Question about 2001 Titan Gecko SX

1 Answer

Carberator issues I actually have a 2002 titan coyote and I am having carb issues. Where can I see a scematic of the s &s carb?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 216 Answers

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Hi I have petrol leaking from my Yamaha virago 535 via bottom of air intake when petrol pump kicks in after turning key . can you help please

If petrol leaking from bottom of air intake if air intake is connected
to carberator most likely the float needle jet is not seating properly . Try replacing needle jet it is connect under the floats. Motorcycle will still run but fuel will leak out carberator. Try

Feb 18, 2015 | 1992 Yamaha XV 535 Virago DX

1 Answer

Hitting on only one cylinder

what is wrong with the diaphram ? if a hole use petrol resistant rubber type glue as a temp repair , if gone hard and perrished then replace ! is it the diaphram that lifts the slide , to test it use a breath of air in and out of air intake to diaphram and it should lift up and down if ok , have you checked compressions ? let me have feed back

Jan 19, 2014 | Yamaha Motorcycles

1 Answer

Not getting fuel to carberator

Stuck float or neddle seat valve. remove the carb and clean make sure the float and needle seat are functioning.

Oct 13, 2012 | 2002 Suzuki VS 1400 Intruder

1 Answer

1985 yamaha virago carberator problems... gas leaking out of the carberator ..took it off ,cleaned diaphram . still leaks gas after we shut if off, also sprays gas out of exhaust when throttled

Hi, Carol and the usual suspects are:
1. Damaged or restricted fuel tank venting system.
2. Loose float bowl screws.
3. Damaged float bowl o-ring.
4. improper fuel level in the float bowl.
5. Worn or dirty inlet valve or seat.
6. Damaged or leaking float assembly.
7. Particle contamination in inlet fitting cavity.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have nice a day.
Carburetor Carb Leaking Gas How to Fix Repair it Motorcycle Honda DIY...
Dan Motorcycle
Yamaha XV 535 DX Virago Service Manual
OEM parts for Yamaha

Apr 25, 2011 | Yamaha XV 535 Virago DX Motorcycles

2 Answers

Starts and idles fine. Dies if you try to give it gas.

check that the carb jets are clean if one is blocked up even just a little the motor wont rev up well also check that you have a good fule flow to carb and the air filter is clean,,
you can check the jets in the carb by giving the bike a little choke then try reving it up if it revs it has a blocked jet in the carb

Jul 04, 2010 | Motorcycles

1 Answer

My bike is spitting and sputtering.. I am a female without a husband

Did you park the bike over the winter without treating the gas? Gas will leave a lacker type coating on the needles of the carberators . Good chance that is the problem . May need to get the carbs cleaned.Sorry for not good news.

Jun 14, 2010 | 2002 Harley Davidson FLHR - FLHRCI Road...

1 Answer

Plastic piece on the carberator has cracked and letting too much air into the fule system . dose anyone know how to fix or locate that plastic piece without buying a whole new carberator?

Go to the site below where you can see a parts diagram for your specific bike. You will select the actual brand, year, model, etc., once you go to the site. Part numbers and prices are also shown. You can order parts from this site. In the event no price is shown on a particular part, the part is not in stock.

I hope this helps!

Jun 05, 2009 | 2002 Yamaha TT-R 225

1 Answer


Remove the carburetor slide from the throat of each carb. Now move the clip on the jet needle down one notch and put the carb back together. There is a notch on the side of the carb slide. When installing, it lines up with a pin inside the throat of the carb.

Apr 28, 2009 | 2002 kawasaki ZZR 400

1 Answer

Yamaha timberwolf 4x4 carberator issues


Firstly, if you are not a mechanical person you should never buy a vehicle that does not run.
However, here are some basic tests.
1. Connect a good battery.
2. Remove the spark plug.
3. Turn the motor using the starter motor or kick starter.
4. check for spark by inserting a new plug into the plug cap. (make sure the plug is grounded).

If the motor turns freely and there is spark, chances are good that the motor will run. This does not mean that the motor is in a good condition. Only with the motor running will you be able to know for sure.

You will now have to source a carb and fit it to the 4 wheeler.
Fitting the carb is not too difficult. Check that the intake manifold is not perished or torn, and remember to use the airfilter.

Enjoy the ride !


Mar 01, 2009 | 2003 Yamaha YZ 250

Not finding what you are looking for?
2001 Titan Gecko SX Logo

Related Topics:

213 people viewed this question

Ask a Question

Usually answered in minutes!

Top Titan Experts

Nicola Conroy

Level 3 Expert

1320 Answers

Gregg Mahin
Gregg Mahin

Level 3 Expert

34426 Answers

Merle Evans
Merle Evans

Level 2 Expert

177 Answers

Are you a Titan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides