Lost the front left hand indicator since I have changed the bars and risers. Have I neglected something when reconnecting everything?
Maybe but you may also have pinched a wire in the switch assembly and/or where the harness comes out of the switch, clutch perch assembly.
SOURCE: 2000XLC Sportster front end vibration
Hard to diagnose, but if you have a bad engine vibration, you will be able to diagnose that when stopped and just revving up the engine. Moving balance problem can be easily out of true wheel and or needs balanced. (You can make your own balancer/ wheel true guage our of a couple of 8X8 posts with axle size hole drilled in each one) If you clonked a curb or pot hole at speed this can easily happen. Hope this helps you with your scoot, Rick
SOURCE: Small oil leak under front rocker box inner
take the rocker cover back off and check the oil breather and make sure the o ring on the bottem of it is still on there
SOURCE: 1985 harley 1000 no compression in front head
remove the push rod tubee on the front jug.see if the pushrods are moving up and down.see if they are loose.if loose adjust try again.
your valves may be stuck open if not stuck open pour 1 once of mystery oil in head try comp test again.[this is to check the rings}if still no comp you have a hole in your piston or blown head gasket
SOURCE: My 2007 HD sportster nightster is not starting.
I have had the same problem. Been throught two batteries, new cables,checked the fuses 999 times. It only starts every now and then. You must take a wrench and get the positve cable just right and it will start for a week or so then back to the same thing. You would think after building motors for so long Harley could at least make a bike that starts.
181 views
Usually answered in minutes!
×