works fine
most rear tail lights and turn/stop lights are the same dual filiment bulb. it is possible for your tail light to work and your brake light not to and still have a bad bulb. I would check the bulb first, your brake light works on the left yes? this would mean that the fuse is fine
SOURCE: brake lights won't work. tail lights do. I
need to know if your third brake light up high is working or not.if it isn't,you need to check the brake light switch on the brake pedal with a test light,one side hot all the time,the other side should turn hot when brake pedal is pushed.
390 views
Usually answered in minutes!
×