Question about 1989 kawasaki GPX 250 R

1 Answer

Hoses on a 01 gpx250

I need a photo of the gpx250 hose setup because i rebuilt the bike completely and it took me nearly a year to getting around to finishing it but i cant find were a clear possibly fuel hose goes and the small hose off the bottom radiator hose..

Posted by on

  • Graeme Ross
    Graeme Ross May 11, 2010

    Hi Beej2

    Do you have a workshop manual for the bike? I have a link to one for free is you want it?





1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 1,512 Answers

Hi again

Have the link for the manual to get your problem solved. here

you may need to register at the site first to get the download.

The hoses should be colour coded(I hope your still are) and are easy to get mixed up without a decent diagram of the setup. Check page 1.10 for the fuel and emission hoses.


Posted on Dec 07, 2008

  • Graeme Ross
    Graeme Ross Dec 18, 2008

    Hi again...Did you get the manual OK? 

    I had checked myself, and it has very easy to see diagrams for all hose connections. Wondering why the low rating for this hard to find information for you? I have certainly given you the solution to your problem. 

    Have a Merry Christmas.

  • Graeme Ross
    Graeme Ross Dec 28, 2008

    How did you get on, any updates? 



1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My Yamaha YBR 125 2007 not starting, it been standing for 2 years, I have cleaned tank, all hoses, filter, fuel injector.

Hi sounds like your nearly there ,try swapping hose around ,I once mixed the in and out ,next did you take the carbs apart and clean ,also a small shot of wd 40 in to the fuel pump without hose connected then pour out ,from what I read sound pretty good kid best of luck

Apr 12, 2014 | 2007 Yamaha Ybr 125

1 Answer

Engine oil leak after a rebuild

take it back to the shop that rebuilt it...tell them/show them.... they should fix it...

Jul 22, 2017 | 2005 Honda CRF 250 R

1 Answer

2005 Jeep Liberty 3.7L overheating

it's overheating, for sure,
is coolant levels dropping? cold checked at rad cap?
"pulled over and found a hose to cool the radiator and hose near the thermostat,"
i can not understand this statement"above"
if it overheat only parked, check fan for full ops.
if overheats moving too, wont stay cool moving fast
bad rad cap
bad thermostat , they have 7 year life says STANT. (and why)
belts slipping (to water pump)
rad cores blocked (IR thermo gun it) ask
water pump impellers rust 1/2 gone?

all this assumes no coolant loss, if you have loss, tell where.,
where it leans
passengers toes (foot well)
engine oil pan? milky oil
if A/T TRANS, check it for milky too.

Mar 17, 2017 | 2005 Jeep Liberty

1 Answer

1999 Yamaha Kodiak Front Disc Brake - Rebuilt master cylinder with new parts. Replaced orings on piston in front caliper and bleed brakes using new fluid. The piston will not retract. What is proble

The brake hose is clogged. When under pressure from applying breaks, the piston is forced tight to the rotor. When released the fluid will not return through the hose because there is no real pressure. Replace the hose.

Jul 31, 2012 | Cars & Trucks

1 Answer

Gsf1200k6 bike stored for 3 months now has a misfire also making strange clunk noise every now and then at idle bike has traveled 30,000km

I have just rebuilt the carbs on my buddy's Bandit 1200 that had a similar problem. After doing the initial checks to confirm it was not plugs, wires or coils and doing a compression test it came down to the carbs. After removing them and taking the float bowls off I found lots of small rubber pieces in the bowls. This could only have come from the rubber fuel hose, from tank to carbs, as there is a filter in the fuel valve in the tank and that was clear. The small rubber pieces had blocked off some of the jets. Apparently Suzuki recommends replacing that hose every two years. I suspect alcohol in the fuel was eating the inside of the hose.
i am not saying that is the same problem you have but something to keep in mind. If it had not been stored with fuel stabilizer in the tank I would drain the fuel and add fresh gas and then if the problem persists do the basic tests first before going further.

Jan 10, 2018 | 2005 Suzuki GSF 1200 Bandit S

1 Answer

How do I configure the gas hoses on the Hyosung GT250R

I have this exact same issue. For the life of me I cannot figure out how to get these fuel lines and vacuum hoses configured in the correct fashion. I'm still having a hell of a time. Are you still having this issue??

Mar 14, 2012 | 2008 Hyosung GT250R

1 Answer

I am reinstalling a Moen 7345 riser faucet in my laundry room. This faucet was removed from a bar sink two years ago by the contractor who replaced my kitchen counters and changed my two kitchen sink...

I had a similar problem and, like you, found that there was nothing for the washer to seat against. Apparently, there was a metal bushing installed when manufactured, that was entirely eaten away by electrolytic corrosion - mine took nearly twenty years. I machined a new non-metallic bushing, installed it, and the problem was solved.

I also sent Moen's president a letter explaining the problem and how to fix it but heard nothing back from them. At the time, no parts were offered that could fix the problem.

Jan 30, 2010 | Moen 7310 Legend Single-Handle Kitchen...

1 Answer

Bike wont idle unless the choke is on.

Try cleaning pilot jets on carb or carbs. Also check for vaccume leaks like hose off of carb or bad carb boots.Spray carb cleaner around boots with bike running but be careful not to get it near exhaust or spark plug.

Dec 26, 2009 | 2000 Suzuki GSX-R 600

Not finding what you are looking for?
1989 kawasaki GPX 250 R Logo

Related Topics:

236 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4544 Answers


Level 3 Expert

77932 Answers


Level 2 Expert

342 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides