Question about 1997 Honda CBR 600 F(3)V

1 Answer

Fuel pump pressure

How much pressure should a 1995 honda cbr 600f3 fuel pump have?

Posted by on

  • fastrider Mar 25, 2009

    What is the fuel pressure suppose to be and do you know how to go about checking it? I have a 1996 Honda cbr and have stored it all winter in the garage. Now I'm trying to get it started and It won't start. Any suggestions on what could be causing this?
    thanks

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 2,336 Answers

In my experiences over the years pressure testing the carbs and messing with the fuel pump, I have never actually tested the pump output. Knowing that the average pop off pressure of the float valve on the float is 10-13 psi, this being tested via hand held pressure gauge to ensure no leaks before installation on the bike. I assume that the fuel pressure coming from the pump should not exceed the pop off pressure or it could cause the carbs to leak though and the bike would run rich. Hope this helps out.

Posted on Nov 10, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2001 honda cbr 929 rr help wont start fuel pump works tested but doesnt kicked on when switched on main fuse blew replaced opened wire harness replaced burned wire looked didnt see any open wires


Hi, Keyth the following is a systematic procedure for diagnosing fuel pump issues designed to keep "DRACHMA" to a minimum. If you need parts check with Amazon and eBay first to keep costs down.
1. If your pump does not turn on check the pump fuse and relay and all wiring including connectors for corroded, broken, or loose pins/sockets.
1. Normal fuel pump pressure is 3-5 PSI.
2. Check any rubber or plastic tubing for age-related pinholes by removing and plugging the ends that connect to the fuel valve and then turn on the ignition switch and watch for fuel streams exiting the pinholes, if any exist, replace tubing as necessary.
3. Check for a clogged a primary fuel filter that comes off the bottom of the pump to screen out big rocks and clean as necessary.
4. Check for a clogged secondary fuel filter that's outside if applicable by removing it from the system and replace it with a short splicing tube turn on the ignition switch and recheck fuel pressure if pressure increases to normal pressure you need a new secondary filter.
5. If all the above check out OK and the pump is not functioning properly then you need a new fuel pump.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
http://www.fireblades.org/forums/honda-fireblade/18340-2001-cbr929-will-not-start.html
http://www.esportbike.com/forums/86-tech/127250-cbr929-fuel-pump-not-working.html
2000 2001 Honda CBR929RR Fireblade Service Manual Moto Data Project
http://www.partsfish.com/page/oem-parts-for-honda
Honda CB Owners Manuals

Feb 14, 2017 | 2001 Honda CBR 929 RR Fireblade

1 Answer

I replace the regulator rectifier and the plug to the rectifier on my 1995 Honda CBR 600 f3. soon as the bike warms up wants to die. so I unplugged the rectifier. brand new battery two. Still Dying


Hi, Harold it's really tough to answer any of your questions because you didn't ask any, the batteries in my crystal ball are dead and my mental telepathy headset is broken so here is my best shot the following applies to carbureted also fuel injected models and the usual suspects are:
1. Severely discharged or a damaged battery, should have 12.5 volts or better and be able to pass a load test if necessary.
2. Failed alternator/generator and or voltage regulator.
3. Loose or corroded battery terminals and or cables especially the "NEGATIVE" cable, look for loose, corroded, or broken connectors inside the cable harness at "BOTH" ends.
4. Failed main circuit breaker or ignition switch, check for loose connections and continuity.
5. Failed system and or ignition relay, check for continuity.
6. Failed ignition coil, ignition/electronic module.
7. Failed CKP, CPS, CMP, MAP, TPS, or BAS sensor, corroded, loose or broken wire connector pins/sockets.
8. Throttle cables and or idle speed improperly adjusted hot idle speed should be 950 RPM to 1000 RPM.
9. Air/fuel mixture screw improperly adjusted.
10. Water or dirt in the fuel system, carburetor or filter.
11. Restricted, blocked or kinked fuel line.
12. Fuel tank empty.
13. The gas cap is not venting properly or fuel tank venting system blocked.
14. A failed fuel pump, pressure regulator and or fuel injectors.
15. Vacuum line from intake manifold to petcock broken, cracked, or not attached, carburetor vent line plugged.
16. Needle and seat stuck closed in the float bowl.
For more information about your issue and valuable "FREE" downloads that you need please click on the links below. Good luck and have a nice day.
1995 cbr 600 F3 problem PLEASE HELP CBR Forum Enthusiast forums for Honda...
cbr600f3 will only start choke gas givin Honda Motorcycles FireBlades org
HONDA CBR WONT START TRY THESE TIPS
1996 1998 Honda CBR600F3 Service Manual Moto Data Project

May 10, 2016 | Honda Motorcycles

1 Answer

Wheres the fuel pressure regulator on a 1992 cbr 600


They don't have one. They are carburetor engine and not fuel injected.Their reciprocated small pump was driven by relay just to feed the carburetors at high revs.Fuel pressure regulator is used in fuel injected engines and that came to production by Honda in the late '99s.

Feb 06, 2012 | 1991 Honda CBR 600 F(2)M

2 Answers

96 CBR 600F3 runs for approx 10Min then stalls out.


Check the vacuum pipe from the carbs to the fuel tap, if its gat a pin hole in as you demand more fuel the vacuum loss cuts downthe fuel flow and the bike will stop!

Jul 28, 2009 | 1997 Honda CBR 600 F(3)V

2 Answers

Where is the fuel filter located on 1997 honda cbr 600


I have a 1996 CBR 600F3. Mine is directly under the gas tank. Where the gas tank meets the seat. If you remove the single top bolt for the gas tank and the lower bolt for the gas tank you can lift the tank a little. Then you will see the rubber gas fuel line. The filter will be in-line.

Jun 18, 2009 | 1997 Honda CBR 600 F(3)V

1 Answer

How do I adjust the rear tire on a 97 honda cbr 600f3


40mm slack up and down middle of chain. not tight when sitting on bike. loosen axle ajust both sides evenly, retighten axle install new split pin

Dec 04, 2008 | 1997 Honda CBR 600 F(3)V

1 Answer

Runs for 30 minutes then dies


try running with fuel cap open. If it keeps running, breather in fuel cap blocked, strip fuel cap and clean.

Nov 10, 2008 | 1996 Honda CBR 600 F(3)T

Not finding what you are looking for?
1997 Honda CBR 600 F(3)V Logo

Related Topics:

1,280 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

70374 Answers

Gino Cussen
Gino Cussen

Level 2 Expert

216 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...