Gemini djm-1 gooseneck microphone repair question

There are devices that allow that, yes. A y connector with two inputs and 1 output should work in that capability.

you have to unsolder the wires on the coil assembly then pull everything out through the bottom. replace the bad wire, reassemble the xlr end and resolder the wires to the coil.

This would not be something a user can correct. If you're interested in repairing the unit, please contact me at audioserviceclinic.com. Thank you.

http://www.bogen.com/products/pdfs/microphonespdfs/DDU250m.pdf

Red = mic + (tip)
White = mic - (ring)
Shield = gnd. (sleeve)
Blue & Black = switch

As I remember the Anchor has a removable metal back plate that is used to mount the volume control and 1/4" or XLR connectors. Before you start disassembling the unit....are you a qualified repair person? Other than a bad speaker, broken wire or connector there's not much "user servicable" parts inside.

does this mic have a switch? Is this mic dual impedance? If it is dual impedance depending on the impedance of the input will determin if you use 2 or3 wires. If it is only low impedance then white to pin2 black to pin 3 and the shield to pin1. If it is low imlpedance and has a switch the red and blue wire may be connected at the switch and may also have to be conneceted to pin2 and3. any more questions call me a the store.

Vito Vacirca Jr.

Pro Line Music

490 Lincoln Highway

Fairless Hills Pa. 19030

215-736-8055

[email protected]

[email protected]

www.prolinemusic.com

sure.. depend on what kind of speakers u r using...when active(they already has got a amp inside) than obviously u do have it build in so u just need connecting them to a source........
but with regullar speakers -and that's i think u've got them buy connecting cable between speakers and amp-can be regular phono cable...than wire your speakers with red and black,or blue cable and go to the back of your amp....there u should have two sort of clips...cables from speakers put inside, set the clip and u r ready to go..
hope that help...if u got any questions just write with the details couse u didnt give much

best

The service manual is at www.akg.com/mediendatenbank2/psfile/datei/19/C4194055d1fa264a7.pdf. You will have to replace the wiring that goes to the cartridge through the gooseneck.

the tip is is soldered to 1 and the sleeve/ring is soldered to 2 on a xlr. thanks nate. i have pictures i can email you if you need more.

connect your gemini phono out to -------- pioneer phono in.