Question about 1987 Honda CBR 600 F(1)H

1 Answer

Cbr 600 grtting ready for winter

I finally had to put her away , lousy Canadain weather! I was wondering if you guys had any good tips for us noobs? Last year i was lucky enough to have a heated garage to put it into. This year it''s my folks shed. So far i let the bike run with the gas turned off, untill it ran out of gas. Then I checked the coolant. I put some fuel stabilizer in the tank. Removed the battery. Is there anything im missing? Any hints would be helpfull :D thx guys

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 2,336 Answers

Top off the fuel tank to reduce the amount of air in there, less open space means less room for condensation to form and cause rust in the tank. next drain the float bowls if you dont really like pulling the carbs in the spring. also put the battery on a trickle charger to keep it from going bad.

Posted on Nov 20, 2008

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Cbr 600 f sport harder to start when weather gets cold

check choke working fully , check plug cap resistances not too much and condition and gap on plugs !

Jan 12, 2014 | 2002 Honda CBR 600 F(4)i

1 Answer

Is it hard to fit a cylinderhead gasket to a cbr 600

I think it is motor out mate, but not ahard job, but first drain it then put some old oil in if you have any , run it up then add engine flush, run it up and then drain , ready for fresh, just follow the manual.

May 10, 2012 | 1987 Honda CBR 600 F(1)H

1 Answer

1998 honda cbr 600 fw fuel pump assembly join leak more so in hot weather, presuming the seal expands. can this be repaired?

It's not the seal that's expanding, it's the metal. In any case, you will need to put a new seal/ o rings in.

Jun 27, 2011 | 1998 Honda CBR 600 F(3)W

1 Answer

Any good tips how change spark plugs on 00 cbr 600,have tank and air box off,But its hard to get in at them. cheers

get some good flex adapters and u can pretty much get any bikes spark plugs and modify a 1/4 in socket wrench to a 3/4in

Feb 15, 2011 | Honda CBR 600 900 929 954 1000 RR KEYCHAIN...

1 Answer

What kind of maintenance should i do to my 1989 cbr 600 f to keep it in tip top running condition

  • Change gearbox oil every 3000 miles. Change oil filter every 6000 miles. Use 10w40 motor oil. NEVER use synthetic lubricants as they can mess up the clutch.
  • Oil the chain every two weeks. Lube the control cables every oil filter change.
  • Keep the gas tank full in the cold months. This lessens internal tank rusting due to condensation in the tank. Drain the carbs when the bike will sit over the winter unless you plan on starting the bike every two weeks and letting it run for 15 minutes each time.
  • Be sure the gas valve is turned off when the bike is not in use.
  • Get a 2 amp trickle charger and charge the battery once a week for 4 hours in the winter. Be sure to keep enough water in the battery to cover the top of the plates in each cell. Know that batteries only last two years or so.
  • Check the chain tension once a month during the summer riding season.
  • Please rate my answer. Thanks.

Sep 11, 2010 | 1989 Honda CBR 600 F Hurricane

1 Answer

03 Honda cbr 600 rr motorcycle

now im not sure on this but when i had mine there was a bolt towards the tip take it out and the baffle should slide out from the exit

Mar 23, 2010 | 2003 Honda CBR 600 RR

1 Answer

I have a cbr 600 1993,can you tell me is there a step in the pilot jet

my 87 cbr manual says to lightly seat then 2&1/2 turn great for me had it dyno"d and the guy said it could have been better.

Sep 27, 2009 | 1994 Honda CBR 600 F(2)R

Not finding what you are looking for?
1987 Honda CBR 600 F(1)H Logo

Related Topics:

201 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers


Level 3 Expert

69199 Answers

Gino Cussen
Gino Cussen

Level 2 Expert

216 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides