SOURCE: how to change brake pads on a 2005 1200 Harley
there is 2 bolts on the caliper take them off and there are pad pins that need to be taken out.. inside the caliper there is a metal clip where the pad sits in.. put them in the same way they came out once you start its pretty self explainatory.. you should not have to blead them
SOURCE: how do i get to the battery of 2005 harley
on the right hand side of your bike just under the seat is a black box , cover actualy. under that is a phillips head screw remove then give the cover a good tug from the bottom and theres your battery.
SOURCE: harley davidson flstc heritage softail 1997
The fork oil is a very specific job needing a manual and a special tool, I don't want to insult anyones mechanical knowledge but if you have never done it before, best to take somewhere else. Engine oil on the other hand is easy, the drain tube to any softail is on the right side by where the frame meets the swing arm, has somekind of plug in it. Start and run bike for a little while, long enough to get it warm but not hot. Remove fill plug and then remove plug in drain line. Using a peice of cardboard or something put in between filter and frame , directing the oil to your drain pan instead of where ever it goes. Put 1 qt oil back in (after everything is reinstalled) start the bike and make sure the oil light goes out, when it does shut bike off and fill to the point that when it is standing upright you get a little oil on the tip of your finger, over filling may result in loss of oil cap from pressure (been there)
SOURCE: when changing the oil in a Harley Davidson Road
Three quarts. Then check the level while the bike is on the side stand. The dipstick is marked "Full Hot" and "Full Cold". Make sure you do not overfill.
SOURCE: need to change battery
remove the screw from the rear of the seat lift the seat gentlypulling the seat towards the rear of the machine once you have the seat of the battery is right in front of you. Regards Geoff
201 views
Usually answered in minutes!
×